Range Rover Parts

Connector

O-Ring - Radiator Hose

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

Oil cooler seal, 18 mm diameter, sealing an oil transfer connection between the engine and the oil filter housing on the 3.0L V6 diesel. Three are...

Ignition Coil for the 5.0L V8 petrol engine (AJ133), part of the ignition coil and spark plug assembly. This is a coil-on-plug unit: it mounts dir...

Automatic Transmission Fluid (ATF) for the automatic gearbox and power steering circuit. Specified as the transmission and power steering fluid to...

O-Ring for the oil pump outlet tube, sealing the pressurised feed within the oil pump, sump and filter assembly. The outlet tube carries oil from ...

Hose - Radiator

Intercooler to Inlet Manifold Gasket from the charge air induction system of the supercharged 5.0L V8 petrol engine (AJ133). The supercharger and ...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Radiator Hose - Top for the 5.0L AJ133 V8 petrol engine, part of the cooling system pipes and hoses. The top hose carries hot coolant from the eng...

Upper Front Suspension Arm Ball Joint The upper ball joint forms the top pivot between the front upper suspension arm and the wheel knuckle, holdi...

Exhaust Gas Temperature Sensor for the rear-of-catalyst position in the diesel exhaust aftertreatment system, on vehicles fitted with a diesel part...

Steering rack ball joint repair kit - M12 ball joints, steering gear and track rod linkage. The kit renews the outer connection between the steeri...

Inlet Manifold Gasket - seals the inlet manifold to the cylinder head on the 5.0L V8 AJ133 naturally aspirated petrol engine. The gasket closes th...

Lambda Sensor - left-hand bank exhaust gas oxygen sensor for the 5.0L AJ133 V8 petrol engine, mounted in the front pipe and catalyst section of the...

Accessory Drive Belt - ribbed serpentine belt for the front-end accessory drive of the 5.0L naturally aspirated V8 petrol engine. Driven from the ...

Sensor Assembly

Heater Water Hose - coolant hose in the heater circuit of the engine cooling system, for the 4.2 V8 Supercharged petrol engine. It carries engine ...

Coolant Hose - water outlet hose running to the cylinder head, part of the engine cooling circuit on the 3.6L V8 32V DOHC EFi diesel (Lion TDV8). ...

Inlet Manifold Gasket - seals the inlet manifold to the cylinder head on the 5.0L V8 AJ133 naturally aspirated petrol engine. The gasket closes th...

Coolant Hose - inlet tube connector hose in the engine cooling circuit of the 3.6L V8 32V DOHC EFi diesel (Lion TDV8). It carries coolant between ...

Air Suspension Compressor Cover - Upper is the upper half of the protective housing that encloses the air suspension compressor. It shields the co...

Exhaust Valve for the cylinder head of the 5.0L V8 petrol engine (AJ133), naturally aspirated and supercharged. It seals the exhaust port against ...

Upper Front Suspension Arm Ball Joint The upper ball joint forms the top pivot between the front upper suspension arm and the wheel knuckle, holdi...

Door Trim Name Plate - decorative name plate fitted to the visible face of the inner door trim panel. A cosmetic trim item only; it carries no str...

Primary Drive Belt - the main accessory drive belt of the 5.0L supercharged V8 petrol engine, running from the crankshaft pulley around the front-e...

Coolant hose connecting the radiator to the coolant expansion tank. Carries displaced coolant and air from the radiator into the expansion tank as...

Cylinder Head Gasket - Grade 5 for the 2.7L TDV6 diesel engine. Seals the joint between the cylinder head and the engine block, containing combust...

Accessory Drive Belt - ribbed serpentine belt for the front-end accessory drive of the 5.0L naturally aspirated V8 petrol engine. Driven from the ...

Parking Brake Cable Bracket from the parking brake cable routing. The bracket anchors the cable outer casing at a fixed point on the vehicle, so th...

Clip for the headlamp washer system. Retains the headlamp washer jet to the bumper.

Valve Cover Stud and Sleeve from the cylinder head cover fixings of the petrol V8 and supercharged V6 engines. The stud threads into the cylinder ...

Wiring Harness - Rear Bumper Parking Aid is the sub-harness that runs inside the rear bumper and connects the rear parking aid sensors to the vehic...

Outer Track Rod End with an M12 ball joint stud, forming the outer connection in the steering linkage. The track rod end threads onto the tie rod ...

O-Ring, 11mm - a sealing ring used in the power steering hydraulic circuit, at the union joints of the pressure supply and return hoses. It seats ...

Self-Tapping Screw - a fastener that cuts its own thread as it is driven, used in the luggage compartment door finisher and trim assembly. It secu...

O-Ring for the engine cooling system - it seals the water outlet tube at its connection to the cylinder block, alongside the thermostat housing. T...

Cylinder Head Gasket seals the joint between the cylinder head and the engine block on the 3.0L V6 turbo diesel engine, containing combustion press...

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

Camshaft Cover Gasket - LH seals the left-hand camshaft cover to the cylinder head on the AJ133 5.0L V8 petrol engine. It closes the joint around ...

Gear Selector Lever - lever that clamps to the manual selector shaft on the six-speed ZF automatic transmission, forming the gearbox end of the flo...

Exhaust Manifold Gasket - right-hand side seals the exhaust manifold against the cylinder head face on the right-hand bank of the engine. It conta...

Accessory Drive Belt - ribbed serpentine belt for the front-end accessory drive of the 5.0L naturally aspirated V8 petrol engine. Driven from the ...

Outer Track Rod End with an M12 ball joint stud, forming the outer connection in the steering linkage. The track rod end threads onto the tie rod ...

Outer track rod end - M14 thread, steering gear and track rod linkage. The track rod end threads onto the tie rod and its ball joint connects the ...