Range Rover Sport L494 Parts

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Flanged Nut with an integral flange that spreads the clamping load and helps resist loosening, removing the need for a separate washer. Used to se...

Battery Management System sensor for the negative battery terminal, forming part of the vehicle's battery monitoring and charge-control circuit. I...

Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Tailgate Switch operates within the powered tailgate and luggage compartment locking controls. The switch signals tailgate release, actuating the ...

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Brake Disc & Caliper Bolt - a fixing bolt for the brake disc and caliper assembly. It is used at both the front and rear brake disc and calipe...

Thermostat and Housing assembly for the 2.0L 16V TIVCT turbocharged petrol (GTDi) engine. The thermostat regulates coolant flow to bring the engine...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). It runs in the up...

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Solenoid Switch for the centre console switch pack, serving as the engine start-stop control. Mounted in the console and facia switchgear, it sign...

Timing Chain Tensioner - hydraulic tensioner in the timing chain drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). The tens...

Tensioner - Timing Belt

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...

Output Shaft Oil Seal for the ZF 9HP 9-speed automatic transmission (9HP48 / 9HP50). The seal is fitted in the transmission housing around the out...

Climate Control Humidity Sensor, an input device for the automatic climate control system. Mounted at the base of the interior rear-view mirror, i...

Timing Chain - the primary drive chain that links the crankshaft to the camshafts, synchronising valve timing with piston movement. For the 2.0L I...

Front Cylinder Cover - a cover that closes off the front face of the cylinder block, sealing the opening and enclosing the components behind it. F...

Timing Belt Tensioner

Timing Belt Tensioner

Drive Belt Tensioner - automatic tensioner for the front-end accessory drive on the AJ20 Ingenium petrol engine range. A spring-loaded pivoting ar...

Camshaft Sprocket for the timing drive of the Ingenium engine family - the 2.0L and 3.0L diesel and 3.0L petrol units. Mounted on the end of the ca...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Crankshaft Pulley with integral torsional vibration damper, mounted on the crankshaft nose of the 2.0L Ingenium AJ200 four-cylinder petrol and dies...

Water Pump is part of the engine cooling system. It circulates coolant through the cylinder block, cylinder head and radiator to carry heat away f...

Passive Start Module is part of the keyless (passive) start and vehicle anti-theft system. It authenticates the smart key fob and allows the engin...

D3S xenon headlamp bulb, supplied with its igniter, for headlamp units originally built as bi-xenon or adaptive xenon assemblies. D3S is a mercury...

Rear Door Latch is the lock latch mechanism that secures the rear door to the body. Mounted in the trailing edge of the door, it engages the strik...

Front Door Latch - the left-hand (driver side) door latch assembly, mounted in the shut face of the front door. It engages the striker on the body...

Camshaft Sprocket A component of the timing gear that transmits drive from the timing chain to the camshaft, keeping valve operation synchronised w...

Exhaust Camshaft Sprocket for the valve timing drive on the 2.0L 16V TIVCT turbo petrol engine. Mounted on the exhaust camshaft, it is driven by t...

Crankshaft Pulley mounts on the nose of the crankshaft at the front of the engine and drives the front-end accessory belt. Fitted to the 2.0L 16V ...

Camshaft Sprocket for the camshaft drive, mounted on the end of the camshaft and driven by the timing chain from the crankshaft. It transmits the d...

Parking Camera, part of the surround camera and parking assistance system. It captures the video feed used by the driver assistance display during...

Combined Oil and Vacuum Pump for the 2.0L Ingenium (AJ200) diesel engine. This tandem unit houses the engine oil pump and the vacuum pump in a sing...