Products

Flanged Nut - M10 flanged fastener. The integral flange spreads the clamping load over a wider area and resists loosening under vibration, removin...

Flanged Nyloc Nut, M10, a multi-purpose locking fastener used across the chassis and suspension. The nylon insert resists loosening under vibratio...

Hex Nut - M12 - a standard M12 hexagonal nut used as a general-purpose fastener across the vehicle. The six-sided form is tightened with a standar...

Torx Screw - 4.8 × 25mm for use in Land Rover body and trim assemblies. A metric Torx-head screw, 4.8mm diameter × 25mm length, for use where Torx...

Front seat headrest in Techno trim, forming the upper part of the front seat assembly. The headrest locates on its stems into the guide sleeves se...

Front Seat Cushion Repair Kit - the seat base cushion for the front seat frame, supplied in half-leather / half-cloth trim. The cushion is the low...

Oil Seal for the LT230 transfer box input shaft. Part of the transfer box gear train. The seal fits around the rotating input shaft where it enter...

Handbrake Shoe Kit - the retention (hold-down) hardware for the transmission handbrake, which acts on the LT230 transfer box rather than at the roa...

Gear Change Lever Knob for the transfer box gear change lever. The knob fits to the top of the transfer lever and forms the hand grip used to sele...

Low Ratio Detection Switch - the transfer box range-detection switch, mounted on the front housing of the transfer box. It senses whether the tran...

Door Latch Link Clip secures the operating link rod within the door latch and locking assembly. It retains the connecting linkage that transfers m...

Bulkhead Seal for the dash ventilation aperture on Defender models without air conditioning. This rubber seal fits between the dash ventilator ass...

BEZEL - VENT AIR LOUVRE RH Defender Puma 2007 - 2016

Bezel - Vent Air Louvre LH

Fuel Filter Shield is a protective cover fitted over the fuel filter assembly. It mounts over the filter housing and shields the filter body and i...

Heater Control - the heater and air-conditioning control panel mounted in the centre of the dashboard. It carries the rotary controls for cabin te...

Heater Cable is the air distribution control cable for the heater assembly. It connects the heater control on the facia to the air distribution fl...

Heater Blower Motor and Fan Assembly - the powered fan unit of the cabin heating, ventilation and demisting system. The electric motor drives the ...

Heater Hose - outlet pipe from the heater matrix, Td5 2.5L 5-Cylinder Turbo Diesel, left-hand drive (LHD). Returns engine coolant from the heater ...

Hose - Heater Water

Coolant Vent Hose - a small-bore hose in the engine cooling and cabin heater circuit of the 2.4 TDCi Puma diesel. Connected at the heater outlet, ...

Escutcheon

Exhaust Heat Shield - a formed metal shield fitted in the exhaust system area of the underbody. The shield sits between the exhaust and the adjace...

Heater Valve for the cabin heating circuit on Defender Puma diesel models from 2007 onwards. This valve regulates the flow of engine coolant to th...

A/C Switch - facia-mounted switch for the air conditioning system. Fitted in the heater and ventilation control panel of the centre facia, it is t...

Air Conditioning Pipe for the manual air conditioning refrigerant circuit. It carries refrigerant between the receiver dryer and the evaporator, fo...

A/C O-Ring - the front pipe sealing O-ring for the manual air conditioning system. It seals the refrigerant pipe joint on the front line running b...

Clip retains the heater and air-conditioning control cable within the HVAC control assembly, holding the cable on its correct routing.

A/C Compressor O-Ring seals a refrigerant line union at the air conditioning compressor. The O-ring is clamped between the pipe end fitting and th...

Locking Wheel Nut Key engages the matching pattern locking wheel nut so it can be fitted and removed with a wheel brace or socket. This key matche...

Engine Mount - Rubber - Diesel supports the engine on the chassis and isolates it from the vehicle structure. The bonded rubber element absorbs co...

Heat Shield - Engine Mount for the Puma diesel engine mounting assembly. This shield mounts over the engine mount rubber to protect it from heat a...