FRC1644 - Half Shaft – 10/24 Spline – Rear RH Transmission or Drivetrain Part Land Rover Range Rover Defender, Series

FRC1644 - Halve as – 10/24 spievertanding – Rechts achter

- €59,20

€59,20

€59,20 - €59,20

€59,20

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Achteras-as - rechts, 10/24 spline, voor de Series III achteras. Deze as brengt de aandrijving over van het achterdifferentieel naar de achterwielnaaf, met 10 tanden aan het differentieeluiteinde en 24 tanden aan het naafuiteinde.

Van toepassing op 88-inch en 109-inch Series III voertuigen vanaf juli 1980. Per stuk verkocht.

Vehicle Model Land Rover Defender t/m 2016
Land Rover Series 2 en 3

Fitment Notes SERIE II/IIA/III — 88in, vanaf 1980/81
DEFENDER — achteras met 10/24 spiebanen
Eenvoudig type — zonder moer, schroefdraad of borgpen.

Alternative Codes

FRC1644

In stock 2 units

1 · Gouda 1 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the half shaft FRC1644?

The FRC1644 is the rear right-hand half shaft with a 10/24 spline count, ten splines at the differential end and twenty-four at the hub end. It transmits drive from the rear differential to the right rear wheel hub on the Series II/IIA/III axle.

Which side is it and how many do I need?

This is the right-hand rear shaft, sold individually. The opposite side uses the left-hand shaft, FRC1645. If one shaft is worn or sheared, it's common to inspect or replace both sides.

What does 10/24 spline mean and will it fit my axle?

10/24 spline means ten splines at the differential end and twenty-four at the hub end, which distinguishes it from earlier single-spline shafts. It fits Series II/IIA/III (from 1980/81) and Defender axles using the 10/24 spline. Count your splines to confirm.

Is anything else included for fitting?

The shaft is supplied plain, without the hub nut, thread or split pin. Reuse your existing fixings if they're sound, or source the hub nut and split pin separately when fitting.