Hoseclamp 50-70 - Hose clamp 50-70 Hardware Part Land Rover Range Rover

Hoseclamp 50-70 - Hose Clamp – 50-70mm

- €1,00

€1,00

€1,00 - €1,00

€1,00

Tip: Log in to your account to unlock volume discounts on this item.

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Hose Clamp - 50-70mm A worm-drive hose clamp with an adjustable 50-70mm clamping range, used to secure a flexible hose onto its spigot or fitting.

Turning the screw draws the band evenly around the hose to hold a leak-free joint.

Alternative Codes

Hoseclamp 50-70

In stock 24 units

24 · Gouda 0 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the Hose Clamp 50-70mm used for?

The Hose Clamp 50-70mm is a worm-drive clamp that secures a flexible hose onto its spigot or fitting. Its band adjusts across a 50 to 70mm range, and turning the screw draws it evenly around the hose for a leak-free joint. It typically suits larger coolant, heater, or intake hoses.

How do I know if the 50-70mm size is right for my hose?

Measure the outside diameter of the hose once it's seated on its spigot, then pick a clamp whose range covers that figure. This clamp closes anywhere between 50 and 70mm, so the seated hose should fall inside that band, ideally near the middle rather than at either extreme.

How many hose clamps do I need for a hose replacement?

Typically you'll need one 50-70mm clamp per hose end, so a single hose usually takes two. It's common practice to renew clamps whenever a hose is disturbed, since a reused worm-drive band can lose tension and weep. Buy to match the number of joints on the hose you're replacing.