Products

Coil Spring - Rear for the rear suspension. It supports the vehicle weight carried over the rear axle and sets the rear ride height. This is a rai...

Coil Spring - Front for the front suspension. It supports the vehicle weight carried over the front axle and sets the front ride height. This is a...

Front Coil Springs - heavy-duty replacement pair for the front suspension. Shot peened, double scragged and load tested for consistent spring rate ...

Fuel Pipe Sealing Washer seals the fuel pipe union at the DPA diesel injection pump. Fitted at the union connection, it is compressed between the ...

Rear Coil Spring Pair - heavy-duty load rating - for the rear suspension assembly. The springs seat in the rear spring towers between the axle perc...

Front leaf spring LWB diesel DS

Rear Coil Spring Pair - medium load rating - for the rear suspension assembly. The springs seat in the rear spring towers between the axle perches ...

Front Coil Springs HD Pair

Carburettor Bell Crank Bush for the accelerator throttle linkage on the 2.25L 4-cylinder petrol engine. The bush locates the throttle bell crank a...

Past op  1958 - 61:   Sommige S 3 vanaf 1977 en 110 1983 - 84 All 3 Lug Internal Fixings

Accelerator Pedal Return Spring for the cable-operated throttle linkage. The spring returns the accelerator pedal to its rest position when foot p...

Rocker Bracket Locating Dowel for the cylinder head and rocker assembly in the 2.25L and 2.5L petrol and diesel engines. This dowel locates the ro...

Intermediate Shaft

Driving Member Bolt secures the driving member, or drive flange, to the wheel hub. The driving member transmits drive from the axle halfshaft to t...

Cylinder Head Bolt is the short-length head bolt that clamps the cylinder head to the block on the 2.25L and 2.5L 4-cylinder petrol engines. The h...

Leaf Spring - LWB - Rear - Drivers Side

Leaf Spring is the rear passenger-side leaf spring for long-wheelbase (LWB) chassis, of 8+2 leaf construction. Land Rover lists it as the left-hand...

Bowl Washer is the sealing joint washer for the fuel sediment bowl (sedimentor) in the fuel system. It seals the bowl to its housing, maintaining ...

Brake Caliper Bolt secures the rear brake caliper to its mounting bracket within the rear braking assembly. It clamps the caliper body in position...

Headlamp Bowl Kit - Series

Flat Washer with a 3/8" bore, fitted under a bolt head or nut to spread the clamping load over a wider area and protect the mating surface.

Distributor Contact Set - the contact breaker points assembly for the ignition distributor. Mounted on the distributor baseplate, the points open ...

Lock Washer fitted under a nut or bolt head to lock a threaded fastening against loosening. Its sprung form bears against the joint face and the u...

Hex Nut used in the clutch master cylinder and pipe assembly. This standard hex nut secures hydraulic pipe fittings or mounting hardware within th...

Main Switch - 200A 24V / 100A 12V - No Key

Controle lamp groen, universeel Diameter kop: Ø 24 mm. Diameter schroefdraad: Ø 15 mm. Lengte behuizing: 35 mm. Gloeilamp: 12 Volt, 2 Watt, Ba9s.

Stekker 7-polig Pvc

Trailer Plug - 7-Pin - Aluminium

Trailer Socket - 13-Pin - PVC

Trailer Adaptor for converting between a 7-pin and a 13-pin towing electrical connection. It lets a vehicle fitted with one connector standard be ...

Auto Cable, seven-core automotive wiring cable with a 1.5 mm² cross-section per core, supplied by the metre. The seven cores allow a complete trai...

Glass Fuse, rated at 10A, in the standard 6.3 x 32mm cartridge size. A cylindrical glass-bodied cartridge fuse with metal end caps, fitted in the ...

Relay - 12V automotive changeover relay with a 30A contact rating, twin make. The five-pin configuration provides two normally-open contacts, allo...

Hinge Pin - the pivot pin for the top hatch (windscreen) hinge. It passes through the hinge knuckles to retain the two halves of the hinge while a...

Panel Rivet - a round-head solid rivet for body panel fixing. Used to join body panels and brackets, it has a domed (round) head, a 3/16 in shank ...

Washer