Land Rover Defender Parts

Rear Body Outrigger (Outer) - a chassis bracket that extends outboard from the main chassis rail to support and locate the rear body. The outrigge...

Road Spring - rear coil spring for vehicles equipped with self-levelling suspension. The spring locates in the rear suspension and works in conjun...

Exhaust U-Bolt secures a joint in the front section of the exhaust system. The U-bolt clamps over the pipe at a slip joint and, tightened against i...

Heater Hose - a coolant hose in the heater circuit, running between the engine and the heater matrix. It carries engine coolant to and from the he...

Fuel Tank Drain Plug - the threaded plug that seals the drain point at the base of the fuel tank. Removing it allows the tank to be drained for se...

Body to Chassis Bracket - Rear - a body mount bracket that secures the vehicle body to the chassis at the rear. It locates the inner body mounting...

Servo Booster Vacuum, Valve Bottom - Right

Coolant Hose carries coolant between the radiator and the engine within the cooling circuit. Moulded for the 2.25L carburettor petrol engine fitte...

Radiator Hose for the engine cooling system, specific to the 2.25L Petrol engine with standard duty radiator. This hose connects the engine to the...

Metal Fuel Filler Cap seals the fuel tank filler neck, closing the fuel system against contamination, spillage and evaporative loss. The cap secur...

Grille Retainer Nut secures the radiator grille panel to its mounting points on the front body. It threads onto the grille fixing stud to hold the...

Nut An M4 hexagonal plain nut. A general-purpose metric fastener used across a wide range of assemblies. Takes a 7 mm spanner.

Windscreen Hinge - left-hand - for the Defender fold-flat windscreen assembly. This hinge forms one of two pivot points at the lower edge of the w...

Decal is an exterior body decal applied to the rear of the vehicle. It carries the Land Rover name in silver lettering on a black background, and ...

Fastener - black plastic drive-type (fir tree) push-in fastener used throughout the vehicle to secure body trim panels, interior linings, underbonn...

Sliding Window Catch - LH is the locking catch for the left-hand sliding side window in the rear cab panel of the Defender Hard Top. The catch sec...

Bump stop

Rear Window Glass for the rear body aperture, in clear glass. It glazes the rear window opening, fitting into the surrounding rubber seal. This is...

Side Window Retention Clip for the door glazing assembly on the Defender. This clip secures the side window glass within the door frame, holding t...

Lower Tailboard Bracket is the right-hand bracket for the bottom-hinged rear tailboard, part of the tailboard mounting assembly. It secures the lo...

Seat Back - Outer - Standard - Black for the left and right outer positions of the three-abreast front bench seat in Land Rover Series vehicles. T...

grab handle for 3rd / 5th door (rear end door). Upto (VIN) 1A622423

sill panel rear LH 90

Rear sill panel RH 90

Window Sliding Catch – LH is the left-hand catch for the side sliding window. It latches the sliding glass pane to hold it open or closed at the c...

Windscreen in tinted laminated glass - the front screen for the cab, supplied with the factory tint. Sending is only possible by pallet. Too fragi...

Plate Nut

Seat Back - Inner - the centre backrest of the three-piece front bench seat, trimmed in black vinyl. Fitted between the two outer seat backs, it p...

Mudflap Bracket retains the front right-hand mudflap, securing it to the body so the flap hangs correctly behind the front wheel. Manufactured in ...

Heater Controls Spacer - spacer fitted within the heater control assembly of the HVAC unit. Sold individually.

Nut Plate for the body-side striker mountings, part of the door and tailboard latch assembly. The plate provides captive threaded anchor points be...

Rear Body Lower Mounting Nut Plate used in the rear body mounting assembly on the Land Rover Defender. This pressed steel plate sits behind the bo...

Seat Back and Headrest for the outer front seat, in the deluxe pattern and finished in black. This is the upholstered backrest (squab) the occupant...

Bonnet Stop Buffer is a rubber buffer that cushions the bonnet where it rests against the body when closed. Mounted on the front bodywork, it supp...

Rear Light Guard - Single - Black is a steel mesh protective guard for a single rear lamp. It bolts over the rear lamp lens to shield it from impa...

Manifold Absolute Pressure (MAP) Sensor, part of the engine management system. The MAP sensor measures the absolute pressure inside the intake man...

Oil Sump Drain Plug, bolt and washer assembly, for the Rover V8 EFI engine. The drain plug seals the oil sump drain aperture at the base of the en...

Front Fuel Tank Outrigger is a chassis outrigger welded to the main frame rail, located at the rear of the front fuel tank to support and locate th...

Rear Crossmember, Heavy-Duty, pressed from 3mm steel and supplied with 200mm side extensions. The rear crossmember closes the back of the chassis ...

Rear Crossmember is the transverse structural member that closes the rear of the Defender ladder chassis, tying the two chassis rails together and ...

Door Pillar Bracket for the right-hand (offside) bulkhead door pillar, supplied as the bottom bracket only (less the pillar). The bracket forms th...

Clutch Kit renews the friction components that transmit drive between the engine and the manual gearbox. The clutch sits between the engine flywhe...

Transmission Output Shaft Grease for the MT82 six-speed manual gearbox. This specialist grease is applied to the gearbox output shaft splines, whe...

Hardtop Support Bracket for the rear body, forming part of the upper fixings that secure the hardtop to the bodyshell. The bracket supports the si...

Rear Propshaft transmits drive from the transfer box rear output flange to the rear axle differential input, forming part of the driveline on the 9...

Rear Door Glass - the glass assembly for the rear end (tail) door. It incorporates a heated element for demisting the rear window and an integrate...

Timing Chain Tensioner for the 2.2L Td4 (Puma) diesel engine. It maintains correct tension on the timing chain, taking up slack as the chain wears...

Seal rear side door LH GENUINE LR