Range Rover Parts

Rear Lower Suspension Arm Bush for the front pivot of the rear lower arm, within the rear knuckle and suspension arm assembly. The bush forms the ...

Lower Rear Knuckle Suspension Bush for the rear suspension. This bush fits the lower mounting of the rear knuckle (wheel carrier), forming the comp...

Transmission Sleeve for the ZF 6HP26 and 6HP28 six-speed automatic transmission. It is fitted within the main control valve body, where it forms th...

Belt Tensioner - 4.4 V8 AJ is the automatic tensioner of the accessory (auxiliary) drive belt system, holding the correct running tension on the pr...

Flanged Nyloc Nut, M10, a multi-purpose locking fastener used across the chassis and suspension. The nylon insert resists loosening under vibratio...

O-Ring for the engine coolant water manifold, sealing the manifold joint in the cooling circuit of the 4.4L M62 V8 petrol engine. Measuring 34.2mm...

Brake Caliper Assembly - RH

Air Strut - LH is the left-hand front air suspension strut, a MacPherson-type unit combining a hydraulic damper and an air spring in a single corne...

O-Ring - Fuel Injector - Diesel - sealing ring in the fuel injector and pipe assembly on diesel engines. The ring seals the injector joint against...

Oil Pump Oil Seal for the ZF 6HP26 and 6HP28 six-speed automatic transmission. It seals the oil pump hub at the front of the transmission, where t...

Track Control Arm is the front upper control arm for the left-hand side of the independent front suspension. It locates the top of the wheel knuck...

Brake Disc - Coated - vented front brake disc, part of the front disc brake assembly. The disc is mounted to the front hub and rotates with the ro...

Front Crankshaft Oil Seal seated in the engine front (timing) cover, sealing the crankshaft nose where it exits the crankcase. The seal runs again...

Intercooler Hose - Upper, Right-Hand for the charge-air (boost) circuit of the 3.6L V8 32V DOHC diesel engine. This is the upper hose on the right...

Water Pump is the engine-driven mechanical pump that circulates coolant through the cylinder block, cylinder heads and radiator to maintain engine ...

Air Filter for the engine air intake system. The element installs in the air cleaner housing and traps airborne dust and debris from the incoming a...

Thermostat Housing Seal for the engine cooling system, sealing the thermostat housing joint. Fitted between the thermostat housing and its mating ...

Flanged Nut - an M14 x 1.5 nut with an integral flange, used to secure suspension fasteners. The flange spreads clamp load across the joint face a...

Blade Assembly - Wiper

Coolant Expansion Tank Cap rated at 1.4 bar, fitted to the expansion (header) tank of the engine cooling system. The cap seals the expansion tank ...

Regulator - Fuel Pressure

Glow Plug for the TDV6 2.7L and TDV8 3.6L diesel engines. Glow plugs are installed per cylinder in the cylinder head and heat the combustion chamb...

Track Control Arm is the front upper control arm for the left-hand side of the independent front suspension. It locates the top of the wheel knuck...

Coolant Temperature Sensor in the engine cooling circuit. This sensor monitors coolant temperature and transmits a signal to the engine management...

EGR Valve for the right-hand cylinder bank of the 3.6L V8 TDV8 diesel (Lion) engine, part of the exhaust gas recirculation system. The valve meter...

Mass Air Flow Sensor - air mass meter fitted in the induction tract as part of the engine management system. The sensor sits in the intake ducting...

Relay, a 70A 4-pin grey mini power relay. It provides high-current make-and-break switching for a heavy electrical load, letting a low-current con...

Lower Front Suspension Arm for the front suspension assembly. This arm connects the chassis to the lower section of the front wheel carrier, locati...

Front Brake Caliper Pin Kit covering both front calipers (left and right). The kit supplies the guide pin hardware required when servicing the fro...

Air Filter Element for the engine air intake system, seated in the air cleaner housing. It filters incoming air before it reaches the turbocharger...

Front Brake Caliper Fitting Kit - pad retaining hardware for the front brake caliper. The pins pass through the caliper body to retain the brake p...

Handbrake Shoe Set for the mechanical parking brake, which operates inside its own dedicated drum and is independent of the hydraulic service brake...

Exhaust Gasket sealing a flanged joint in the exhaust system on Land Rover and Range Rover models fitted with the 2.7L TDV6, 3.0D V6, 2.2D, and 4.4...

Front Crankshaft Oil Seal for the 4.4L M62 B44 V8 petrol engine, sealing the crankshaft nose at the front of the engine. The seal is fitted into t...

Wheel Bearing for the front and rear hub assemblies. The same bearing serves all four corners. It is the sealed bearing unit clamped between the h...

Brake Hose for the front braking hydraulic circuit. This flexible hose carries pressurised brake fluid from the rigid chassis-mounted brake line to...

Intercooler Hose - left-hand upper hose in the charge air (intercooler) circuit of the 3.6L V8 32V DOHC turbo diesel (Lion TDV8). It carries press...

Camshaft Cover Bush for the 4.4L M62 B44 V8 petrol engine, fitted at the camshaft cover fixing points on the cylinder head cover. Each bush seats ...

Radiator for the engine cooling system. Mounted at the front of the vehicle behind the grille, this radiator dissipates heat from the engine coola...

Brake Pipe - Rear is a rigid hydraulic line forming the fixed section of the rear brake circuit, carrying pressurised brake fluid from the chassis-...

Exhaust Manifold Gasket seals the joint between the exhaust manifold and the cylinder head on the TDV8 3.6L V8 Turbo Diesel engine. This gasket pr...

Replacement Brake Hose

Rear Knuckle Bush - Upper from the rear independent suspension knuckle assembly. The bush presses into the upper bore of the rear knuckle and form...

Glow Plug for the TDV6 2.7L and TDV8 3.6L diesel engines. Glow plugs are installed per cylinder in the cylinder head and heat the combustion chamb...

Belt Tensioner for the auxiliary (accessory) drive belt system. The spring-loaded tensioner arm and pulley maintain the correct tension on the ser...

Ball Joint - Front Suspension Arm is fitted at the outer end of the upper front suspension arm, forming the pivot between the arm and the steering ...

Valve Stem Seal for the cylinder head valvetrain on TDV6 and TDV8 diesel engines. Fitted to both inlet and exhaust valves, the seal presses onto th...