Products

Washer Reservoir Cap closes the filler neck of the windscreen washer reservoir. It seals the reservoir to retain washer fluid and keep dirt and deb...

Valve assy

Washer Jet Tube Tee Piece - a T-shaped connector in the windscreen washer system. The tee piece connects into the small-bore washer tubing, joinin...

Jet - Windshield Washer

Windscreen Washer Jet A heated twin-nozzle washer jet that directs washer fluid onto the windscreen. It seats into the scuttle or bonnet panel and ...

Tube Wiper

Grapa

Tube

End Cap

Front Bumper End Cap - Outer, installed at the outer section of the front bumper assembly. This component forms part of the Front Bumper & Bum...

Blanking Plug for the front bumper assembly. Closes an unused aperture at the centre of the front bumper. Black.

Blanking Plug Fills the headlamp washer jet aperture in the front bumper on vehicles not fitted with headlamp washers. It presses into the moulded ...

Towing Hook Cover for the rear bumper. The cover fits over the rear bumper towing eye aperture to complete the bumper face and is retained by two ...

Rear Panel Applique - the exterior finisher panel that fits across the rear door, incorporating the licence plate bracket and covering the rear doo...

Wheel Centre Cap for steel road wheels, finished in black. Fits over the wheel centre and covers the wheel nuts. Supplied individually; four are r...

Fog Lamp Bezel - right-hand side. This exterior trim surround frames the front fog lamp where it sits in the front bumper, finishing the aperture a...

Fog Lamp Bezel - Anthracite - LH

Clip for the headlamp washer system. Retains the headlamp washer jet to the bumper.

Finisher Clip - a retaining clip for exterior body finishers and mouldings. The clip secures a trim finisher or moulding to the body panel, engagi...

Rear Bumper Bracket Clip - a plastic retaining clip used in the rear bumper assembly to secure the bumper bracket to the body. It locates the brac...

Clip retaining rear body mouldings to the body, including the rear wheel arch moulding and front door cladding. A push-in plastic clip; sold indiv...

Blind Anchor Nut - a threaded anchor nut that provides a captive fixing point where the reverse side of the panel is inaccessible. It is used in t...

Self-Tapping Screw - a fastener that cuts its own thread as it is driven, used in the luggage compartment door finisher and trim assembly. It secu...

Torx Pan-Head Screw, M5 x 25. Secures the radiator grille and rear end door casing trim.

Hex-Head Bolt with Washer, M4 x 14. Fastener used in the front end carrier assembly, securing the front panels, aprons and side members.

Trim Clip (Scrivet) is a two-piece plastic push-fit fastener used to secure trim panels, facia sections, splash shields and other clipped-in compon...

Scrivet A two-piece plastic push-rivet fastener used on the rear bumper assembly. The body pushes into the panel hole and a central pin drives home...

Stud

Trim Clip is an interior trim fixing that retains the A-pillar trim panel against the body structure. Depending on application it also serves as t...

Turnbuckle - a turn fastener that secures the battery cover within the battery tray assembly. It clamps the cover down over the battery and engage...