Land Rover Defender Parts

Drive Belt Bracket and Bearing for the auxiliary (accessory) drive belt system. The bracket mounts to the engine and locates a pulley within the a...

Headlamp Kit

Piston Ring Set for the Td5 2.5L five-cylinder turbo diesel engine, standard size. Provides the compression and oil-control rings for one piston, ...

Front Door Latch Assembly for the right-hand front door. This mechanical latch is mounted inside the front door and engages the door striker on th...

Driving Member (axle drive flange) for the front and rear hub assemblies. It bolts to the outer face of the hub and engages the splined end of the ...

Crankshaft Spigot Bearing - 2.4 TDCi

Engine Front Cover - the timing case cover at the front of the Puma 2.4L Duratorq TDCi (and 2.2L TDCi) engine. It encloses the front of the cylind...

Output Shaft Oil Seal for the MT82 6-speed manual gearbox. Seals the output shaft at the rear of the transmission casing, preventing oil loss towar...

Head Gasket seals the joint between the cylinder head and the engine block. It seals combustion pressure, coolant and oil passages across the head...

Window Regulator for the right-hand front door, manually operated. The regulator carries the door glass within the door frame and raises or lowers...

Water Pump for the 300 Tdi 2.5L turbo diesel engine cooling circuit. The pump bolts to the engine front cover and circulates coolant through the cy...

Heat Shield - Engine Mount for the Puma diesel engine mounting assembly. This shield mounts over the engine mount rubber to protect it from heat a...

Eye End - Cross Rod

Thermostat Housing for the Puma 2.4L TDCi HPCR diesel engine. The cast housing that encloses the engine thermostat and connects the engine block to...

Connection - Water Outlet

Front Axle Shim, 0.45mm thick. Fitted to the front axle half-shaft assembly to set the correct end-float, taking up clearance so the shaft is posit...

Oil Seal Housing Gasket for the 300 TDi engine, sealing the rear crankshaft oil seal housing to the rear face of the cylinder block. The gasket fo...

Transfer Box - LT230 43D is a reconditioned two-speed transfer gearbox with a 1.4:1 high-range ratio. The transfer box mounts to the rear of the m...

Anti-Roll Bar Bush for the rear suspension. It locates and insulates the rear anti-roll bar (stabiliser bar) at its mounting to the chassis, allowi...

Valve Stem Seal for the Rover V8 engine, part of the cylinder head valve train. The seal fits over the top of the valve stem where it passes throu...

Cable Gaiter is a flexible protective sleeve and grommet fitted at the door aperture, routing the door wiring harness between the body and the door...

Crankshaft Oil Seal is the rear crankshaft (rear main) oil seal for the 2.2L and 2.4L Duratorq TDCi Puma diesel engine. It seals the rear of the c...

Side Lamp Lens - Front - Clear is the replaceable lens for the front side and indicator lamp within the exterior lighting assembly. The clear lens...

Starter Motor - Electric

Engine Mount - Rubber - Diesel supports the engine on the chassis and isolates it from the vehicle structure. The bonded rubber element absorbs co...

Set - 200 TDi Head Including Bolts

Caliper - Assembly

Panhard Rod Bush Set for the front suspension lateral location assembly. Each bush in this set is pressed into the Panhard rod eye and provides th...

Clutch Plate

Door Seal - Front - Top is the weatherstrip that closes the joint between the top edge of the front door and the roof cant rail, forming part of th...

Exhaust Manifold Locking Washer that secures the exhaust manifold fixings to the cylinder head. The tab washer fits under the manifold bolt or nut...

Distributor Cap for the Lucas distributor fitted to the four-cylinder petrol engine, part of the ignition system. The cap seats over the distribut...

Wheel Nut for alloy wheel fitment on Defender, Discovery 1 and Range Rover Classic. This tapered-seat wheel nut is designed for use with alloy whe...

Main Bearing Set for the 2.5L 4-cylinder engine (200 TDi, 300 TDi and the related 2.5 diesel and petrol units), supplied at standard size. The mai...

Pipe Clip, a routing clip that retains pipework and small-bore lines against the chassis, body or transmission casing. It supports breather, fuel,...

Cam Cover Gasket - Td5 - Late Type

Nyloc Nut - M16 flanged self-locking nut used at suspension link fastenings. The integral flange spreads the clamp load across the joint face and ...

Bow Shackle Bow-shaped recovery shackle with a threaded pin, used to connect a recovery strap or rope to a recovery point on a winch bumper. The w...

Headlamp Kit

Timing Cover Plate Gasket sealing the timing gear cover plate on the 300Tdi 2.5L four-cylinder turbo diesel engine. The gasket forms the joint bet...

Front Crankshaft Oil Seal for the 2.5L 300TDi turbo diesel engine. It fits around the crankshaft nose at the front of the engine, sealing the point...

Thermostat for the 2.5L 200TDi diesel engine, operating within the thermostat housing at the top of the cooling circuit. This thermostat opens at ...

Thermostat - 88°C for the cooling system of V8 petrol engines. The thermostat regulates coolant flow between the engine block and the radiator, al...

Transmission Handbrake Shoe Set is the friction pair for the drum-type parking brake mounted on the rear output of the transfer box. When the hand...

Fuel Injector - Nozzle and Holder Assembly for the 2.4L Duratorq-TDCi HPCR 140PS Puma diesel engine, part of the high-pressure common-rail injectio...

Linkage - Wiper

LWB Rear Seat Assembly

Bearing Set 030