Products

Rocker Cover Gasket sealing the inlet rocker cover to the cylinder head on the 2.0L petrol IOE (Inlet Over Exhaust) engine. Fitted between the upp...

Brake Lining - Rear is a replacement friction lining for the rear drum brake assembly on long-wheelbase Land Rover models, covering 109-inch, 110-i...

Heater hose SII IIA Genuine

Distance piece

Top cover

Rocker Shaft for the 2.6L six-cylinder petrol engine, part of the valvetrain in the cylinder head. The shaft mounts on the head and carries the ro...

Camshaft for the Land Rover 2.25L four-cylinder diesel engine, early specification (up to engine number 36619420B), and also applicable to the 2.0L...

Cable Grommet for the wiring loom, fitting a 41.5 mm panel hole and accepting a cable of up to 6 mm. Made of black rubber, it lines the hole where...

Inlet Air Seal for the Solex carburettor connection on the 2.25L 4-cylinder petrol induction system. Seals the joint between the air intake and th...

Genuine Accelerator Lever 1964-83.

Special Bolt with a coarse ACME-form thread, 1/4 in diameter and 5/8 in long. It is a body fixing used to secure inner-wing mudshields, floor plat...

Rear End Door T-Handle and Lock Assembly for the upper tailgate on hard top body configurations. The handle operates the latch mechanism to release...

Washer

Rear Mudflaps - a pair of rear mudflaps for the 88in short-wheelbase, fitted behind the rear wheels to deflect road spray and debris thrown up by t...

Interior Lamp Lens for the interior courtesy lamp. The translucent lens clips over the lamp body, protecting the bulb and diffusing its light into...

Plain Washer - 7/16" used in the power steering box assembly. This flat washer is used within the steering hydraulic assembly at the power steerin...

Cab Mounting Stud

Rubber Plug Cushion is a moulded rubber blanking plug that fits into a pre-formed aperture in the body, frame or seat base to close off the opening...

Floor Mat for the second seat row, a ribbed rubber mat protecting the intermediate floor area. Approximate dimensions 1490 x 460 x 3 mm.

Female Dovetail for the rear end door latch mechanism. Receives the male dovetail to align and secure the rear door as it closes. Sold individually.

Spacer

Filler Strip is the fixing channel that runs along the top edge of the rear door window aperture. It locates and retains the upper edge of the doo...

Clip - a retaining clip within the vehicle body hardware, used to secure and locate a fitted component in position.

Centre Retainer - Front Windscreen Glass is the metal retainer strip that secures the front windscreen glass at its centre division point. The ret...

Rear Sill for the left-hand side, in the high cab body configuration. The sill is the structural panel running along the lower edge of the body be...

Blanking Plug - a push-fit plug used to close an unused aperture in a body panel, door or interior trim component. It seals the opening against wa...

Blanking Plug for closing an unused 13 mm (1/2") hole in body or trim panelling. A push-in plastic plug used to blank off redundant or open apertu...

Grommet / Blanking Plug - Dash Bulkhead for Land Rover Defender. This rubber plug seals an unused aperture in the dash bulkhead (such as a heater ...

Grommet - Blanking Plug, Gearbox Tunnel for Land Rover Series II and III. This small rubber blanking plug fits into an aperture in the top of the ...

Rubber Washer - Seat Backrest for Land Rover Series and Defender models. This rubber washer is used in the seat backrest assembly, fitting beneath...

Hook

Seal is a rubber weather seal that fits between the top of the door and the windscreen frame. It closes the gap along the upper door-to-windscreen...

Retainer - LH

Hose Clip Spring is the spring connector clip for the heater demister and air outlet pipes. Retains the demister ducting and outlet flaps within t...

Spare Wheel Bracket is the mounting bracket for a side-mounted spare wheel. Forms part of the side spare wheel carrier, working with the anchor pl...

Heater Control Mounting Plate for left-hand drive applications. Fitted within the heater control assembly in the cab interior, this plate provides ...

Shim door GENUINE - door striker plate 1958 - 1984 - side hinged tailgate

Grille Spring Clip for securing the front grille panel on Series III models. Fitted at the grille mounting points, this spring clip retains the fro...