Skip to content
Search parts

533731 - Bearing Housing

- €81,70
€81,70
€81,70 - €81,70
€81,70
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Bearing Housing for the rear mainshaft bearing of the LT76 four-speed gearbox.

The housing locates and retains the bearing that supports the rear of the gearbox mainshaft within the casing, holding it concentric so the shaft runs true. It is an internal gearbox component, usually renewed during a gearbox rebuild.
Vehicle Model Land Rover Series 1
Land Rover Series 2 and 3
Fitment Notes Fitment data limited — derived from web research, verify if uncertain
SERIES I / II / IIA / III — Gearbox rear mainshaft bearing housing (LT76 4-speed)
Alternative Codes
533731

In stock 1 unit
1 · Gouda 0 · Drachten
Express delivery available

When will my order arrive?
  • Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
  • UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
  • Netherlands / Belgium / Germany: 2–4 working days.
  • Other EU countries + UK: 4–8 working days.
  • Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the Bearing Housing and what does it do?
This Bearing Housing locates and retains the rear mainshaft bearing in the LT76 four-speed gearbox. It holds the bearing concentric so the rear of the gearbox mainshaft runs true within the casing. It's an internal component, usually renewed during a gearbox rebuild.
Which Land Rovers use this gearbox bearing housing?
This bearing housing fits the LT76 four-speed gearbox used in Land Rover Series 1, 2, 2A and 3. Fitment data on this part is limited, so check it against your gearbox type before ordering, as Series gearboxes changed over the production run.
When is the bearing housing usually replaced?
The bearing housing is typically renewed during a gearbox rebuild, when the rear mainshaft bearing is changed. If the bore is worn or the bearing has spun in it, the housing can't hold the bearing true, so it's replaced while the LT76 gearbox is stripped down.