Products

Oil Filter for Land Rover petrol and diesel engines, part of the engine lubrication circuit. This screw-on canister filter threads onto the filter...

Head Gasket Seals the cylinder head to the cylinder block on the pre-TDi 2.25L and 2.5L naturally aspirated and turbocharged diesel engines. It co...

Carburettor Manifold Gasket - the gasket that seals the inlet and exhaust manifold assembly to the cylinder head face on carburettor-fed engines. ...

Flywheel Bolt securing the flywheel to the rear flange of the crankshaft. Used on four-cylinder petrol and diesel engines, including the 200TDi an...

Valve Spring - V8 is a cylinder head valve spring for the Rover 3.5L and 3.9L V8 petrol engine. The valve spring seats between the cylinder head a...

Valve Spring for the cylinder head valvetrain. Fitted over the valve stem, it holds the valve closed against its seat and keeps the follower in con...

Rocker Cover Gasket seals the joint between the rocker (valve) cover and the cylinder head at the top of the engine, within the valvetrain assembly...

Front Cover Gasket seals the timing cover to the front face of the cylinder block on the V8 petrol engine. It fits between the front cover and the...

Cam Follower - a roller-type tappet operating in the engine valve train, between the camshaft and the pushrod. It rides on the camshaft lobe and t...

Front cover oil seal

Valve Spring Cap for the cylinder head valve train. The spring cap seats on top of the valve spring and locates against the split collets on the v...

Special Bolt for retaining the tappets in the cylinder block, part of the camshaft and tappet assembly. This is a specific-design fastener that se...

Exhaust Valve Stem Seal for the cylinder head valvetrain. Fits over the exhaust valve stem at the top of the valve guide, metering the oil that pa...

Thermostat

Timing Chain for the 2.25L and 2.5L four-cylinder petrol engines with the five-bearing crankshaft, running inside the front timing cover. It drive...

Rocker Cover Gasket - Diesel for the 2.25L and 2.5L 4-Cylinder diesel engine. This gasket seals the joint between the rocker cover and the cylinde...

Rubber-Lined Sealing Washer - a metal sealing washer with a bonded rubber lining, fitted under a bolt or union to seal the joint. As the fitting i...

Inlet Manifold Gasket - Diesel for the 2.25L and 2.5L 4-Cylinder diesel engine. Fitted between the inlet manifold and the cylinder head, this gask...

Oil pump relief valve washer V8

3 man seat Techno Exmoor trim EX4188 EXT006-TC

Rubber Mat - a heavy-duty 6mm rubber floor mat for the rear load area of hardtop models. Laid over the load-area floor, the 6mm rubber protects th...

Door Drain for the left-hand door, fitted to the lower edge of the door to channel water away. Water that runs down inside the door skin past the ...

Screen to Drain Bracket for the right-hand side, securing the windscreen frame to the drain channel at the base of the screen. The bracket ties th...

Lightweight Seat Back Black Vinyl Exmoor Trim

Safari Rear Side Door Top Panel (r/H) - Black Vinyl

Safari Rear Side Door Main Panel (l/H) - Black Vinyl

Front Door Trim Kit - a left- and right-hand pair of front door trim panels finished in black vinyl, without map pockets. The panels fit to the in...

Bolt - a flanged-head bolt used as a general fastener across a range of engine, chassis and body locations, including the timing cover, chassis fra...

Rear Left-Hand Half Shaft for the 10/24 spline rear axle. The half shaft transmits drive from the differential to the rear wheel hub. This left-ha...

Output Shaft Oil Seal seals the front or rear output shaft of the LT76 transfer gearbox, retaining lubricant within the transfer case and preventin...

Reverse Selector Fork for the gear selection mechanism in the Series-type manual gearbox (LT76), suffix B onwards. Mounted on the selector shaft, ...