Products

24v dsl long belt

Oil Pan Gasket for the engine lubrication system, sealing the oil pan (sump) to the underside of the cylinder block. The gasket forms the oil-tigh...

Valve Stem Seal for the cylinder head valve train, fitting over the valve stem at the top of the valve guide. The seal meters lubrication down the...

Front Crankshaft Oil Seal seated in the engine front (timing) cover, sealing the crankshaft nose where it exits the crankcase. The seal runs again...

Valve Stem Seal for the cylinder head valvetrain on TDV6 and TDV8 diesel engines. Fitted to both inlet and exhaust valves, the seal presses onto th...

Oil Filter for the 2.7L TDV6 diesel engine, part of the engine lubrication circuit. A paper-element filter that removes wear particles and contami...

Kit - Drive Belt

Camshaft Seal for the TDV6 2.7L V6 diesel engine. Seals the camshaft at its exit point from the cylinder head, preventing oil leakage from the cams...

Clamp - Tube

Bolt - Exhaust Manifold & EGR - a fixing bolt used in the exhaust manifold and exhaust gas recirculation (EGR) assembly of the TDV6/TDV8 diesel...

Coolant Connecting Tube - rigid coolant transfer pipe located at the thermostat housing within the engine cooling system of the 2.7L TDV6 diesel en...

Timing Chain & Tensioner Kit - Upper

Throttle Body Housing Seal seals the rear interface of the throttle body housing where it mates with the adjoining intake ducting, within the engin...

Crankshaft Oil Seal is the front main oil seal that seals the nose of the crankshaft where it passes through the timing cover on the 4.0L V6 petrol...

Camshaft Pulley Hub mounts to the front of the right-hand (RH) cylinder bank camshaft on the 2.7L and 3.0L V6 diesel engine, forming part of the ti...

Oil Tube Gasket seals the turbocharger oil drain (return) pipe where it joins the engine, within the turbocharger lubrication circuit. After lubri...

Exhaust Gasket for the TDV6 2.7L V6 diesel engine. Seals the joint between the exhaust manifold and the cylinder head, preventing exhaust gas leaka...

EGR Outlet Pipe Gasket seals the joint between the EGR outlet pipe and the intake system on the 2.7L TDV6 diesel engine (Lion V6). It sits where r...

Cylinder Head Bolt for the cylinder head assembly on TDV6 and TDV8 diesel engines. The bolt secures the cylinder head to the engine block, clamping...

Thermostat O-Ring for the TDV6 diesel engine. This O-ring provides the coolant seal at the thermostat housing on TDV6 diesel engines, preventing c...

Oil Separator Seal - sealing gasket for the oil separator in the crankcase ventilation system of the 2.7 and 3.0 litre V6 diesel engines. The oil ...

Thermostat Housing Gasket for the 2.7L TDV6 diesel engine. This gasket seals the thermostat housing (water outlet) to the engine, preventing coola...

Oil Pump Seal for the V6 diesel engine oil pump assembly, part of the engine lubrication circuit. It seals the oil pump interface to prevent oil l...

Glow Plug for the TDV6 2.7L and TDV8 3.6L diesel engines. Glow plugs are installed per cylinder in the cylinder head and heat the combustion chamb...

Oil Cooler Gasket for the oil cooler / oil filter housing assembly on the 2.7L TDV6 diesel engine. The gasket seals the joint between the oil cool...

Exhaust Manifold Stud for TDV6 2.7 and 3.0 and TDV8 3.6 diesel engines, used to fasten the exhaust manifold to the cylinder head. On 2.7 TDV6 engi...

Engine Oil Sump for the 2.7 TDV6 diesel engine. The sump forms the lower section of the crankcase and houses the oil reservoir from which the oil p...

Banjo Washer for the oil feed pipe banjo union at the turbocharger, used on TDV6 2.7L/3.0L and TDV8 3.6L/4.4L diesel engines. This sealing washer ...

Gasket - Oil Tube

Tube - Injection Pump Leak-Off

Coolant Temperature Sensor in the engine cooling circuit. This sensor monitors coolant temperature and transmits a signal to the engine management...

Timing Chain Tensioner – Balance Shaft maintains tension on the balance shaft drive chain of the 4.0L V6 Cologne SOHC petrol engine, taking up slac...

Oil Filter filters the engine lubrication oil on the 4.0L V6 Cologne SOHC petrol engine, removing contaminants from the oil before it returns to th...

Cylinder Head Bolt - M10 x 175mm bolt clamping the cylinder head to the block on the AJ-series V8 petrol engine. A torque-to-yield fastener; twent...

Front Brake Pad Set - the friction pads for the front-axle disc brakes. The pads sit in the caliper and are clamped against the brake disc by the c...

Floor Pan Blanking Plug. It closes an unused aperture in the floor pan, sealing the opening against water, dust and road debris.

Fuel Filler Door Latch Bezel is the trim surround that locates and frames the fuel filler flap latch within the fuel filler housing. It seats in t...

Front Wing - LH

Bracket - Fender Mounting

Rivet Screw - 6.3 x 22mm for securing panels and trim on Land Rover vehicles. This scrivet-type fastener combines a screw thread with a expanding ...

Domed Nut - retains the dash ventilator (face-level fresh-air vent) in the facia. Used on vehicles without air conditioning. The domed (acorn) for...

Stay Luggage compartment door stay that supports the door when open and controls its travel. Mounts between the body and the luggage compartment d...

Door Stay for the luggage compartment (lower tailgate) door. Restrains the door's opening travel and supports it in the open position, taking the l...

Door Stay for the luggage compartment (lower tailgate) door. Restrains the door's opening travel and supports it in the open position, taking the l...