Products

Water Pump for the engine cooling circuit, fitted to supercharged petrol applications (3.0L DOHC GDI supercharged V6 and 5.0L AJ133 DOHC supercharg...

EGR Valve and Throttle Body Assembly from the engine's exhaust gas recirculation and intake system. The EGR valve meters recirculated exhaust gas b...

O-Ring - seals a joint in the thermostat housing and EGR cooling circuit. Fitted to the 2.0L four-cylinder AJ200 diesel engine, it maintains a lea...

Bolt - a structural fastener used at chassis and front suspension mounting points, including the front cross member and stabiliser bar crossmember,...

Hex Head Bolt - M14 x 148mm fastener used at the front crossmember and stabiliser bar, front suspension arm, rear bumper and tow bar mountings. A ...

Oil Pump for the engine lubrication system of the supercharged petrol V6 and V8 (AJ133) engines. Driven from the crankshaft, the oil pump draws oi...

Transmission Mount Insulator locating the transmission mounting bracket. The rubber-to-metal insulator supports the transmission against the body ...

Brake Pad Wear Wire - front brake pad wear warning wire within the braking system. Routed to the front brake pad, the wire completes a circuit tha...

Brake Pad Wear Wire - front brake pad wear warning wire within the braking system. Routed to the front brake pad, the wire completes a circuit tha...

Brake Pad Wear Wire - front brake pad wear warning wire within the braking system. Routed to the front brake pad, the wire completes a circuit tha...

Brake Pad Wear Wire - front brake pad wear warning wire within the braking system. Routed to the front brake pad, the wire completes a circuit tha...

Brake Disc for the rear axle. This disc is the rotor that the rear caliper clamps to slow the wheel. Sized for the 20-inch brake disc and caliper ...

Brake Disc for the rear axle. This disc is the rotor that the rear caliper clamps to slow the wheel. Sized for the 20-inch brake disc and caliper ...

Accessory Drive Belt - multi-rib belt driving the engine's front-end accessories. Transmits crankshaft rotation to the belt-driven ancillaries wit...

Front Propshaft Flange in the front driveline, coupling the front propeller shaft to the transfer case output on vehicles fitted with a two-speed t...

Brake Actuator - electric parking brake (EPB) actuator, part of the electronic parking brake assembly. The motor-driven actuator applies and relea...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

Exhaust Gas Pressure Sensor for the exhaust and emissions system on 2.0L AJ200P Ingenium petrol and plug-in hybrid applications. The sensor measur...

Cylinder Head Gasket for the 5.0L V8 AJ133 petrol engine. The gasket seals the joint between a cylinder head and the engine block, containing comb...

Cylinder Head Gasket for the 5.0L V8 AJ133 petrol engine. The gasket seals the joint between a cylinder head and the engine block, containing comb...

Head Gasket for the right-hand cylinder bank of the 5.0L V8 AJ133 petrol engine. It seals the cylinder head to the engine block, containing combust...

Injector Refit Kit supplying the seals needed to refit a fuel injector on petrol engines. It restores the sealing interface between the injector an...

Thermostat Seal for the thermostat housing on AJ200/AJ20 series petrol and diesel engines. It seals the thermostat housing joint within the cooling...

Thermostat Seal for the thermostat housing on AJ200/AJ20 series petrol and diesel engines. It seals the thermostat housing joint within the cooling...

Cover Gasket for the crankcase cover, part of the emission-control and crankcase ventilation system on the 2.0L AJ200 four-cylinder diesel engine. ...

Engine Mounting Bracket that connects the engine to its rubber mount on the chassis, part of the powertrain mounting system. It carries the engine...

Engine Mounting Bracket - a structural bracket within the engine mounting system. The bracket bolts to the engine and locates the engine mount, ca...

Thermostat for the 2.0L Ingenium diesel engine (AJ200D) cooling system. It regulates coolant flow to bring the engine up to operating temperature q...

Screw - a fastener used to secure exterior body panels and trim, including body mouldings, front and rear bumper assemblies, radiator grille panels...

Idler Pulley for the front-end accessory belt drive, 90mm diameter. The idler routes and guides the auxiliary drive belt around the accessory pull...

Idler Pulley for the front-end accessory belt drive, 90mm diameter. The idler routes and guides the auxiliary drive belt around the accessory pull...

Fuel Pressure Sensor for the high-pressure fuel injection circuit on petrol engines. It measures fuel rail pressure and temperature and reports to ...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Front Cylinder Cover - a cover that closes off the front face of the cylinder block, sealing the opening and enclosing the components behind it. F...