Land Rover Parts

Bottom link mounting RRC polyurethane pair

Mounting Link Bottom Range Rover Classic

Gearbox Gasket for the LT95 four-speed gearbox, sealing the power take-off (PTO) cover joint. Fits between the PTO cover and the gearbox main casi...

Ball Steel Bearing

Radiator Drain Plug seals the drain point in the cooling system and is removed to drain coolant during flushing or servicing. When fitted it close...

Gear Selector Plunger is the interlocker pin fitted to the 1st and 2nd gear selector shaft in the gearbox top cover. It prevents simultaneous selec...

Plain Washer with a 1/4" bore, used as a general-purpose flat washer. Fitted under a bolt head or nut, it spreads the clamping load over a wider a...

Window Catch Mask fits behind the window catch on the rear side door. This plate seats between the catch and the door skin, masking and reinforcin...

Decal – Dash is an adhesive instrument switch-tab label for the dashboard control panel. It is applied to the face of a plastic switch tab to iden...

Glow Plug Lead in the diesel glow plug (heater plug) pre-heat circuit. This short 5" lead interconnects glow plugs wired in series and is not inte...

Bolt - 5/16 inch BSF x 1 inch for the gearbox selector assembly. Used to secure the gear selector forks to their respective selector shafts within...

Battery Clamp - Negative is a single terminal clamp for the negative post of the battery. It secures the earth (negative) lead to the battery term...

Engine Bush Kit - Diesel

7" Round LED Headlights, supplied as a pair, replacing the standard round sealed-beam or halogen headlamps. Each unit carries a full LED main and ...

Front suspension shock absorber designed to control spring oscillation and maintain tyre contact with the road surface. Twin-tube low-pressure ni...

Rear Coil Spring Pair - Medium Load, +2" Lift (Terrafirma). These rear coil springs raise ride height by approximately 2 inches over standard and ...

Rear Propshaft transmitting drive from the transfer box rear output to the rear axle differential. The shaft carries torque from the transfer box ...

Fuel Filler Cap - Locking - the cap that closes the fuel tank filler neck within the fuel system. It seals the filler neck against fuel loss and c...

Self-Tapping Screw, size No. 6 x 3/8", for the door glass and window regulator assembly. This screw secures the window glass run channel to the do...

Plastic Drive Rivet - Front Wheel Arch Liner is a push-in fastener used to secure the front wheel arch liner to the surrounding body structure. Fi...

Safari Door - the rear load (tail) door of the body assembly, supplied unglazed and without a spare-wheel carrier. It hinges on the rear body to c...

Exhaust manifold lockplate

Fuel Pump Adaptor for mounting the external fuel pump on petrol engines. It provides the interface between the external fuel pump and its mounting...

Intercooler Hose Kit replaces the standard rubber hoses in the intercooler circuit of the Defender 2.4L TDCi (Puma) engine. This kit includes the ...

Anti-Roll Bar for the rear suspension, 28mm bar diameter. The bar mounts to the chassis on a pair of clamped bushes and connects to the axle throu...

Tailgate Assembly is the rear tail door that closes the back of the body. This is the later three-hinge type tailgate, supplied without the mounti...

Fender Goes to Africa - a hardback children's picture book written and illustrated by Veronica Lamond. Part of the Fender series, in which a Land ...

Programmable Wiper Delay Relay is a direct replacement for the standard AMR2341 relay in the front wiper circuit, providing a user-adjustable inter...

Fuel Pump and Sender Unit is the in-tank assembly that delivers pressurised fuel to the engine fuel rail and signals the fuel level to the instrume...

Intercooler Hose - the charge-air hose connecting the turbocharger to the intercooler on the Td5 2.5L 5-cylinder turbo diesel. It carries pressuri...

Fuse box

Bonnet Prop Clip for the bonnet support rod assembly on the Land Rover Defender. This clip secures the solid-type bonnet prop rod in its stowed po...

Intermediate & Rear Exhaust Assembly forms the rear section of the exhaust system, comprising the intermediate pipe and rear silencer. Install...

Parking Sensor for the Park Distance Control (PDC) system. This ultrasonic sensor fits into the bumper and transmits and receives ultrasonic pulses...

Bolt

Fuel Injector Bolt - retaining bolt securing the fuel injector clamp to the cylinder head on the 2.4L Duratorq TDCi (Puma) common-rail diesel engin...

Clutch Cap that closes an aperture in the clutch bellhousing around the release mechanism. Fitted over an opening in the bellhousing, the cap seal...

Visco Unit Bearing for the rear propshaft, supporting the viscous coupling unit (VCU) in the four-wheel-drive driveline. The bearing locates on th...

Timing Belt Tensioner for the 200TDi 2.5L turbo diesel engine, part of the camshaft timing belt drive. The tensioner maintains correct tension on ...

Front Wheel Hub and Bearing Assembly is the pre-assembled hub unit at the front axle, combining the wheel hub, its bearing and the ABS wheel speed ...

Power Steering Pipe - Pump to Box is the high-pressure hydraulic feed line connecting the power steering pump outlet to the steering box inlet. Th...

Oil Sump is the lower section of the two-piece sump assembly, bolting to the base of the engine to form the oil reservoir and enclose the oil picku...

Caliper Repair Kit - Front - Axle Set

Steering Column Bolt for the lower steering shaft coupling. This pinch bolt clamps the lower steering shaft to its mating joint, securing the colum...

Rocker Cover Breather Hose - Left-Hand for the crankcase ventilation system of the Rover 3.5L V8 twin-carburettor engine. This hose connects the l...

Propshaft Lock Washer, used within the propshaft and viscous coupling assembly. The lock washer is seated beneath the retaining fastener at the pr...

Front Left-Hand Indicator Lamp Assembly for the Discovery 1. This amber turn signal lamp unit is mounted at the front left corner of the vehicle a...

Intercooler Hose - To Tube - RH is a charge-air hose in the intercooler (charge-air cooling) circuit of the 2.4L Puma turbo diesel. It forms the r...