Products

Telematics Control Unit Backup Battery, a lithium-ion cell that supplies the Telematics Control Unit (TCU) when the main vehicle battery is disconn...

Lithium-Ion Battery - the backup battery for the Telematics Control Unit (TCU). It supplies backup power to the telematics control unit so the uni...

MAP Sensor is the manifold absolute pressure and charge-air temperature sensor mounted in the inlet manifold. It reports intake manifold pressure ...

Macpherson Strut with Magnetic Damping for the front suspension, left-hand side. The damper uses a magnetorheological fluid whose viscosity is vari...

MacPherson Strut for the front suspension, right-hand side. This is a complete strut assembly combining the damper and its upper mount within the ...

Bolt used in the front brake disc and caliper assembly. This is a securing fastener within the front braking installation.

Brake Disc is a rear brake disc within the rear axle braking assembly, 325mm in diameter. The disc provides the friction surface the brake pads cl...

Brake Disc is a rear brake disc within the rear axle braking assembly, 325mm in diameter. The disc provides the friction surface the brake pads cl...

Brake Disc - Pair is a matched pair of rear brake discs for the rear axle braking assembly, each 325mm in diameter. Each disc provides the frictio...

Brake Disc is a rear brake disc within the rear axle braking assembly, 325mm in diameter. The disc provides the friction surface the brake pads cl...

Brake Pad Set for the front axle, sized for 18-inch brakes. The set provides the friction material that acts against the front brake discs. It is ...

Cylinder Head Gasket for the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4). The gasket seals the joint between the cylinder head and ...

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Cylinder Head Bolt for Ingenium petrol engines (1.5L AJ20P3, 2.0L AJ200 / AJ20P4, 3.0L AJ20P6 / AJ22P6). The bolt clamps the cylinder head to the ...

Ignition Coil for the 2.0L four-cylinder petrol engine (AJ200 / AJ20P4, including PHEV). This is a coil-on-plug unit that mounts directly on the sp...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Timing Chain - Lower is the lower (primary) chain of the timing drive on the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4, including t...

Timing Chain - the primary drive chain that links the crankshaft to the camshafts, synchronising valve timing with piston movement. For the 2.0L I...

Timing Chain Tensioner for the 2.0L Ingenium petrol engine (AJ200P). Maintains running tension on the timing chain, taking up slack to keep valve ...

Guide - Timing Chain

Timing Chain Guide locates and supports the timing chain within the timing drive assembly. It maintains correct chain alignment along its run, con...

Guide - Timing Chain

Timing Chain Guide locates and supports the timing chain within the timing drive assembly. It maintains correct chain alignment along its run, con...

Timing Chain Tensioner Arm is the pivoting guide arm in the timing drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4 / AJ200P ...

Timing Chain Tensioner Arm bears against the timing chain within the timing drive assembly, providing the face through which the tensioner applies ...

TMAP Sensor is the combined intake air temperature and manifold absolute pressure sensor, fitted to the inlet manifold and intercooler ducting. It...

Oil Cooler Gasket seals the oil cooler within the oil cooler and filter housing assembly. It maintains the oil-tight joint between the cooler and ...

Brake Pad Wear Wire is the rear brake pad wear warning sensor, fitted to the rear brake pads within the rear disc and caliper assembly. The wire c...

Knock Sensor mounts on the cylinder block and detects engine knock through block vibration. It reports combustion knock to the engine management s...

Knock Sensor mounts on the cylinder block and detects engine knock through block vibration. It reports combustion knock to the engine management s...

Knock Sensor detects engine detonation (knock) on the 2.0L Ingenium four-cylinder petrol engine. Bolted to the cylinder block, it converts combust...

Connecting Rod Bolt secures the connecting rod big-end cap to the connecting rod within the crankshaft, pistons and bearings assembly. The bolt cl...

Exhaust Mounting Rubber (insulator/hanger) in the exhaust system suspension. Supports the exhaust system on its mounting brackets, isolating exhau...

NOx Trap Temperature Sensor is an exhaust gas temperature sensor within the diesel exhaust aftertreatment system, mounted in the exhaust stream at ...

Fuel Injector Sealing Washer for the fuel injection system. Seals the fuel injector against the cylinder head, maintaining the combustion seal and...

Fuel Injector Sealing Washer for the fuel injection system. Seals the fuel injector against the cylinder head, maintaining the combustion seal and...

Sealing Washer is the fuel injector sealing washer for the Ingenium diesel engine (2.0L and 3.0L AJ20 / AJ21 diesel). It seats at the base of the ...

Front Crankshaft Oil Seal for the AJ200 2.0L four-cylinder petrol and diesel engine. It seals the front of the crankshaft where it passes through t...

Front Crankshaft Oil Seal for the AJ200 2.0L four-cylinder petrol and diesel engine. It seals the front of the crankshaft where it passes through t...

Front Crankshaft Oil Seal located at the front of the cylinder block, on the crankshaft. Seals the crankshaft where it exits the front of the engi...

Mass Air Flow Sensor in the engine air intake system, fitted in the intake tract between the air filter and the throttle and turbocharger inlet. It...

Solenoid Control Switch - ignition and start control switch located in the facia and console. It controls the engine start function through the ve...