Land Rover Parts

Mirror Cover – the exterior cap that fits over the door mirror housing. The cover clips onto the mirror body to form its outer shell, enclosing th...

Sunroof Guide Assembly – the left-hand guide within the sliding roof assembly that locates and supports the panel as it travels. The guide runs al...

Sunroof Sliding Guide – the guide within the sliding roof assembly that locates and supports the panel as it travels. The guide runs along its rai...

Sunroof Cable

Sunroof Motor Assembly – the electric drive motor for the factory sliding roof panel. Mounted to the sunroof cassette, the motor drives the glass ...

Sunroof Motor Assembly – the electric drive motor for the factory sliding roof panel. Mounted to the sunroof cassette, the motor drives the glass ...

Sliding Roof Frame – the lower frame of the sunroof assembly that mounts into the roof panel opening. The frame locates the sunroof cassette in th...

Seal

Spankabel

Spankabel

Sliding Roof, the glass sunroof assembly that fits into the roof aperture. The glass panel slides to open the roof for cabin ventilation and close...

Roof Headlining in Ripple Grey, the moulded trim panel that lines the underside of the cab roof to provide the finished interior surface and concea...

Bonnet Hinge Cover - a front-end trim finisher that conceals the left-hand bonnet hinge where it mounts at the scuttle/plenum. It clips over the h...

Cover bonnet hinge Freelander LH

Loadspace protector 6"" deep sides. Semi-rigid Disco 3 / 4

Compartment Load Liner - a semi-rigid protective liner for the loadspace floor. It sits over the boot floor with raised sides that contain spills ...

Plate EAP100720PUB

Washer forms part of the battery tray lid retention assembly. It provides the seat into which the turnbuckle clip engages: the turnbuckle (DZM1000...

Retaining Clip secures the roof spoiler to the body, providing the M6 fixing point that anchors the spoiler in position. It locates over the panel...

Fender Seal - a seal fitted along the fender (wing) to close the gap against the adjacent body panel, helping to keep out water and road debris.

Clamp

Key

Roof Trim Retainer - a fastening clip that secures the exterior roof trim moulding to the body, holding it in position and preventing movement.

Pad

Rear Bumper Assembly forming the moulded outer cover of the rear bumper. Supplied in primer for painting, with apertures for the rear parking aid ...

Rear Bumper Assembly - the complete rear bumper unit, forming the rearmost protective element of the vehicle's exterior body. It mounts to the rear...

Front Bumper End Cap for the left-hand end of the front bumper assembly. The end cap forms the outer corner of the front bumper where it meets the...

Bumper Reinforcement panel for the front bumper assembly. The reinforcement mounts behind the front bumper cover to provide structural rigidity an...

Front Bumper Support Bracket for the left-hand side of the front bumper assembly. The bracket locates and secures the front bumper to the vehicle ...

Bumper Support Bracket - the right-hand support bracket for the front bumper. It locates and supports the right-hand side of the front bumper, secu...

Armature Assembly - the structural armature for the front bumper. It is the reinforcement beam that sits behind the bumper cover, carrying the bump...

Towing Eye Cover - an anthracite, textured-finish trim cover for the lower front bumper. It clips into the bumper to conceal the front towing-eye r...

Front Bumper is the front-most body component, mounting across the front of the chassis to form the leading face of the vehicle. It carries the fr...