Range Rover Sport L320 Parts

Fuel Injector Refit Kit - the seals and retainer required when removing and refitting a fuel injector on 3.0L V6 and 5.0L V8 supercharged petrol en...

O-Ring for the variable valve timing (VVT) solenoid. Seals the VVT solenoid where it locates into the cylinder head, retaining oil pressure to the...

Water Outlet Tube carries coolant between the water pump and the thermostat housing within the engine cooling circuit. For 3.0L supercharged V6 an...

Handbrake Shoe Spring Repair Kit - the springs for servicing the rear parking-brake shoe assembly, the drum-in-hat parking brake integrated into th...

Sealing Ring seals the joint between the engine oil cooler and the water pump on the AJ133 5.0L V8 and 3.0L supercharged V6 petrol engines. It mai...

Sealing Ring seals the joint between the engine oil cooler and the water pump on the AJ133 5.0L V8 and 3.0L supercharged V6 petrol engines. It mai...

O-Ring for the oil pump outlet tube, sealing the pressurised feed within the oil pump, sump and filter assembly. The outlet tube carries oil from ...

Idler Pulley is a guide pulley in the auxiliary (accessory) drive belt system of the 2.7L and 3.0L TDV6 diesel engine. Mounted at the front of the...

Oil Level Sensor - electronic engine oil level sensor mounted in the wall of the sump, forming part of the engine lubrication monitoring circuit. ...

Sealing ring kit for the engine oil cooler and oil filter housing connections on the 3.0L V6 diesel. The rings seal the oil transfer joints betwee...

Ball Joint

Oil Level Sensor - electronic engine oil level sensor mounted in the wall of the sump, forming part of the engine lubrication monitoring circuit. ...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Exhaust Gas Temperature Sensor - middle-position sensor in the exhaust after-treatment system. It reports exhaust gas temperature at its point in ...

Crankshaft Position Sensor for engine management, mounted in the lower cylinder block and oil pan area facing the crankshaft reluctor ring. As the...

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

O-Ring for the oil pump outlet tube, sealing the pressurised feed within the oil pump, sump and filter assembly. The outlet tube carries oil from ...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Upper Front Suspension Arm Ball Joint The upper ball joint forms the top pivot between the front upper suspension arm and the wheel knuckle, holdi...

Inlet Manifold Gasket - seals the inlet manifold to the cylinder head on the 5.0L V8 AJ133 naturally aspirated petrol engine. The gasket closes th...

Lambda Sensor - left-hand bank exhaust gas oxygen sensor for the 5.0L AJ133 V8 petrol engine, mounted in the front pipe and catalyst section of the...

Accessory Drive Belt - ribbed serpentine belt for the front-end accessory drive of the 5.0L naturally aspirated V8 petrol engine. Driven from the ...

Upper Front Suspension Arm Ball Joint The upper ball joint forms the top pivot between the front upper suspension arm and the wheel knuckle, holdi...

Accessory Drive Belt - ribbed serpentine belt for the front-end accessory drive of the 5.0L naturally aspirated V8 petrol engine. Driven from the ...

Cylinder Head Gasket seals the joint between the cylinder head and the engine block on the 3.0L V6 turbo diesel engine, containing combustion press...

Exhaust Manifold Gasket - right-hand side seals the exhaust manifold against the cylinder head face on the right-hand bank of the engine. It conta...

Side Repeater Lamp - Front - Exterior Lighting assembly group, direction indicator circuit. Mounted in the front wing panel ahead of the door and ...

Headlight Switch is the dashboard rotary lighting switch mounted in the facia lighting panel. It switches the side, dip and main-beam lighting cir...

Exhaust Gas Temperature Sensor for diesel exhaust aftertreatment, fitted on the right-hand side of the exhaust in the front pipe and catalyst area ...

Exhaust Manifold Gasket - left-hand side seals the exhaust manifold against the cylinder head face on the left-hand bank of the engine. It contain...

Oil Seal for the oil level sensor where it passes through the wall of the oil pan (sump). The sensor is retained in the sump and this ring forms t...

Front Brake Disc - vented - the rotating friction element of the front disc brake assembly. The disc provides the surface the front caliper pads c...

Front Brake Disc - vented - the rotating friction element of the front disc brake assembly. The disc provides the surface the front caliper pads c...

Rear upper suspension arm bush kit - front mounting position in the rear independent suspension arm assembly. The bush locates the forward eye of ...

Cylinder Head Bolt secures the cylinder head to the engine block on V6 and V8 petrol engines. Threaded M11 x 178 mm. Twenty bolts are required per...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...