Products

Air Conditioning O-Ring, 13.7 x 2.5mm, for the R134a refrigerant circuit. It seals a line connection in the front air-conditioning system on the c...

Cam Cover Gasket - seals the camshaft cover to the cylinder head on the 2.2L TD4 diesel engine (DW12). It forms the oil-tight joint at the top of ...

Bolt and Washer is a hex-head bolt with washer for the cylinder block. Used at the cylinder block and its plugs on the 2.2L diesel engine.

Sealing Ring - Input Shaft is an O-ring seal fitted to the input shaft of the M66 six-speed manual transmission. It seals the joint where the inpu...

Oil Seal - 30 x 40mm is an external oil seal for the M66 six-speed manual transmission. It seals a rotating shaft where it exits the gearbox casin...

Oil Seal - M66 Gearbox Driveshaft is the 67mm driveshaft oil seal for the M66 six-speed manual transmission. It seals the driveshaft output where ...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Driveshaft Oil Seal - Inner - Front LH is fitted to the front axle case (final drive housing) and seals around the inner end of the left-hand front...

Driveshaft Oil Seal - Inner - Front LH is fitted to the front axle case (final drive housing) and seals around the inner end of the left-hand front...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Fuel Tank Vent Reservoir for the evaporative emission control (EVAP) system on petrol models. It collects and stores fuel vapour drawn from the fue...

Starter Inhibitor Switch mounted at the clutch pedal on manual-transmission models. It detects when the clutch pedal is fully depressed and prevent...

Blade Fuse rated at 10 A, colour-coded red to match its rating. This standard automotive blade fuse plugs into the vehicle fuse box and protects it...

Brake Caliper Guide Pin Kit for a floating (sliding) brake caliper. The guide pins locate the caliper body on its carrier bracket and let it slide ...

Thermostat Housing Gasket for the engine cooling system. It seals the joint between the thermostat housing and the engine, containing coolant and ...

Rocker Arm for the 2.2L DW12 Td4 diesel engine, part of the cylinder head valve train. It transfers camshaft lobe motion to the valve, opening it ...

Rocker Arm for the 2.2L DW12 Td4 diesel engine, part of the cylinder head valve train. It transfers camshaft lobe motion to the valve, opening it ...

Valve Tappet for the 2.2L DW12 Td4 diesel engine, part of the cylinder head valve train. It provides the pivot for the rocker arm and takes up cle...

Timing Belt for the 2.2L DW12 Td4 diesel engine - the toothed belt that drives the camshafts from the crankshaft, keeping valve and piston movement...

Sump Drain Plug for the 2.2L DW12 Td4 diesel engine oil pan. Threaded into the base of the sump, it is removed to drain the engine oil during a se...

Cylinder Block Plug, 16mm, seals a threaded port in the cylinder block. It closes an internal casting passage in the block, retaining pressure and...

Ashtray in Ebony Black for the centre floor console. The ashtray is a removable insert that locates in the console cubby box.

Inlet Manifold Gasket Kit - gasket set for the inlet (intake) manifold of the 2.2L TD4 diesel engine. Renews the sealing between the inlet manifol...

Halogen Headlamp Bulb of the H11 type, used in the dipped (low) beam of the front headlamp assembly. The H11 is a single-filament halogen bulb tha...

sensor exhaust gas 2.2L CR DI 16V Diesel OEM Autotec

Sensor Assembly - Lambda

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...

Oil Filler Cap for the 2.2L diesel engine. It seals the oil filler aperture, closing the crankcase to prevent oil loss and contamination during en...

Oil Filter Housing Cover for the oil cooler and filter housing on the 2.2L DW12 turbo-diesel engine. The cover closes the oil filter housing, reta...

Sump Plug Washer is the sealing washer for the engine oil sump drain plug. It seats between the drain plug and the sump pan to form a leak-tight s...

Oil Cooler and Filter Assembly combines the engine oil cooler and oil filter housing for the 2.2L TD4 diesel engine (DW12). Mounted in the lubrica...

Oil Cooler and Filter Assembly combines the engine oil cooler and oil filter housing for the 2.2L TD4 diesel engine (DW12). Mounted in the lubrica...

Oil Cooler Return Connector is a connector fitting in the engine oil cooler circuit of the 2.2L diesel engine (DW12). It joins the oil cooler retu...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Coolant Temperature Sensor for the 2.2L DW12 common-rail diesel engine (Td4/SD4), mounted in the thermostat housing. The sensor is a thermistor si...

Starter Motor - starting motor for the 2.2L CR DI 16V turbo diesel (DW12 / TD4), part of the engine starting system. When energised by the starter...

D3S xenon headlamp bulb, supplied with its igniter, for headlamp units originally built as bi-xenon or adaptive xenon assemblies. D3S is a mercury...

D3S xenon headlamp bulb, supplied with its igniter, for headlamp units originally built as bi-xenon or adaptive xenon assemblies. D3S is a mercury...

Gasket polygon shape type. cover