Products

Quarter Light is the rear quarter window glass for the left-hand (LH) side. The glass fits the fixed rear quarter aperture in the body side behind...

Rear Window Glass for the rear body aperture, in clear glass. It glazes the rear window opening, fitting into the surrounding rubber seal. This is...

Rear Door Glass for the rear door aperture, 4mm heated glass. It glazes the rear door opening, seating into the surrounding rubber seal. The heate...

Rear Quarter Glass is a fixed side glazing panel that sits in the rear body quarter, forming the glazed opening behind the rear side door. It loca...

Front Door Glass Assembly is the front door window glass, supplied as a 4mm clear glass pane. It fits into the front door as part of the door glaz...

Front Door Glass in green-tinted, 4 mm toughened safety glass. The glass locates within the front door frame and forms the openable side window of...

Glazing rubber for the window lift channel, from the front door glass and regulator assembly. The rubber lines the U-section lift channel that the...

Outer Door Handle Cover is the right-hand exterior finger pull fitted to the top of the door, part of the sliding side-window door top assembly. I...

Door Lock Link - LH is the actuation link rod within the push-button door lock mechanism of the Defender 90 and 110. The rod connects the exterior...

Front door channel assy RH

Front door channel assy LH

Seat Outer Base - Grey is the lower seating surface unit for the outboard seat position on the Defender, trimmed in grey vinyl. The base mounts to...

Rubber Buffer moulded door stop pad fitted within the door check and hinge mechanism. The buffer cushions the door against its check arm and limit...

Fir Tree Fastener push-in fixing used to retain body trim and exterior panels against the bodywork. The tapered fir-tree shank pushes into a pre-d...

Rear door sill seal RH

Door Sill Seal rubber weatherseal for the lower edge of the rear side door aperture, left-hand side. The seal runs along the sill of the door fram...

P-shaped sill seal, 1983 - 1994

Bump stop

Glazing Rubber is fitted within the side window assembly to secure and seal a fixed window glass to the body aperture. It retains the glazing pane...

Felt Pad used in the sliding side window assembly of the Defender Hard Top cab body. The pad sits at the rear cab panel, cushioning the sliding wi...

Seat Recline Mechanism Cover - RH is the trim cover plate fitted over the front seat recline adjuster mechanism. It conceals and protects the recl...

Sliding Window Catch for the side-opening cab window glazing. This right-hand catch assembly latches the sliding side window in the closed positio...

Facia Panel Assembly - LHD is the end closing trim for the upper dashboard fascia on left-hand drive Defender 90 and 110, finished in black. This ...

Fir Tree Fastener in light grey, for the roof trim and headlining assembly. Push-fit fastener that secures roof trim panels and headlining ancilla...

Plastic Rivet in black, a push-in fastener for door cards, interior trim panels and wheelarch eyebrow trims. Locates through a pre-drilled hole an...

Door Torsion Bar is the spring element within the rear end door check mechanism on the Defender. The torsion bar provides the resistive force that...

Seatbelt Anchorage - Upper - RH for the Defender seatbelt system. This structural bracket mounts to the pillar or roof structure at the top of the...

Seatbelt Anchorage - Upper - LH for the Defender seatbelt system. This structural bracket mounts to the pillar or roof structure at the top of the...

Heater Inlet Hose is a moulded coolant hose in the cabin heater circuit of the 200TDi 2.5L turbo diesel engine. It carries hot coolant from the en...

Spare Wheel Clamp Plate for the Defender underbody spare wheel carrier assembly. This steel plate forms part of the underfloor spare wheel mountin...

Rear Seat Belt Buckle for the rear occupant restraint system. This is the receiving buckle stalk into which the seat belt tongue latches, securing...

Glass Channel for the fixed quarter light in the rear side door, retaining the 4mm glass panel within the door frame.

Window Channel top run channel for the front door glass, fitted within the door frame aperture. The channel lines the upper edge of the window ope...

Channel fitted to the top of the Defender rear side door frame, guiding and retaining the upper edge of the main drop glass as it operates.

Drain Channel - Rear Side Door installed vertically within the rear side door frame, channelling water away from the fixed quarter light aperture a...

Channel fitted to the top of the rear side door frame, retaining and sealing the upper edge of the fixed quarter light glass. Designed for 4mm glas...

Door Glass Drain Channel vertical run channel at the rear edge of the front door glass aperture. The channel guides the door glass along its rear ...

Vertical Drain Channel is a body-side glazing channel fitted to the rear side door. It runs vertically within the door frame to guide the edge of ...

Rear Mudflap in the right-hand fitment, mounted behind the rear wheel to deflect road spray, mud and stones thrown up by the tyre. It protects the...

Rear Mudflap in the left-hand fitment, mounted behind the rear wheel to deflect road spray, mud and stones thrown up by the tyre. It protects the ...

Door Lock Handle exterior front door handle for the left-hand side, part of the door latch and locking mechanism. The handle mounts on the outer d...

Door Lock Handle (RH) is the exterior handle for the right-hand front door, operating within the door latch and locking assembly. The handle mount...

Windscreen Hinge - left-hand - for the Defender fold-flat windscreen assembly. This hinge forms one of two pivot points at the lower edge of the w...

Door Hinge - right-hand door hinge that mounts the side door to the body hinge pillar and carries the door as it swings. Steel hinge for the front...

Door Hinge - left-hand door hinge that mounts the side door to the body hinge pillar and carries the door as it swings. Steel hinge for the front ...

hinge front door RH upper with holes for mirror arm "smaller" version for Series 3 and early classic Defender upto (VIN) WA138479 (1998 model year)