Land Rover Defender Parts

Crankshaft Damper for the 300TDi 2.5L turbo diesel engine, mounted on the front nose of the crankshaft. This torsional vibration damper absorbs th...

Self-Tapping Screw, size No. 6 x 3/8", for the door glass and window regulator assembly. This screw secures the window glass run channel to the do...

Cable Tie, a push-fit strap for routing and securing wiring and hoses. The tie strap bundles and secures wiring looms, pipes and hoses, locating i...

Clutch Cover is the pressure plate assembly of the manual transmission clutch, for V8 petrol applications. It bolts to the engine flywheel and cla...

Plastic Washer serves as a spacing and anti-friction washer at the front seat hinge and the rear door check arm pivot. Fitted at the pivot joint, ...

Battery Clamp Bolt - fastener for the battery retention assembly. Secures the battery clamp bar across the top of the battery, holding the battery...

Spring Washer - 6mm for use across gearbox, clutch and general fastening applications. A helical split spring washer for M6 fasteners, providing r...

Fuel Pipe - Pump to Engine for the Td5 diesel fuel delivery system. This under-body pipe assembly carries fuel from the in-tank pump forward to th...

Plain Washer - metric M10 flat washer for use in general fastening assemblies throughout the vehicle. A standard flat washer used to distribute lo...

Tow hitch 110 TD5 adjustable

Pan Head Screw, M4 x 12mm. Metric pan head screw for use across a range of Land Rover assemblies, including brake system and electrical components.

Plain Washer - Large 5/16" is a large plain washer for use with 5/16" fastenings, providing load distribution beneath bolt heads and nuts across La...

Floor-Mounted Headlamp Dipswitch for Land Rover Series 2A vehicles. This foot-operated switch mounts to the cab floor and controls switching betwe...

Steel Wheel - a 5.5J x 16 inch tubeless welded steel road wheel, finished in black. The rim carries a 35 mm offset (ET35). Its welded tubeless con...

Intercooler Hose - To Tube - RH is a charge-air hose in the intercooler (charge-air cooling) circuit of the 2.4L Puma turbo diesel. It forms the r...

EGR Cooler Hose - Engine to Cooler is a coolant hose serving the exhaust gas recirculation (EGR) system. It carries engine coolant from the engine...

O-Ring for the fuel injector harness assembly on the Td5 2.5L 5-Cylinder Turbo Diesel engine. This O-ring provides a seal within the fuel injector...

Locknut is a 1/4" UNF self-locking nut used as a general threaded fastener across the vehicle. Its locking feature resists loosening under vibrati...

Hose Clip is an adjustable worm-drive band clip that clamps a flexible hose onto its spigot or fitting. It tightens over the hose with a screw-dri...

Safari Door - the rear load (tail) door of the body assembly, supplied unglazed and without a spare-wheel carrier. It hinges on the rear body to c...

Crankshaft Pulley Bolt - M12 x 80mm fastener that secures the crankshaft pulley (torsional vibration damper) to the front nose of the crankshaft on...

Clip retains the heater and air-conditioning control cable within the HVAC control assembly, holding the cable on its correct routing.

O-Ring for the manual air conditioning pipe and hose circuit. This O-ring seals connections within the manual air conditioning pipework, preventin...

Bolt - M8 x 40mm for the front seat rail mounting. This bolt secures the front seat rails to the floor pan. M8 thread, 40mm length. Sold as a sing...

Retaining Plate - gearchange grommet retaining plate for the transfer box. Secures the transfer box gearchange grommet where the gear lever passes...

Radiator Muff in black, by Exmoor Trim, for the classic Defender radiator protection system. This cover fits over the front grille and radiator on...

Crankshaft Main Bearing Cap Cross-Bolt Seal Washer for the Rover V8 petrol engine. This 19mm diameter seal washer seals the main bearing cap cross...

Drain Plug - Coolant - Cylinder Block is the threaded plug that seals the coolant drain port in the cylinder block, providing a controlled drain po...

Screw Kit - Grille & Heater Inlet is a set of stainless steel fasteners for securing the front grille and the heater inlet panel to the front b...

Celebrate the elegance and ruggedness of the Land Rover Defender 90 Autobiography edition with this detailed 1:76 scale diecast model in sleek Corr...

Door Pillar Repair Bracket for the front left-hand (nearside) door pillar. A welded repair section that renews the front door pillar at the bulkhe...

Lamp Lens Screw Kit - stainless steel screws for retaining exterior lamp lenses. Replaces the lens-retaining screws on the side lamp, indicator an...

Mud Flap Bracket for the right-hand rear position on High Capacity Pick Up (HCPU) bodywork. Part of the exterior mud flap mounting. The HCPU rear ...

Programmable Wiper Delay Relay is a direct replacement for the standard AMR2341 relay in the front wiper circuit, providing a user-adjustable inter...

Relay operates within the anti-theft alarm and central locking circuit. This relay switches power to the alarm and remote central locking system, ...

Door Sill Seal - rear, supplied as a left- and right-hand pair. This rubber seal fits along the rear door sill aperture, forming the weather seal b...

seal washer for block coolant drain plug. - All 4-cylinder engines upto 1998 (except VM diesel)

Cable Tie for securing wiring looms and cables in Land Rover applications.

Screw - No.10 x 1" Pan head, self-tapping, pointed fastener used in door trim and window regulator assemblies. It secures the interior grab handle...

Screw - a No. 10 x 1" pan-head self-tapping screw used across interior and door assemblies. It secures the window regulator and door glass channel...

Banjo Bolt secures the breather pipe to an axle, gearbox or transfer case housing. The bolt is drilled through its shank and head so that, clamped...

M6 Stud for the gearbox main casing. This threaded stud secures the speedometer drive housing to the transmission main casing, providing the fixin...

Swivel Ball Taper Plug for the front axle swivel housing. This tapered-thread plug screws into a port in the swivel ball housing, sealing it agains...

Rocker Shaft Locating Bolt for the 2.25L and 2.5L petrol, 2.5L naturally aspirated diesel and 2.5L turbo diesel engines, securing the rocker shaft ...

Fitment: All Models Except TD5

Tailgate Chain Bracket

Glow Plug Lead in the diesel glow plug (heater plug) pre-heat circuit. This short 5" lead interconnects glow plugs wired in series and is not inte...

Gear Lever Anti-Rattle Plunger Spring The lower plunger spring for the gear lever in the gearchange mechanism of the 5-speed manual gearbox (LT77 a...