Products

Blanking Plug for the cylinder block of the Td5 2.5L 5-cylinder turbo diesel engine. The plug closes a machined aperture in the cylinder block cas...

Cylinder Head Amc Early Type to 1a622423 - TD5

Cylinder Head Assembly for the Td5 2.5L 5-cylinder turbo diesel engine, supplied complete with the valves and valve springs already assembled. The...

Cylinder Head for the Td5 2.5L 5-cylinder turbo diesel engine, later type. The cylinder head seals the top of the engine block, forming the combust...

Cylinder Head for the 300Tdi 2.5L 4-cylinder turbo diesel engine, supplied complete with valve guides and with the valves and valve springs assembl...

Cylinder Head for the 300 TDi 2.5L four-cylinder turbo diesel engine, supplied as a bare casting without valves. The head bolts to the top face of...

Front Camshaft Oil Seal for the Td5 2.5L 5-Cylinder Turbo Diesel engine, fitted at the timing end of the camshaft within the cylinder head. Seated...

Piston Assembly for the Td5 2.5L 5-Cylinder Turbo Diesel, part of the cranktrain within the cylinder block assembly. Oversize service piston, for u...

Piston and Pin Assembly - TD5

Piston Assembly for the Td5 2.5L 5-Cylinder Turbo Diesel, part of the cranktrain within the cylinder block assembly. Oversize: 0.020 in (approximat...

Piston Ring Set for the Td5 2.5L five-cylinder turbo diesel engine, standard size. Provides the compression and oil-control rings for one piston, ...

Camshaft for the Td5 2.5L 5-cylinder turbo diesel engine, running in the cylinder head as part of the valvetrain. Driven from the crankshaft by th...

Inlet Valve for the cylinder head valvetrain of the Rover V8 petrol engine (3.5L, 3.9L, 4.0L and 4.6L variants). It seats in the cylinder head inl...

Valve Guide for the cylinder head of the 2.5L 200 TDi and 300 TDi diesel engines. The valve guide is pressed into the cylinder head and locates th...

Valve Guide for the cylinder head valve train of the Rover V8 petrol engine. The guide is an interference fit in the cylinder head and locates the...

Timing Chain Tensioner for the Td5 2.5L 5-cylinder turbo diesel, part of the timing chain drive assembly at the front of the engine. The tensioner...

Tensioner - Timing Belt

Drive Belt Tensioner - 2.0L MPi

Idler Pulley guides and supports the timing belt on the 300 TDi 2.5L turbo diesel. Running on a sealed bearing, it routes the belt around the timi...

Valve Stem Cap is a hardened cap that sits over the tip of the valve stem in the cylinder head valve train. It forms the wear interface between th...

Exhaust Manifold for the Td5 2.5L five-cylinder turbo diesel engine. The cast manifold bolts to the exhaust ports on the cylinder head and collect...

Inlet Manifold Gasket for the V8 petrol engine, forming the seal between the central inlet manifold casting and the cylinder head intake faces. It...

Hose - Oil

Valv

Oil Filter for the Td5 2.5L five-cylinder turbo diesel. Part of the engine lubrication system. The filter is a replaceable cartridge element that ...

Oil Filler Cap for the engine oil filler neck. Seals the oil filler aperture in the valve cover, preventing oil vapour loss and contamination ingr...

Oil Dipstick for the 2.4L Duratorq-TDCi (Puma) diesel engine. It locates in the dipstick tube to allow the engine oil level in the sump to be check...

Flanged Nut - M6 captive nut, also described as a U-nut or speed clip, used to provide a threaded fixing point in sheet metal and moulded panels. ...

Front Indicator Bulb - PY21W amber signal bulb, 12V 21W, with a BAU15s offset-pin bayonet base. It fits the front direction indicator lamp. The am...

Reverse Lamp Bulb - a 21W 12V single-filament incandescent bulb (type P21W) with a BA15s single-contact bayonet cap, fitted to the rear lamp assemb...

Exhaust Gasket for the flanged joint between the exhaust front pipe and the catalyst section. It seals the bolted flange where the front pipe meet...

Copper Exhaust Nut for the exhaust system of the Defender 2007-2016 with the 2.4L TDCi Puma engine. Copper exhaust nuts are used on exhaust manifo...

Dowel Pin locates the flywheel on the crankshaft flange within the clutch and flywheel assembly. The dowel sets the angular position of the flywhe...

Seal Ring seals the fuel injection pump within the fuel injection system. The ring prevents fuel leakage at the injection pump. Fitted to the 2.4L...

Cylinder Head Bolt, M10 x 160mm clamps the cylinder head to the engine block. One of the head bolts that secures the cylinder head to the block de...

Cylinder Head Bolt, M10 x 160mm clamps the cylinder head to the engine block. One of the head bolts that secures the cylinder head to the block de...

Cylinder Head Bolt, M8 x 120mm clamps the cylinder head to the engine block. One of the smaller-diameter bolts in the cylinder head bolt pattern, ...

Glow Plug is an electric heating element that warms the combustion chamber to assist cold starting of the 2.4L Duratorq-TDCi (Puma) diesel engine. ...

Crankshaft Pulley Bolt - M12 x 80mm fastener that secures the crankshaft pulley (torsional vibration damper) to the front nose of the crankshaft on...

Front Cover Gasket for the 2.4L Duratorq TDCi (Puma) diesel engine, also used on the 2.2L Puma TDCi. It seals the joint between the engine front (t...

Hex Flange Bolt for the engine timing gear drive. This flanged hex-head bolt secures a timing gear within the front timing drive. The integral fla...