Products

Fixing Screw for the front door hinge and check strap assembly. This screw secures the door hinge and the check strap (door-stay) to the body pill...

Front Fender Panel - RH is the right-hand front wing panel, the outer body panel covering the front wheel arch and forming the side of the front bo...

Front Panel - TD5 - LH

Differential Pinion Bearing is the outer taper roller bearing on the differential pinion shaft. It locates the pinion within the differential carr...

Fuel Pump Joint Washer Sealing washer for the mechanical fuel pump mounting on the 2.6 litre 6-cylinder petrol engine. The washer fits between the...

Electric Fuel Pump - an SU-type electric fuel pump in the low-pressure fuel delivery circuit. It draws petrol from the tank and delivers it to the...

Idle Adjusting Needle is the mixture-adjusting needle for the Zenith Stromberg CD175 constant-depression carburettor fitted to the Rover 3.5 V8. I...

Ignition Lead Set for the 1.8L K Series four-cylinder petrol engine - the high-tension (HT) leads that carry the ignition voltage from the coil to ...

Decal is an adhesive exterior body decal displaying the "4.0 SE" designation, approximately 13 cm wide. Part of the exterior badging, it is applie...

Receiver Dryer is a component of the air-conditioning refrigerant circuit. Installed in the high-pressure liquid line between the condenser and th...

Air Conditioning Compressor for the refrigerant circuit on 2.0L diesel applications fitted with air conditioning. Belt-driven from the engine, the...

A-Post Windscreen Finisher trim for the right-hand A-pillar, fitted along the outer edge of the windscreen aperture. The finisher covers the A-pos...

A-Post Windscreen Finisher trim for the left-hand A-pillar, fitted along the outer edge of the windscreen aperture. The finisher covers the A-post...

Top Windscreen Finisher trim fitted across the upper edge of the windscreen aperture, along the roof header. The finisher covers the seam where th...

Fastener is a fixing used to secure exterior body trim and finisher panels to the bodywork. It retains trim components such as plinths and finishe...

Rear Bumper End Cap finishes the left-hand outer end of the rear bumper assembly. The end cap closes off the corner of the bumper where it wraps t...

Front Bumper End Cap for the left-hand side, part of the front bumper assembly. Moulded cap that fits over the outer LH end of the front bumper, c...

Front Bumper End Cap finishes the right-hand outer end of the front bumper assembly. The end cap closes off the corner of the bumper where it wrap...

Wiper Blade for the rear screen wash/wipe system. Fits the rear wiper arm and sweeps the tailgate glass, operating with the rear wiper motor and w...

Protective Strip is the body rubbing strip that runs along the rear door, shielding the panel from minor knocks and parking scuffs. It clips to th...

Exterior Door Mirror is the left-hand mirror assembly mounted to the door at the A-pillar. The housing carries electrically adjustable glass with ...

Bumper Mounting Bobbin is a mounting bobbin for the front bumper. It sits between the bumper and its mounting bracket, locating the front bumper a...

Gear Lever Gaiter for the manual transmission gear shift assembly. It fits over the base of the gear lever where it passes through the transmission...

Seat Cushion Cover for the front seat, forming the outer covering over the seat base cushion - the part of the seat you sit on. It replaces a worn,...

Seat Squab Cover for the front seat backrest (squab), forming the outer covering over the backrest cushion. It replaces a worn, torn or faded origi...