Land Rover Defender Parts

Flywheel Assembly for the manual transmission on the 2.5L 200 TDi and 300 TDi turbo diesel engines. Bolted to the rear of the crankshaft, the flyw...

Elbow Gasket seals the coolant outlet elbow, or thermostat housing, to the inlet manifold on the V8 petrol engine, forming part of the engine cooli...

Body Rivet - a mechanical fastener used within the body and panel assembly to join thin sheet metal, trim and stowage fittings. Nominal size 3/16"...

Brake Caliper Bolt - M12 x 35mm threaded fastener securing the brake caliper to its mounting on the hub carrier. It holds the caliper in correct a...

Piston Rings - 200TDi - Standard for the 2.5L 200TDi four-cylinder turbo-diesel engine at standard bore dimensions, for use during engine overhaul....

Fuel Pump Seal, part of the fuel delivery system at the in-tank fuel pump and sender module. Seals the joint where the fuel pump and sender unit m...

Lockset-Complete Vehicle

Rear Axle Half Shaft - LH, Heavy Duty, part of the disc-braked Salisbury rear axle assembly. The left-hand halfshaft transmits drive from the diff...

Towing Bracket Slider Lock Pin is the pin that locks the vertical slider of a Dixon Bate adjustable-height towing bracket at the selected height. ...

Strip - Glazing and Sealing

Drive Flange Gasket

Chubby Box Techno

Intercooler Hose - LH carries compressed charge air through the intercooler circuit on the 2.4L Puma turbo diesel. It forms part of the ducting th...

Water Shedder - LH

LED Clear Side Repeater (Pair)

Drive Member - Heavy Duty

Fender - Front

Camshaft Cover Grommet sealing the camshaft cover to the cylinder head on the Td5 2.5L five-cylinder turbo diesel engine. The grommet forms a stat...

Drive Belt Idler Pulley for the auxiliary (accessory) belt drive of the Td5 2.5L 5-cylinder turbo diesel engine. The pulley mounts above the water...

Flywheel Bolt securing the flywheel to the rear flange of the crankshaft. Used on four-cylinder petrol and diesel engines, including the 200TDi an...

Transfer Gear Knob - High/Low - LT95 is the hand grip fitted to the high/low range transfer lever on the LT95 gearbox. It threads onto the top of ...

Side Steps - a matched left- and right-hand pair of fixed tubular side runners that bolt to the sill and chassis mounting points, forming a continu...

Injector Ring Seal for the Puma 2.2L TDCi 4-cylinder turbo diesel engine, seating in the injector bore in the cylinder head. The seal forms a gas-...

Brake Pipe T-Piece is a three-way hydraulic union in the rear braking circuit, joining the incoming brake line to the two rigid pipes that feed the...

Door Lock Kit - Push Button - Front

Timing Chain Guide for the primary timing chain drive of the 2.2L (Puma) diesel engine. The guide bears against the timing chain to control its pa...

Bottom Coolant Hose for the Td5 2.5L 5-Cylinder Turbo Diesel engine. This lower radiator hose forms part of the primary coolant circuit, connectin...

Bonnet - Less Hinges for the Defender Puma era body assembly. This bonnet panel is taller and wider than the pre-2007 Defender bonnet, with a dist...

Crankshaft Position Sensor - mounted to the cylinder block, it monitors crankshaft speed and angular position. The engine control module uses its ...

Distributor Cap for the Ducellier distributor fitted to 2.25 and 2.5 litre four-cylinder petrol engines. Part of the ignition system, the cap seat...

Brake Caliper - Assembly - Rear - LH

Thermostat for the 2.5L 300TDi diesel engine, operating within the thermostat housing at the top of the cooling circuit. The thermostat regulates ...

Rear Anti-Roll Bar Bolt secures the rear anti-roll bar within the rear suspension assembly. It fixes the bar to its mounting, holding it in positi...

Service Kit - Defender TD

Shock Absorber Bush is a rubber mounting bush that fits into the shock absorber mounting eyes, locating the damper at its chassis and axle attachme...

High-Mounted Stop Lamp Stud is a mounting stud for the high-level stop lamp. It secures the high-level (centre) stop lamp to its mounting point on...

LED Direction Indicator Lamp - Smoked is a rear direction indicator lamp to NAS (North American Specification) pattern in the 95mm round format, fi...

Fuel Injector for the fuel injection system of the 2.5L 200 TDi diesel engine. The injector atomises high-pressure diesel delivered from the injec...

EGR Valve to Pipe Gasket for the diesel exhaust gas recirculation (EGR) system. The gasket seals the flanged joint between the EGR valve and the r...

Suspension Link Bush is the rear upper A-frame bush, fitted at the chassis-side mounting of the A-frame that locates the rear axle. It cushions an...

Starter Motor for the 2.25L 4-cylinder diesel engine, operating in the engine starting circuit. When energised through the starter solenoid, the p...

Screw - Bonnet Hinge - M6 x 20 for the bonnet hinge assembly on the Defender. This M6 x 20 Torx-head screw secures the bonnet hinge. Used on vehic...

Radius Arm Bush Set - Front - a set of polyurethane bushes for the front radius arm axle-end mountings. The radius arm locates the front axle long...

Cylinder Head Gasket for the 2.2L TD4 turbo-diesel engine. Seals the joint between the cylinder head and the engine block, containing combustion p...

Brake Pad Set for the rear axle disc brakes, fitting the rear brake calipers. The friction pads clamp against the rear brake discs under caliper a...

Timing Chain Guide for the primary timing chain drive of the 2.2L (Puma) diesel engine. The guide bears against the timing chain to control its pa...

Gasket - EGR Cooler