Land Rover Defender New Parts

Screw, M6 x 38mm, from the timing gear assembly - timing chains, tensioners and guides, and the auxiliary drive. It retains the chain guide in pos...

Knock Sensor for the engine management system, mounted on the rear face of the cylinder block. Petrol applications only - Ingenium AJ200P, AJ20P an...

Transmission Oil Cooler - part of the automatic gearbox cooling circuit, fitted to ZF 8-speed automatic transmissions. The cooler dissipates heat ...

Rear Brake Disc - a vented disc from the rear brake disc and caliper assembly. The disc is mounted on the rear hub behind the road wheel and rotat...

Wheel Nut Set - set of twenty wheel nuts, sufficient for four five-stud road wheels. Each nut clamps the road wheel against the hub face on the wh...

Timing Chain - Lower is the lower (primary) chain of the timing drive on the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4, including t...

Brake Pad Kit - Front - front axle set of disc brake pads for the 19-inch front brake disc and caliper installation. The pads are clamped against ...

Front Brake Pad Kit for vehicles built with the size 20 front disc and caliper package, supplied as a complete front axle set. The pads work in th...

Front Brake Pad Kit for vehicles built with the size 20 front disc and caliper package, supplied as a complete front axle set. The pads work in th...

Camshaft Position Sensor monitors camshaft rotation for the engine management system. Mounted in the cylinder head and camshaft cover, it signals ...

Oxygen Sensor (lambda sensor) for the lower, post-catalyst position in the exhaust gas sensing circuit, mounted in the exhaust front pipe at the ca...

Leak Detection Pump - DMTL (Diagnostic Module Tank Leakage) unit for the fuel tank evaporative emission (EVAP) system. The module sits between the...

Brake Disc - Front - ventilated front brake disc for the front brake discs and calipers assembly. The disc measures 380 mm in diameter by 34 mm th...

Oil Cooler Assembly for the 5.0-litre supercharged V8 petrol engine (AJ133). It forms part of the engine lubrication circuit, transferring heat fro...

Brake Disc - Front - ventilated front brake disc for the front brake discs and calipers assembly. The disc measures 380 mm in diameter by 34 mm th...

Cylinder Block Core Plug Seal sealing a core plug aperture in the cylinder block. It seals a casting core plug opening in the block, preventing co...

Wheel Nut Set - Satin Black - set of twenty wheel nuts in a satin black finish, sufficient for four five-stud road wheels. Each nut clamps the roa...

Water Valve - coolant control valve in the auxiliary fuel-fired pre-heater circuit. The valve opens and closes the heater loop against the main en...

Electronic Pressure Control Solenoid for the transfer case control circuit. The solenoid is actuated electrically by the vehicle's control module ...

Front Brake Pad Kit for vehicles built with the size 20 front disc and caliper package, supplied as a front axle set. The pads work in the front c...

Engine Mounting Bracket that connects the engine to its rubber mount on the chassis, part of the powertrain mounting system. It carries the engine...

Relay is a 4-pin electromechanical switching relay used within the vehicle's electrical system. A low-current control signal energises the 12V coi...

Water Pump for the 3.0L supercharged V6 and 5.0L V8 petrol (AJ133) engines. The pump circulates coolant through the engine block, cylinder heads a...

Auxiliary Coolant Pump - an electrically driven pump in the engine cooling system that circulates coolant independently of the belt-driven main wat...

Front Propshaft Flange in the front driveline, coupling the front propeller shaft to the transfer case output on vehicles fitted with a two-speed t...

Oil Cooler, part of the engine lubrication system. It draws heat out of the engine oil to hold oil temperature within its operating range under su...

Transmission Oil Pan and Filter for the ZF 8HP 8-speed automatic transmission (8HP45 and 8HP70, and the later 8HP51/8HP76 variants). The pan bolts...

Starter Motor

Fuel Injector for the 3.0L AJ20D6 Ingenium six-cylinder diesel engine in high-output specification, part of the high-pressure common rail fuel inje...

Brake Vacuum Pump, the auxiliary vacuum source for the brake servo on petrol engines. Petrol engines - particularly direct-injection and superchar...

Radiator is the primary heat exchanger of the Engine Cooling System, transferring heat from the engine coolant to the air drawn through the front c...

Fuel Pump - high-pressure, engine-mounted fuel injection pump within the direct-injection fuel system on petrol engines. Driven off the engine, it...

Fuel Pump - high-pressure, engine-mounted fuel injection pump within the direct-injection fuel system on petrol engines. Driven off the engine, it...

Mass Air Flow (MAF) Sensor for the engine air intake system. Installed in the intake tract downstream of the air filter, the sensor measures the m...

Alternator for the engine charging system. Driven by the auxiliary drive belt, it generates the electrical power that charges the battery and suppl...

Air Suspension Compressor - the compressor unit that supplies pressurised air to the four-corner air suspension system. It draws in and compresses...

Battery - Wet Non-Spillable for the vehicle electrical system. It is a flooded (wet) lead-acid battery of sealed, non-spillable construction. It su...

Fan Assembly

Air Conditioning Compressor - Kit