Products

7" round LED headlamp 12/24V black 78W LHD (pair)

7" round LED headlamp 12/24V chrome 78W LHD (pair)

7 inch high low beam headlight LHD black, with U shape parking light, (PAIR)

Portable Jump Starter and Air Compressor - a handheld 12V power pack combining a battery jump starter, power bank, tyre inflator and LED work light...

Crankshaft Spigot Bush is the clutch pilot bush that presses into the rear face of the crankshaft, between the engine and the clutch. It supports ...

Heater Valve - T-Piece for the engine cooling and heating circuit. Directs coolant flow through the heater circuit, providing controlled distribut...

Wiper Blade for the windscreen wash/wipe system, 25 cm in length and finished in black. The blade clips onto the wiper arm and carries the rubber ...

Wiper Blade for the windscreen wash/wipe system, 25 cm in length, of flat-blade construction. The blade attaches to the wiper arm and carries the ...

Wheel Wrench a 27mm wheel brace for loosening and tightening wheel nuts. The 27mm socket end matches the wheel nuts fitted to the applicable vehic...

Wheel Wrench a 27mm wheel brace for loosening and tightening wheel nuts. The 27mm socket end matches the wheel nuts fitted to the applicable vehic...

Locking Plate - the lower tailboard locking plate, mounted to the rear body. Fitted at the lower hinged tailboard, the plate provides the fixed en...

Joint - Ball

Ignition switch

Propshaft Bolt - a fastener that secures the propshaft universal-joint flange to the differential drive flange within the driveline. It clamps the...

Side lamp new type

Rear Stop/Tail Lamp - combined rear stop and tail lamp, supplied as a complete lens and body assembly. It mounts in the rear lamp position and pro...

Rear Fog Lamp for the rear lighting circuit, providing the high-intensity red rear light used to make the vehicle conspicuous from behind in poor v...

Rear Fog Lamp for the rear lighting circuit, providing the high-intensity red rear light used to make the vehicle conspicuous from behind in poor v...

Hardtop Support Bracket for the rear body, forming part of the upper fixings that secure the hardtop to the bodyshell. The bracket supports the si...

Anti-Rattle Rubber Strip fits the steering column top support. It sits between the column and its upper mounting, cushioning the shaft at the top ...

Seal

Lower Windscreen Seal for the Defender windscreen mounting assembly. This felt seal spans the full width of the lower windscreen channel, sealing ...

Door Seal for the rear end door, fitting along the lower floor edge of the side-hinged tailboard. It forms the sealing interface between the foot o...

Door Hinge for the rear end (load/tail) door, lower position. One of the pair of side-hinged door hinges that mount the rear door to the body aper...

Rear Sill Panel - Left-Hand is a lower-body repair panel for the rear sill section on the nearside (left-hand) of the body. It forms the outer clos...

Wheel Arch Kit is a four-piece set of moulded ABS plastic wheel arches. The kit comprises four wheel arch sections covering the front and rear arc...

Bulkhead Door Pillar for the right-hand (offside) front door aperture, in the basic configuration. The door pillar forms part of the bulkhead asse...

Rear Crossmember with 325mm Extensions for the military Lightweight (Air Portable) 88" chassis. The rear crossmember closes and braces the rear of...

T-Piece Hose Connector is a three-way junction fitting used in a flexible hose run. It joins three hose ends at a single point, allowing a hose li...

Rear Main Bearing Cap Seal for the Rover V8 petrol engine, sealing the joint between the rear main bearing cap and the cylinder block. This crucif...

Manifold Absolute Pressure (MAP) Sensor, part of the engine management system. The MAP sensor measures the absolute pressure inside the intake man...

Fuel filler breather hose

Lightweight Vent Seal

Rear Light Guard - Single - Natural is a steel mesh protective guard for a single rear lamp. It bolts over the rear lamp lens to shield it from im...

Rear Light Guard - Single - Black is a steel mesh protective guard for a single rear lamp. It bolts over the rear lamp lens to shield it from impa...

Fume Curtain – Khaki Canvas is a canvas curtain that hangs across the rear of a soft-top vehicle to reduce the volume of exhaust fumes drawn into t...

Mirror Arm within the external rear-view mirror assembly. This arm mounts at the door hinge position and extends outward to position the mirror he...

Spare Wheel Bonnet Buffer is a rubber buffer for the bonnet-mounted spare wheel carrier. It sits between the spare wheel and the bonnet, cushionin...

Door Checker Bracket Assembly - Rear - LH is the door check mechanism for the left-hand rear door. It links the door to the body pillar and limits...

Door Seal - Bottom for the left-hand front door, forming part of the door-aperture weather sealing. The seal fits along the lower edge of the door...

Mud Shield - Under Wing - RH for right-hand drive Series 2 and Series 3 Land Rovers (1968-1984). Fitted beneath the inner front wing on the right-...

Bulkhead Mudshield, right-hand - inner wing to bulkhead splash plate, right-hand drive applications. The mudshield closes the gap between the inne...

Mud Shield – RHD – LH is the left-hand mud shield for the pedal box. It fits over the pedal box aperture in the bulkhead to keep mud, water and ro...

Bulkhead Mudshield, left-hand - inner wing to bulkhead splash plate, right-hand drive applications. The mudshield closes the gap between the inner...