Products

Rear Bumper Reflector for the right-hand position of the rear bumper. This passive retroreflector fits into the designated aperture in the rear bu...

Rear Bumper Reflector, left-hand side - a passive (non-illuminated) retroreflector set into the rear bumper. It reflects the headlamps of followin...

High-Level Stop Lamp - the centre high-mounted stop lamp (CHMSL), positioned above the rear screen. It operates with the brake lighting circuit to...

High-Mounted Rear Stop Lamp - the centre high-mounted stop lamp, commonly called the third brake light, within the rear lighting system. Mounted c...

Rear Lamp Gasket - the sealing gasket fitted between the rear lamp assembly and the rear body panel. It seals the lamp against the bodywork, preve...

Number Plate Lamp Lens - clear lens for the rear licence plate lamp mounted in the luggage compartment door. The lens clips into the lamp housing ...

Bulb Holder - double-pole bulb holder for the rear stop and tail lamp. It carries the twin-filament stop/tail bulb and locates by bayonet fitting ...

Bulb Holder - right-hand rear lamp bulb carrier, forming the electrical backplate of the rear lamp assembly. The carrier clips into the back of th...

Bulb Holder - left-hand rear lamp bulb carrier, forming the electrical backplate of the rear lamp assembly. The carrier clips into the back of the...

Side Repeater Lamp - side direction indicator repeater with a clear lens, part of the exterior lighting system. Mounted in the front wing panel ah...

Stop Light Switch mounts on the brake pedal bracket and controls the stop lamp circuit. When the pedal is depressed the switch closes its contacts...

Brake Light Switch, the stop lamp switch mounted at the brake pedal. When the brake pedal is depressed the switch closes the stop lamp circuit to ...

Brake Light Switch - pedal-mounted stop lamp switch, located on the brake pedal box assembly. The switch mounts on the pedal bracket and is actuat...

Brake Light Switch for the braking and signalling circuit. Mounted at the brake pedal assembly, this switch closes when the pedal is depressed, co...

Tweeter is the high-frequency loudspeaker mounted in the A-post trim, part of the Harman Kardon eleven-speaker audio system. Positioned at the bas...

Antenna Amplifier for the aerial system, operating at 433 MHz. The amplifier boosts the 433 MHz radio-frequency signal between the antenna and the...

Blanking Plate - moulded plug that closes an unused switch aperture in the facia or switch console. Where a vehicle is built without an optional s...

Hexagon Nut for use in electrical system assemblies.

Retainer Clip for the headlamp and front end carrier assembly, quarter-turn type. The clip locks with a quarter turn to secure the headlamp and fr...

Headlamp Mounting Retainer for the front lighting assembly. This cupsac retainer secures the headlamp unit in its mounting position within the fro...

Front Flasher Bulb for the front direction indicator lamp, wedge base. The bulb provides the front turn-signal (flasher) illumination.

Dual - Bulb

Bulb Holder A black bulb holder that retains a bulb and connects it into the lighting circuit. Used in the instrument panel and interior trim ligh...

Bulb and holder GENUINE LR Discovery 2: for instrument cluster

Bulb & Holder - Main Instrument Panel for the Discovery 2 instrument cluster illumination circuit. This bulb and holder assembly fits into the...

Bulb and holder GENUINE LR - D2 instrument panel - main beam

Heater Control Label - replacement decal for the heater control panel. Fits within the HVAC control assembly and provides the printed markings ind...

Speed Sensor for the transfer gearbox speedometer drive. This 2-pin inductive sensor reads a toothed reluctor on the transfer box output, generatin...

Speed Sensor for the transfer gearbox speedometer drive. This 2-pin inductive sensor reads a toothed reluctor on the transfer box output, generatin...

Aid Parking Sensor

Parking Aid Sensor - ultrasonic transducer for the Parking Distance Control (PDC) system, mounted through the rear bumper cover. Straight-bodied ty...

Horn

Alternator Assembly - Freelander TD4

Valve Body Connector is the electrical connector that interfaces the transmission wiring harness with the valve body of the ZF 5HP24 five-speed aut...

Transfer Box Switch Wire Adaptor for the LT230 transfer gearbox. This short harness link connects the main vehicle wiring loom to the switch on th...