Products

Front Seat Cushion Repair Kit - the seat base cushion for the front seat frame, supplied in half-leather / half-cloth trim. The cushion is the low...

Seat Cushion Pad is the moulded foam cushion forming the seating base of the front seat, sitting on the seat frame beneath the trim cover. It rest...

Front Seat Armrest Finisher, the decorative trim panel forming the visible outer surface of the front seat armrest on the Discovery 2. Applies to ...

Seat Back Adjustment Handle - the operating handle for the front seat backrest recline mechanism, mounted on the outboard side of the seat frame. ...

Seat Adjuster Handwheel Cap - the trim cap fitted over the manual recline hand wheel on the front seat. It covers the centre of the rotary recline...

bushes needed to machine the Series LT76 transfer case for the High Ratio Gear Set (HGRS.)

Rear Seat Back Adjusting Handle - the release lever on the rear seat frame assembly. The handle operates the seat back latch, releasing the backre...

Cover - Seat Back Hinge

Drive Fastener - black plastic drive-in retaining clip used to secure body mouldings, trim panels and interior finishers to their mounting panels. ...

Fastener used to secure interior door casing panels and body side trim. Retains door casing and rear body panel trim on applicable vehicles.

Oil Seal for the LT230 transfer box input shaft. Part of the transfer box gear train. The seal fits around the rotating input shaft where it enter...

Handbrake Shoe Kit - the retention (hold-down) hardware for the transmission handbrake, which acts on the LT230 transfer box rather than at the roa...

Gear Change Lever Knob for the transfer box gear change lever. The knob fits to the top of the transfer lever and forms the hand grip used to sele...

Low Ratio Detection Switch - the transfer box range-detection switch, mounted on the front housing of the transfer box. It senses whether the tran...

A-Pillar Trim Clip A retaining clip used in the interior A-pillar trim assembly. It secures the A-pillar trim panel to the body structure alongsid...

A-Pillar Trim Clip A retaining clip used in the interior A-pillar trim assembly. It secures the A-pillar trim panel to the body structure alongsid...

Trim Clip retains interior trim panels against the body. The clip pushes into a pre-formed aperture in the body panel and holds the trim in place ...

Door Latch Link Clip secures the operating link rod within the door latch and locking assembly. It retains the connecting linkage that transfers m...

Oil Drain Plug Gasket for the transfer case drain plug. Sealing washer fitted between the drain plug and the transfer case to prevent oil leaks.

O-Ring and Grease Kit for servicing the transfer box input shaft. Contains the input shaft O-ring and the anti-seize grease used when resealing th...

Oil Seal for the transfer case input shaft. Seals the input shaft where it enters the transfer case, retaining lubricant and excluding contaminant...

Transfer Case Output Shaft Oil Seal seals the output shaft where it exits the transfer case housing. It runs against the rotating shaft to retain t...

Bulkhead Seal for the dash ventilation aperture on Defender models without air conditioning. This rubber seal fits between the dash ventilator ass...

Air Intake Plenum Extension Moulding in black, the moulded panel that sits in the scuttle area between the rear edge of the bonnet and the base of ...

BEZEL - VENT AIR LOUVRE RH Defender Puma 2007 - 2016

Bezel - Vent Air Louvre LH

Fuel Filter Shield is a protective cover fitted over the fuel filter assembly. It mounts over the filter housing and shields the filter body and i...

Heater Control - the heater and air-conditioning control panel mounted in the centre of the dashboard. It carries the rotary controls for cabin te...

Heater Cable is the air distribution control cable for the heater assembly. It connects the heater control on the facia to the air distribution fl...

Heater Blower Motor and Fan Assembly - the powered fan unit of the cabin heating, ventilation and demisting system. The electric motor drives the ...

Blower Motor Resistor Pack - speed control for the heater and air conditioning blower motor, also referred to as the air conditioning switch. The ...

Hose GENUINER LR

Hose

Heater Hose - outlet pipe from the heater matrix, Td5 2.5L 5-Cylinder Turbo Diesel, left-hand drive (LHD). Returns engine coolant from the heater ...

Hose - Heater Water