Range Rover Parts

Handbrake Expander Assembly for the drum-type transmission (parking) brake mounted at the rear output of the transfer box. The expander sits betwe...

Brake Master Cylinder Repair Kit

Side & Flasher Lamp Lens for the front combined side and direction-indicator lamp, right-hand side. The lens fits over the front side (parking...

Side & Flasher Lamp Lens for the front combined side and direction-indicator lamp, left-hand side. The lens fits over the front side (parking)...

Suppressor Capacitor mounted at the ignition coil as part of the ignition system. It suppresses the radio-frequency interference generated by the ...

PAS Pump Gasket Set for the cast-bodied power steering pump on the 3.5 V8. It provides the gaskets for resealing the pump when it is dismantled fo...

Self-Tapping Screw - a No. 6 x 1/2" imperial self-tapping fixing used as a general-purpose fastener throughout the body and chassis. The self-tapp...

Screw for use in Land Rover body, chassis, and hardware applications.

Bolt used in the LT95 gearbox and transfer assembly. It provides a torque-loaded, clamped fastening securing components within the LT95 transmissi...

Festoon Bulb - 12V 21W is a double-ended festoon-type incandescent bulb rated at 12V 21W, fitted with contacts at both ends for installation in spr...

Snap Ring

Nutsert - 1/4" UNF is a blind rivet nut (rivnut) with a 1/4" UNF internal thread. A nutsert is installed into a pre-drilled hole in sheet metal or...

Upper Tailgate Screw, a fixing used in the upper tailgate assembly. It secures the upper tailgate components in place, providing a threaded fasten...

Screw - 2BA x 1" is a round head screw in British Association (BA) thread form, 2BA size, 1 inch in length. Used throughout the Series Land Rover ...

Distributor Drive Gear - V8

Fuel Filler Cap Seal for the fuel system of the Range Rover Classic. This rubber seal fits the hinged (flip-up) fuel filler cap and creates a fuel...

Heater Matrix for the cabin heater assembly, mounted inside the heater box within the HVAC housing. Engine coolant is circulated through the matri...

Bleed Screw for the imperial-specification front and rear brake calipers on the Range Rover Classic. This imperial-thread bleed screw fits the cal...

Front Brake Caliper Piston is a 41mm piston that operates in the front brake caliper, part of the braking hydraulic circuit for solid disc brakes. ...

Valve Guide for the Rover V8 cylinder head. Pressed into the cylinder head, the guide supports the valve stem and keeps the valve concentric with ...

Intake Elbow Seal for the 3.5L V8 twin-carburettor petrol engine. The seal sits between the air cleaner intake elbow and the carburettor intake to ...

O-Ring sealing the dipstick tube where it enters the cylinder block on the V8 petrol engine. Fitted around the lower end of the dipstick tube, thi...

Bolt used in the camshaft assembly of the 3.5L V8 petrol engine. Imperial UNF fastener, 7/16" diameter with a shank length of 1 1/8". Supplied as ...

Cylinder Head Bolt for the Rover V8 engine, 7/16" UNC thread. Used to secure the cylinder head to the block on the Rover 3.5L, 3.9L and 4.0L V8 en...

Cylinder Head Bolt Washer seats under the head of a 7/16in cylinder head bolt on the Rover V8 petrol engine. It distributes clamping load across t...

Cylinder Head Dowel for the V8 petrol engine. The dowel is a locating pin fitted to the cylinder block deck that positively registers the cylinder ...

Fuel Filler Cap for the fuel tank filler neck, part of the Fuel Tank & Ancillaries assembly. This is the hinged flip-type cap, fitted with a b...

Centre Silencer for the V8 single exhaust system. This intermediate silencer sits between the front (down) pipe and the rear silencer, providing t...

Rear Silencer & Tailpipe for the V8 single exhaust system. This is the rearmost section of the exhaust, combining the rear silencer and tailpi...

Inner Ring

Bolt rear caliper 7/16" UNF

Starter relay GENUINE LR

Oil Pressure Gauge for the instrument panel. It displays engine oil pressure, driven from the oil pressure sender on the engine's main oil gallery...

Washer 577254

Vacuum Actuator O-Ring for the LT95 4-speed gearbox. This O-ring seals the vacuum actuator fitted to the LT95 transfer case mechanism, used on V8-p...

Front Caliper Fixing Bolt with 7/16 UNF thread, used to secure the front brake caliper to its mounting bracket. This bolt is a safety-critical fast...

Swivel Pin Housing Joint Washer - RRC

Swivel Ball for the front axle swivel assembly. The swivel ball is the central spherical component around which the swivel housing rotates, enablin...

Front Brake Disc for the front axle braking system. This is a solid (non-vented) rotor with a diameter of 298 mm. Cross-references with Ferodo par...

Upper Swivel Pin forming the upper pivot of the front axle swivel housing. The pin bolts to the top of the swivel pin housing and runs in the uppe...

Swivel Pin Housing Shim - 0.010in is a 0.010 in (0.25 mm) shim used to set the bearing preload in the front axle swivel pin housing assembly. Fitt...

Oil Pressure Transmitter for the V8 engine oil pressure gauge circuit. This single-terminal sender threads into the engine oil gallery and varies ...

Hex Nut - 7/16 UNF fixing nut. Used on the fuel pipe unions of the 3.5L V8 twin-carburettor petrol engine. Also supplied as part of a service kit.

Gearbox Selector Pad for the LT77 five-speed manual gearbox. Fits the 5th gear selector within the selector and yoke assembly, forming the bearing...

Washer - a plain flat washer with a 10.5mm internal diameter, sized for M10 fasteners. It seats under a bolt head or nut to spread the clamping lo...

Circlip for the throttle linkage on the carburettor V8 engine. It retains a pin or clevis within the throttle linkage, holding the linkage componen...

Tappet Guide (guide only) locates and retains the tappet roller assembly within the engine block, maintaining correct alignment of the tappet as it...

Upper Tailgate Lock Barrel & Key secures the upper tailgate (load door) and provides key-operated locking. Supplied as the lock barrel with it...