Range Rover Sport L320 Parts

Gasket Set

Head Gasket Set

Diff Overhaul Kit - Non-Locking - Rear

Piston, standard size, for the 3.0L TDV6 turbo diesel engine. Part of the cylinder block assembly – crankshaft, connecting rods and pistons. The p...

Front Brake Pad Set - friction pads for the front axle braking system. Ceramic-based pads that clamp against the front brake discs under caliper p...

Brake Pipe Connector - a junction fitting in the hydraulic brake circuit that joins rigid brake pipes. It provides a sealed connection between bra...

Tailgate Pivot for the rear tailgate (luggage compartment door). This pivot forms the hinge point about which the upper tailgate swings, locating ...

Rubber Mount - isolating mount in the suspension system. Cushions and locates suspension components against the chassis, damping vibration and noi...

Brake Pads - With Springs

Front Brake Pad Set - the friction pads for the front-axle disc brakes. The pads sit in the caliper and are clamped against the brake disc by the c...

Lower Inlet Manifold Gasket sealing the lower section of the inlet manifold assembly on the AJV8 petrol engines. It forms the joint between the lo...

Inlet Manifold Gasket sealing the inlet manifold to the cylinder head on the 4.2L V8 Supercharged petrol engine. It maintains a sealed air path at...

Fuel Injector for the 4.4L AJV8 petrol engine, forming part of the electronic sequential fuel injection system. The injector meters and atomises p...

Chain Timing

Timing Chain Tensioner maintains correct tension on the timing chain of the 4.4 AJV8 petrol engine, taking up slack as the chain wears to hold accu...

Camshaft Position Sensor reports camshaft position on the AJV8 petrol engine to the engine management system, providing the timing reference for ig...

Camshaft Sensor monitors camshaft position on the AJV8 petrol engine, providing the reference signal the engine management system uses to control i...

Oil Cooler Assembly in the engine oil cooling circuit of the AJ-V8 4.4L petrol engine. It dissipates heat from the circulating engine oil, holding...

Front Crankshaft Oil Seal for the AJV8 4.4L petrol engine, sealing the front of the crankshaft where it passes through the timing gear cover. It r...

Connecting Rod Bearing – Yellow is a big-end bearing shell for the connecting rod of the 4.4 V8 AJ petrol engine, carrying the rod on the crankshaf...

Connecting Rod Bearing – Green is a big-end bearing shell for the connecting rod of the 4.4 V8 AJ petrol engine, carrying the rod on the crankshaft...

Bearing - Crankshaft Main

Connecting Rod Bearing – Blue is a big-end bearing shell for the connecting rod of the 4.4 V8 AJ petrol engine, carrying the rod on the crankshaft ...

Upper Inlet Manifold Gasket sealing the upper section of the inlet manifold assembly on the 4.4L V8 EFI petrol engine. It forms the joint between ...

Bearing - Crankshaft Main

Main Bearing Blue Upper

Timing Chain Tensioner - Lower in the timing chain drive of the AJ-V8 petrol engine (4.4L and 4.2L supercharged). It maintains correct tension on ...

Cylinder Head Gasket - LH - Grade 5 seals the left-hand cylinder head to the engine block on the 3.6L V8 32-valve diesel (Lion TDV8) engine. It si...

Cylinder Head Gasket - LH seals the left-hand cylinder head to the engine block on the 3.6L V8 32-valve diesel (Lion TDV8) engine. It sits between...

Cylinder Head Gasket (Right-Hand Bank) seals the joint between the right-hand cylinder head and the engine block on the 3.6L V8 32-valve diesel (Li...

Timing Chain Tensioner Arm is part of the timing drive on the 3.6L V8 diesel (TDV8) engine. The arm bears against the timing chain on its slack si...

Timing Chain is part of the timing drive on the 3.6L V8 diesel (TDV8) engine. It transmits drive from the crankshaft to the camshafts, keeping val...

Timing Chain & Tensioner Kit - Upper

Filter - Oil - Paper Element Typ

PTFE Split Seal - a split polytetrafluoroethylene sealing ring used in the variable cam timing (VCT) gear of the AJ-series V8 petrol engine. The s...

Crankshaft Thrust Washer locates within the crankshaft main bearing assembly, seating at the thrust main bearing journal. It controls crankshaft e...

Turbo Stud is a fastener in the turbocharger mounting hardware. This double-ended stud carries an M8 thread at each end (10 mm and 25 mm thread le...

Fuel Pump & Sender Module - the complete in-tank fuel delivery unit for TDV6 and TDV8 diesel engines. Mounted inside the fuel tank, the module...

Rear Brake Caliper - Left-Hand is part of the rear braking assembly, mounting over the rear brake disc on the left-hand side of the vehicle. The c...

Water Pump for the engine cooling circuit on the 3.0L V6 diesel engine. This pump circulates coolant through the engine block, cylinder heads, and...

Anti Roll Bar Link

Coated Brake Disc is a rear brake rotor for the rear-axle braking assembly, finished with a protective coating on its non-friction surfaces. The d...

Rear Lower Suspension Arm Kit (Left-Hand) is built around the left-hand rear lower control arm of the rear independent suspension. The arm locates...

Arm - Front Suspension

Sensor - ABS - 4.4 V8 AJ Pet

Rear Anti-Roll Bar Link for the rear stabiliser (anti-roll) bar assembly. The drop link connects the end of the anti-roll bar to the rear suspensi...

Rear Lower Suspension Arm Kit (Right-Hand) is built around the right-hand rear lower control arm of the rear independent suspension. The arm locat...