Range Rover Parts

Parking Sensor is a Park Distance Control (PDC) ultrasonic sensor mounted in the bumper, part of the parking aid system. It emits and receives ult...

Fuel Filler Restrictor for diesel vehicles, fitted inside the fuel filler neck as part of the fuel tank and filler assembly. It forms a physical b...

Front Axle Output Seal - RH Outer - the outer oil seal on the right-hand output of the front axle case. It seals around the differential output fl...

Fuel Pressure Sensor for the high-pressure fuel injection circuit on petrol engines. It measures fuel rail pressure and temperature and reports to ...

Brake Pads for the rear axle, part of the rear brake discs and calipers assembly. The pads are clamped by the caliper pistons against both faces o...

Exhaust Gas Temperature Sensor monitors exhaust gas temperature within the exhaust and emissions system. Mounted on the exhaust manifold or turboc...

Primary Timing Chain Tensioner from the timing drive assembly at the front of the 2.0L four-cylinder AJ200 / AJ20P4 engine. The tensioner bears ag...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...

Sealing Ring - the right-hand outer seal for the front axle case, part of the front driveline. It seals the point where the front driveshaft passe...

Joint and Stub Shaft - the front-axle driveshaft joint and stub shaft assembly. Transmits drive from the front differential to the wheel hub, acco...

Rear Shock Absorber for the rear suspension damper assembly. The unit is handed neutral - the same damper serves both the left- and right-hand rear...

Output Shaft Oil Seal from the external components of the ZF 9HP48 / 9HP50 nine-speed automatic transmission. The seal fits around the gearbox out...

Trim Clip that secures interior and exterior trim panels, door finishers and mouldings to the body. The clip locates in a pre-formed panel apertur...

Front Brake Pad Set - Less Springs - friction pads for the front disc brake assembly, mounted in the front caliper and clamping the front brake dis...

Brake Pad Set for the front axle, sized for 18-inch brakes. The set provides the friction material that acts against the front brake discs. It is ...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). It runs in the up...

Knock Sensor for the engine management system, mounted on the rear face of the cylinder block. Petrol applications only - Ingenium AJ200P, AJ20P an...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Bolt - M8 x 45 mm Torx-head flange bolt for the propshaft flange connection. The bolt secures the flange-type propshaft joint to the mating drive ...

Clutch Master Cylinder - the hydraulic actuator at the head of the clutch circuit, mounted on the pedal box. It converts clutch-pedal effort into h...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Trim Clip that secures interior and exterior trim panels, door finishers and mouldings to the body. The clip locates in a pre-formed panel apertur...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Servo Seal - rubber grommet fitted to the brake vacuum booster (servo) housing. It seals the connection into the booster body, maintaining the vac...

Front brake disc, 325mm diameter, internally vented, forming part of the front brake disc and caliper assembly. Mounted to the front hub, the disc...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Wheel hub bearing for the front and rear knuckle and hub assemblies. The bearing carries vehicle load between the hub and the knuckle and allows t...

Timing Chain - Lower is the lower (primary) chain of the timing drive on the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4, including t...

Brake Caliper Guide Pin Kit for a floating (sliding) brake caliper. The guide pins locate the caliper body on its carrier bracket and let it slide ...

Fuel Pump Drive Sprocket is a timing-drive gear in the timing gear train of the 2.0L Ingenium diesel engine (AJ200D / AJ20D4). Driven by the timin...

Starter Inhibitor Switch mounted at the clutch pedal on manual-transmission models. It detects when the clutch pedal is fully depressed and prevent...

Piston - 0.50 mm Oversize for the 2.0-litre Ingenium (AJ200D / 204DTD) diesel engine. An engine-rebuild piston machined 0.50 mm over the standard ...

Solenoid Switch for the centre console switch pack, serving as the engine start-stop control. Mounted in the console and facia switchgear, it sign...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Engine Mount Insulator - Upper is the bonded rubber-to-metal isolator fitted in the upper engine mounting position of the transverse Ingenium power...

Air Conditioning O-Ring, 13.7 x 2.5mm, for the R134a refrigerant circuit. It seals a line connection in the front air-conditioning system on the c...

O-Ring - 9.5 x 2.5 mm seals a joint in the air conditioning refrigerant circuit, at the condenser and compressor connections. Compatible with syst...