Products

Fuel Pump Assembly Complete fuel pump unit in the fuel delivery system, drawing fuel from the tank and supplying it to the engine under pressure. ...

Pump - Fuel Tank

Sender Tank Fuel 110/130

Inertia Switch in the fuel supply and engine electrical circuit. It cuts electrical power to the fuel pump on a sudden impact or severe deceleratio...

Spring Washer is an M8 double-coil spring washer used as a fastening component in body and chassis assemblies. The double-coil spring form maintai...

Spring Washer is a split spring washer fitted under a nut or bolt head. Its sprung ends bear against the fastener to maintain tension and resist lo...

Wing Gasket Foam sealing gasket fitted along the top edge of the front wing. Seals the joint between the wing and the adjoining bodywork to keep o...

TF Wing Top Foam Gaskets - 07 On

Leak Detection Pump - diagnostic module for the fuel tank evaporative emission (EVAP) system. It sits in the EVAP circuit between the charcoal can...

Wing Top Protector Kit - chamfered protector panels for the front wing tops. The panels cover the wing top, the area most exposed to scuffing from...

Leak Detection Pump - DMTL (Diagnostic Module Tank Leakage) unit for the fuel tank evaporative emission (EVAP) system. The module sits between the...

Fuel Vapour Valve for the evaporative emission control (EVAP) system. The valve governs the flow of fuel vapour between the fuel tank and the char...

Canister Vent Solenoid for the evaporative emission control (EVAP) system. The solenoid controls the fresh-air vent side of the charcoal canister....

Exhaust System Bolt, M8 x 45 mm. Used at the catalytic converter flange joint, clamping the converter to its mating exhaust pipe section. Fastene...

Flanged Nut, M8. The integral flange spreads clamp load across the joint face and removes the need for a separate washer. Used in the exhaust syst...

Flanged Nut, M8. The integral flange spreads clamp load across the joint face and removes the need for a separate washer. Used in the exhaust syst...

Fuel Burning Heater Pump Metering fuel pump for the auxiliary Fuel Burning Heater (FBH). The FBH is a supplementary diesel-fired heater that warms...

Exhaust Stud Nut for front exhaust system connections. This nut secures exhaust pipe sections to the manifold or downpipe studs, maintaining a gas...

Exhaust System Screw, M8 x 20 mm. Used on exhaust and turbocharger joints - securing the catalytic converter to its mating pipe section, and at tu...

Kit gasket carb for Rover V8 engines fitted with SU carburetors

Crankshaft Oil Pump Seal Front crankshaft oil seal located in the oil pump housing. Seals around the crankshaft snout where it passes through the ...

Crankshaft Oil Pump Seal Front crankshaft oil seal located in the oil pump housing. Seals around the crankshaft snout where it passes through the ...

Headlamp for the front exterior lighting assembly, mounted on the left-hand side of the vehicle. The unit incorporates automatic headlamp levellin...

Headlamp

Headlamp

Headlamp for the front exterior lighting assembly, supplied as a complete halogen unit. The headlamp provides manual beam levelling, allowing the ...

Headlamp LHD (NLA Wanneer Op) - Discovery 2 - RH

Headlamp, Right-Hand Side - Black Surround for left-hand drive (LHD) applications. Composite front headlamp unit providing both high and low beam ...

Headlamp, Left-Hand Side - Black Surround for left-hand drive (LHD) applications. Composite front headlamp unit providing both high and low beam f...

Headlamp assy LH

Headlamp

Headlamp Assembly - left-hand unit for left-hand-drive vehicles. Supplied as a complete headlamp and flasher unit comprising the housing, reflecto...