Land Rover Freelander Parts

Cigar Lighter Base - the socket housing for the cigar lighter and 12V auxiliary power point. It mounts in the instrument panel or floor console and...

Auxiliary Drive Belt for the 3.2L inline-six petrol engine. Driven from the crankshaft pulley, it turns the engine's belt-driven ancillaries and is...

Power Steering Fluid, 1 litre. Synthetic hydraulic fluid for the power-assisted steering system, meeting the CHF 202 / WSS-M2C204-A2 specification...

Fuel Tank Vent Reservoir for the evaporative emission control (EVAP) system on petrol models. It collects and stores fuel vapour drawn from the fue...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Driveshaft Oil Seal - Inner - Front LH is fitted to the front axle case (final drive housing) and seals around the inner end of the left-hand front...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Oil Seal - Differential Flange - Front seals the front differential where the drive flange exits the axle case. It runs against the differential o...

Cylinder Head Gasket for the 2.0L 16V TiVCT turbocharged petrol engine, sealing the joint between the cylinder head and the engine block. It conta...

Transmission Oil - Hypoid is a hypoid gear oil for the Power Transfer Unit (PTU) / transfer box. It lubricates the hypoid gearset that sends drive...

Oil Level Plug is the threaded oil level indicator plug for the 6-speed AWF21 automatic gearbox. Removed to check and set the transmission fluid l...

Bolt and Washer is a hex-head bolt with washer for the cylinder block. Used at the cylinder block and its plugs on the 2.2L diesel engine.

Pin is a push-in retaining clip for exterior body trim. It secures side trim panels and body mouldings to the body, holding the trim seated at its...

Manifold Absolute Pressure (MAP) Sensor fitted to the intake manifold of the 3.2L DOHC MPI I6 petrol engine. It measures the absolute pressure ins...

Fuel Return Pipe (Injector Leak-Off) in the fuel injection return circuit of the 2.2L diesel engine. The pipe collects leak-off fuel from the inje...

Switch - Solenoid Control is a solenoid control switch located on the cylinder head of the 3.2L inline-six petrol engine. Two are fitted per engine.

Cylinder Block Front Cover - crankshaft front cover for the cylinder block on the 3.2L DOHC MPI petrol inline-six. The cover closes off the front ...

Parking brake operating lever (shoe expander) for the rear drum-in-disc parking brake assembly. The lever is mounted to the parking brake shoe and...

Radiator Hose - upper radiator hose in the engine cooling circuit. Connects the engine coolant outlet to the top inlet of the radiator, forming th...

Rear suspension bump stop - part of the rear damper and coil spring assembly. The moulded rubber bump stop fits over the shock absorber piston rod...

Indicator Bulb - PY21W amber signal bulb, 12V 21W, fitted to the direction indicator lamp units. The amber envelope provides the signal colour req...

Hex-Head Bolt and Washer - bolt and washer assembly used in the front suspension and subframe area. The fastener secures front cross member, stabi...

Power Steering Pressure Hose within the power steering hydraulic circuit. It carries pressurised fluid from the power steering pump to the steering...

Number Plate Lamp - With Bulb is the rear licence plate illumination unit within the rear lighting circuit. It sits in the rear number plate surro...

Exterior mirror motor - left-hand side glass adjustment motor within the door mirror head. The motor sits behind the mirror glass and drives the g...

Transmission Extension Housing which bolts to the rear of the transmission and encloses the output shaft. It provides the mounting point at the re...

Bolt - M10 x 25 mm, with washer. Underbody and chassis fixing used to secure engine splash shields, heat shields and underbody protection panels t...

Radiator Hose for the engine cooling system. It carries coolant between the engine and the radiator, forming part of the circuit that dissipates en...

Shock Absorber Bracket - a mounting bracket for the rear shock absorber (damper) in the rear suspension. Locates the damper at its body mounting p...

Engine Mounting (support bracket / insulator) for the 3.2L Si6 petrol inline-six engine, part of the powertrain mounting system. It carries engine ...

EGR Cooler Repair Kit

Bolt Mounting bolt for the power steering pump and front cover housing, and for air conditioning compressor and condenser mountings.

Timing Belt Tensioner

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Engine Mounting supports the engine on the subframe and damps vibration transmitted into the body. Fitted to the 2.0L 16V TiVCT turbocharged petro...

Crankshaft Position Sensor - engine management sensor located at the crankshaft, reading a toothed reluctor ring driven by the crankshaft. The sen...

Water Pump is part of the engine cooling system. It circulates coolant through the cylinder block, cylinder head and radiator to carry heat away f...

Water Outlet Adaptor for the engine cooling circuit of the 2.0L turbocharged petrol engine (TIVCT). The adaptor forms the coolant outlet on the en...

Vehicle Battery - the 12 V starter battery in the Battery and Mountings assembly. Supplies cranking current to the starter motor and stabilises th...

Water Pump for the 3.2L DOHC petrol inline-six - the circulating pump of the engine cooling system. The pump draws coolant from the radiator outle...