Genuine Land Rover Parts

Monobolt Rivet - 1/4" structural blind rivet for body and chassis fastening. The Monobolt is a high-strength blind rivet set from one side of the ...

Flasher relay GENUINE LR 3 pin

Rotary Coupler sits at the top of the steering column within the airbag (SRS) system, behind the steering wheel. Also known as a clock spring, it ...

Wiring Assembly

Stud secures the coolant pump to the engine front cover. Part of the coolant pump and front cover assembly on the 2.5L 200 TDi diesel engine, it p...

Steering Column Lock Clamp securing the steering column lock assembly to the steering column. It wraps around the column outer tube and holds the ...

Propshaft Gaiter is the rubber boot that seals the sliding (slip) joint of the propshaft, retaining grease on the splines and excluding water, grit...

Touch-Up Paint Pencil applies the Epsom Green body colour to small stone chips and scratches in the paintwork. The pencil applicator gives accurat...

Bulb & Holder

Bulb Holder - Sidelamp is the bulb holder for the sidelamp (front parking lamp) within the exterior lighting system. It retains the sidelamp bulb ...

Cover

Main Spring is the spring fitted within Superwinch free-wheeling (manual locking) front hubs. A free-wheeling hub allows the front wheels to be di...

Lock Barrel with Keys, part of the Door Lock Assembly on the Discovery 1. This is the complete replacement lock barrel, supplied with a matching s...

Instrument Cluster Bulb Holder for the instrument cluster, part of the cluster illumination and warning-light circuit. The holder pushes into the ...

Seal

Alternator Regulator for the Lucas A133 alternator. The regulator controls the alternator field current to hold the charging output at a stable vol...

Brake Fluid Reservoir Cap with integral fluid level warning switch, for the brake master cylinder reservoir. The cap seals the top of the brake fl...

Heated Front Screen Relay, rated at 70 A, part of the heated windscreen circuit. Triggered by the heated screen switch, it closes the main supply t...

Switch

Electric Seat Switch - the left-hand seat squab control within the electrically adjustable seat circuit. This switch commands the squab (backrest)...

Coolant Pulley for the engine cooling circuit of the V8 EFI petrol engine. The pulley bolts to the coolant pump drive flange and is driven by the ...

Clutch Pedal Box Gasket seals the joint between the clutch pedal box and the bulkhead within the Pedal Box Assembly. It fits between the pedal box...

Choke Cable - control cable in the cold-start circuit of the V8 carburettor installation. It runs from the driver's choke control on the facia to ...

Anti-Roll Bar – Front for the front suspension. The bar spans the front axle and connects to each side of the suspension through drop links, resist...

Handbrake Sealing Gasket for the parking brake (handbrake) assembly. The gasket seals the mating joint between the handbrake lever body and its mo...

Handbrake Adjusting Knob threaded adjuster fitted to the parking brake (handbrake) lever assembly. The knob threads onto the end of the handbrake ...

Blanking Plug closes off an unused aperture in the front bumper and chassis under-ride protection bar. Pushed into an open hole to seal it, the pl...