Products

End Cap

Blanking Plug for the front bumper assembly. Closes an unused aperture at the centre of the front bumper. Black.

Blanking Plug Fills the headlamp washer jet aperture in the front bumper on vehicles not fitted with headlamp washers. It presses into the moulded ...

Rear Panel Applique - the exterior finisher panel that fits across the rear door, incorporating the licence plate bracket and covering the rear doo...

Wheel Centre Cap for steel road wheels, finished in black. Fits over the wheel centre and covers the wheel nuts. Supplied individually; four are r...

Clip for the headlamp washer system. Retains the headlamp washer jet to the bumper.

Rear Bumper Bracket Clip - a plastic retaining clip used in the rear bumper assembly to secure the bumper bracket to the body. It locates the brac...

Trim Clip (Scrivet) is a two-piece plastic push-fit fastener used to secure trim panels, facia sections, splash shields and other clipped-in compon...

Scrivet A two-piece plastic push-rivet fastener used on the rear bumper assembly. The body pushes into the panel hole and a central pin drives home...

Turnbuckle - a turn fastener that secures the battery cover within the battery tray assembly. It clamps the cover down over the battery and engage...

Wiper Hole Blanking Plug - Plenum Air-Take Extension for the Discovery 2 (L318). This rubber blanking plug seals an unused aperture in the plenum ...

Sunroof Finisher - perimeter seal trim section for the manual slide sunroof assembly on the Discovery II. The component forms the finishing strip ...

Sun Visor Retainer Clip – the moulded clip the free end of the front sun visor locates into when it is folded up against the headlining. It fits t...

Valve Stem Seal for the Rover V8 engine, part of the cylinder head valve train. The seal fits over the top of the valve stem where it passes throu...

Oil Pump Gasket for the Rover V8 petrol engine lubrication system. This gasket seals the oil pump to its mating face, maintaining oil pressure and...

Crankshaft Oil Seal - Rear seals the rear of the crankshaft where it leaves the cylinder block at the flywheel end, retaining oil within the bottom...

Key - Mainshaft

Crankshaft Timing Chain Sprocket The drive sprocket mounted on the nose of the crankshaft within the timing chain drive of the Rover V8 petrol engi...

Oil Filter for Land Rover petrol and diesel engines, part of the engine lubrication circuit. This screw-on canister filter threads onto the filter...

Camshaft for the Rover V8 EFI petrol engine (3.9L, 4.0L and 4.6L variants). Mounted centrally in the cylinder block, the camshaft is driven from t...

O-ring

Cooling Fan for the engine cooling circuit, driven from the water pump pulley and drawing air through the radiator core. The viscous coupling (fan...

Camshaft for the valvetrain of the 4.0/4.6L V8 petrol engine. Mounted in the cylinder block and driven from the crankshaft, the camshaft lobes act...

Cylinder Head Bolt securing the cylinder head to the cylinder block and clamping the head gasket joint. It maintains the clamping force that seals...

Crankshaft Oil Seal - Front seals the nose of the crankshaft where it passes through the timing cover on the Td5 2.5L 5-cylinder turbo diesel engin...

Oil Filter Rotor is the rotating element of the centrifugal oil filter on the Td5 2.5L 5-cylinder turbo diesel engine. Mounted within the centrifu...

Injector Sealing Washer seals the base of the fuel injector into the cylinder head on the Td5 2.5L 5-cylinder turbo diesel engine. The washer sits...

Seal - Oil Pump

Drive Belt Idler Pulley for the auxiliary (accessory) belt drive of the Td5 2.5L 5-cylinder turbo diesel engine. The pulley mounts above the water...

Flywheel Bolt for the 2.5L Td5 five-cylinder diesel engine with manual gearbox. This bolt secures the flywheel to the rear flange of the crankshaft...

Engine Plug - a cylinder head core plug (welch plug) for the Td5 2.5L 5-cylinder turbo diesel engine. Core plugs seal the casting holes left in th...

Exhaust Manifold Bolt for the Rover V8 petrol engine, threaded 3/8" UNC and 1 1/8" long. The bolt secures the exhaust manifold to the cylinder hea...

Exhaust Manifold Bolt for the Rover V8 petrol engine, threaded 3/8" UNC and 1 1/8" long. The bolt secures the exhaust manifold to the cylinder hea...

Timing Belt Tensioner for the 2.5L Td5 5-Cylinder Turbo Diesel engine timing system. The tensioner pulley bears directly against the timing belt a...

Injector O-Ring for the 2.5L Td5 5-Cylinder Turbo Diesel fuel injection system. This O-ring seats in the groove on the injector body at the cylind...

Cam Cover Gasket for the 2.5L Td5 5-Cylinder Turbo Diesel engine. This gasket seals the camshaft cover to the top of the cylinder head, preventing...

Grommet is a sealing grommet fitted to the engine oil sump on V8 petrol engines. It seals the point where a tube or fitting passes through the sum...

Grommet is a sealing grommet fitted to the engine oil sump on V8 petrol engines. It seals the point where a tube or fitting passes through the sum...

Camshaft Cover Grommet sealing the camshaft cover to the cylinder head on the Td5 2.5L five-cylinder turbo diesel engine. The grommet forms a stat...