Land Rover Parts

rock slider, rock guards (pair) BA 2091 Generic picture, the set supplied is BLACK coated, NOT galvanised.

Fuel Catch Tank Pipe - part of the V8 petrol evaporative loss (fuel vapour) system. This pipe connects to the fuel catch tank, carrying evaporativ...

Valance Panel - a replacement body panel forming part of the outer bodywork in the wheelarch and valance area of the lower body.

Temperature Sensor mounted in the air filter (air cleaner) housing. This thermal sensor unit sits within the air intake housing and responds to th...

Expansion Tank Carrier for the V8 petrol engine cooling system. This bracket mounts and supports the coolant expansion (header) tank in the engine...

Relay for use in 24V vehicle electrical systems. Electromagnetic switching device with a 24V operating coil and 20A contact rating. Used to switch...

Brake caliper repair kit Freelander to (V) YA999999

Repair Caliper Kit

Needle Roller Bearing - supports the worm and input shaft within the manual (non-power-assisted) steering box of the Gemmer type. It locates the w...

Rear Lamp Lens for the left-hand side, forming the outer cover of the rear lamp assembly. The lens fits over the lamp body to seal and protect the ...

Circlip - Mainshaft Bearing Housing for the Land Rover Series I, II, and III gearbox. This circlip retains the mainshaft bearing within the bearing...

Towing Pin provides a centre towing and recovery attachment point on the front bumper. The pin mounts at the centre of the bumper to give a fixed ...

Anti-Roll Bar Link - Front is a drop link in the front stabilizer bar assembly. The link connects the end of the front anti-roll bar to the front ...

Lower Front Suspension Arm Ball Joint - 35 mm The lower ball joint forms the bottom pivot between the front lower suspension arm and the wheel knu...

Joint Assy - Ball

Outer Track Rod End with an M12 ball joint stud, the outer connection in the steering linkage. The track rod end threads onto the tie rod and its ...

Belt alternator RR L322 Dayco

Track Rod Protection Bracket from the front axle assembly. It mounts to the front differential housing and shields the steering track rod. The bra...

Heater Hose for the cabin heating circuit, carrying engine coolant between the cooling system and the heater matrix to supply heat to the cabin. S...

Channel fitted to the top of the Defender rear side door frame, guiding and retaining the upper edge of the main drop glass as it operates.

Temperature Sensor is the engine coolant temperature sensor for the V8 EFI petrol engine, mounted in the inlet manifold coolant passage. It measur...

Gear Fluid Supplement is a gear oil additive for manual transmissions, transaxles, transfer cases and final drives that run on gear oil. Formulate...

Rear coil spring seat for the chassis, the upper seat that locates and supports the top of the rear coil spring at the chassis outrigger. The seat...

Sill Protector in aluminium, forming part of the external body protection for the sill panel below the door aperture. The panel covers the outer f...

Timing Chain Guide for the primary timing chain drive of the 2.2L (Puma) diesel engine. The guide bears against the timing chain to control its pa...

Track Rod End - the outer ball joint that connects the track rod to the steering knuckle. Transmits steering movement from the track rod to the wh...

Spark Plug - ignition spark plug for the 3.2L Si6 six-cylinder petrol engine. Part of the ignition system, fitted to the 3.2L Si6 petrol engine.

Gasket

Pollen Filter - cabin air filter for the heating, ventilation and air conditioning intake housing. It sits in the fresh-air path upstream of the b...

Pollen Filter for the cabin air intake, part of the HVAC ventilation system. It installs in the intake housing upstream of the blower motor and eva...

Timing Belt - 114-tooth timing belt for the 2.0L L-Series diesel engine. Drives the camshaft and injection pump in time with the crankshaft, maint...

Pollen Filter - the cabin air filter in the heater and ventilation intake of the HVAC assembly. It sits in the fresh-air intake upstream of the bl...

Cylinder Head Pair for the Rover V8 EFI petrol engine - the two aluminium-alloy heads that close the top of the left and right cylinder banks. Eac...

Gearbox Reverse Stop Adjuster screw, part of the reverse gate mechanism in the manual gearbox gear-selection assembly. It sets and limits the gear...