Products

Heat Shield - Engine Mount for the Puma diesel engine mounting assembly. This shield mounts over the engine mount rubber to protect it from heat a...

Tow Hook Protective Cap is a cover for the towing eye aperture in the bumper. It closes off the tow hook mounting point when not in use, keeping o...

Lockable Retainer Handle for the detachable tow bar system. It secures and locks the removable tow bar neck into the receiver, and is supplied wit...

Lockable Tow Ball Handle Assembly for the detachable tow ball system. It locks the removable tow ball into the receiver to secure it against remov...

Gearbox Mount Assembly is the transmission mounting that supports the rear of the gearbox on the gearbox crossmember. It carries the weight of the...

Differential Insulator - rubber mounting bush used in the differential mounting arrangement, on both the front axle case and the rear axle. It iso...

Front Differential Bush Mounting bush that locates and supports the front differential within the axle case. The bush isolates the differential fr...

Front Differential Bush Mounting bush that locates and supports the front differential within the axle case. The bush isolates the differential fr...

Undertray Kit - Side Centre

Rear Crossmember is the rearmost transverse member of the vehicle chassis, closing and tying together the two main longitudinal chassis rails at th...

Body Mount Bracket - chassis-frame bracket forming part of the body mounting arrangement between the body and the chassis frame. The bracket is fi...

Rear Step Assembly – Retractable, a folding step mounted at the rear body to give a low-height step for access to the load area and roof. It compr...

Bracket

Bracket KVU100220

Bracket - Support Galvanised

Plain Washer

Screw and Washer - Hex Head

Bolt - M10 x 25 mm, with washer. Underbody and chassis fixing used to secure engine splash shields, heat shields and underbody protection panels t...

Plastic Nut used in the body panel assembly to secure inner side panels, front panels and related trim. Receives a fastener to retain the panel, r...

Cylinder Head Installation Kit for the Td5 2.5 five-cylinder turbo diesel. It supplies the fitting components used when installing the cylinder he...

Cylinder Head Dowel - Plastic is a locating pin fitted at the mating face between the cylinder block and cylinder head in the Td5 2.5L 5-cylinder t...

Front Camshaft Oil Seal for the Td5 2.5L 5-Cylinder Turbo Diesel engine, fitted at the timing end of the camshaft within the cylinder head. Seated...

Cylinder Block Cover - Water Jacket - coolant galley cover for the M62 4.4L V8 petrol engine. Sits in the engine valley between the two cylinder b...

O-Ring Seal for the cylinder head cover on the AJ-V8 4.4L petrol and 4.2L supercharged petrol engines. The seal locates in the groove of the cylin...

Cylinder Head Bolt Kit is a complete set of the bolts that clamp the cylinder head to the engine block. The kit comprises 14 Torx-drive cylinder h...

Crankshaft Main Thrust Bearing controls the axial, fore-and-aft movement of the crankshaft within the cylinder block. It sets crankshaft end-float ...

Camshaft Bearing for the KV6 2.5L V6 petrol engine. It supports the camshaft in the cylinder head, providing the running surface on which the camsh...

Bearing - Camshaft LEB10121010L

Bearing - Camshaft LEB10121030L

Bearing - Connecting LFB10179010L

Big End Bearing - a connecting-rod (big-end) bearing shell for the 2.5L KV6 petrol engine. Fits between the connecting rod and the crankshaft jour...

Crankshaft Spigot Bush is the clutch pilot bush that presses into the rear face of the crankshaft, between the engine and the clutch. It supports ...