Land Rover Defender New Parts

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Intercooler to Inlet Manifold Gasket from the charge air induction system of the supercharged 5.0L V8 petrol engine (AJ133). The supercharger and ...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Connection - Water

Thermostat Housing - engine cooling circuit component for the 3.0L Ingenium six-cylinder petrol engine (AJ20P6 / AJ22P6). The housing carries the ...

Timing Chain Tensioner - hydraulic tensioner in the timing chain drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). The tens...

Tensioner - Timing Belt

Seal Kit - Torque Converter - 8-Speed Auto

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...

Thermostat for the 2.0L Ingenium diesel engine (AJ200D) cooling system. It regulates coolant flow to bring the engine up to operating temperature q...

Manifold Absolute Pressure (MAP) Sensor - measures the pressure inside the intake manifold and supplies an engine-load signal to the engine control...

Manifold - Heater

Climate Control Humidity Sensor, an input device for the automatic climate control system. Mounted at the base of the interior rear-view mirror, i...

Timing Chain - the primary drive chain that links the crankshaft to the camshafts, synchronising valve timing with piston movement. For the 2.0L I...

Fuel Pump Drive Sprocket for the 2.0L Ingenium diesel engine (AJ200 / AJ20D4). The sprocket drives the high-pressure fuel pump from the engine's ti...

O-Ring and Grease Kit for servicing the transfer box input shaft. Contains the input shaft O-ring and the anti-seize grease used when resealing th...

Front Cylinder Cover - a cover that closes off the front face of the cylinder block, sealing the opening and enclosing the components behind it. F...

Drive Belt Tensioner - automatic tensioner for the front-end accessory drive on the AJ20 Ingenium petrol engine range. A spring-loaded pivoting ar...

Front timing cover - the lower centre cover that closes the front face of the cylinder block over the timing chain drive. It carries the crankshaf...

Fuel Vapour Valve (Purge Control Valve) - electrically operated solenoid valve in the evaporative emission control (EVAP) system, for supercharged ...

Supercharger Isolator - the torsional damping coupler inside the supercharger drive, sitting between the drive input and the rotor pack of the Root...

Timing Chain Tensioner for the timing chain drive of the 5.0L V8 (AJ133) and 3.0L supercharged V6 petrol engines. It bears against the timing chain...

Camshaft Sprocket for the timing drive of the Ingenium engine family - the 2.0L and 3.0L diesel and 3.0L petrol units. Mounted on the end of the ca...

Drive Belt Tensioner for the primary accessory drive at the front of the engine. The spring-loaded tensioner holds the correct tension on the belt ...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Coolant Degas Separator, part of the engine cooling circuit on 2.0L Ingenium (AJ200) petrol applications. The degas separator removes entrained ai...

Oil Filter Housing Cover is the cover for the cartridge-type oil filter assembly on 3.0 GDI petrol and 5.0 AJ-V8 engines. This cover retains the r...

Balance Shaft - counterweighted shaft forming part of the engine balancer assembly in the lower block. Driven from the crankshaft and running at t...

Crankshaft Pulley with integral torsional vibration damper, mounted on the crankshaft nose of the 2.0L Ingenium AJ200 four-cylinder petrol and dies...

Drive Belt Tensioner - engine front-end accessory drive. Sprung arm carrying an idler pulley that maintains correct tension on the accessory drive...

Cylinder Head Gasket sealing the cylinder head to the cylinder block. It contains combustion pressure at each bore and seals the coolant and oil g...

Water Pump for the engine cooling circuit, fitted to supercharged petrol applications (3.0L DOHC GDI supercharged V6 and 5.0L AJ133 DOHC supercharg...

Variable Valve Timing Solenoid - oil control solenoid for the variable valve timing system. The solenoid regulates engine oil flow to the camshaft...

Intercooler (charge air cooler) for the turbocharger induction circuit, mounted at the front of the vehicle within the cooling pack airflow. Compr...

Exhaust Gas Pressure Sensor for the 2.0L AJ200D Ingenium four-cylinder diesel, working within the turbocharger and exhaust gas management circuit. ...

Coolant Bypass Tube - rigid coolant transfer tube in the engine cooling system, connecting the thermostat housing to the heater water circuit. It ...

Cylinder Head Cover (Camshaft Cover) for the 5.0L V8 AJ133 petrol engine, naturally aspirated and supercharged applications. The cover bolts to th...

Camshaft Cover for the 5.0L V8 AJ133 supercharged petrol engine. It closes the top of the cylinder head, enclosing the overhead camshafts and valve...