for Discounts / VAT
for Discounts & Correct VAT
Retaining Clip - 1/4 Turn is a quarter-turn fastener used throughout the front-end and bumper trim assemblies. The clip locates through an apertur...
View full detailsGlovebox Switch is the switch assembly fitted at the glovebox, within the instrument panel related parts. Operating the switch releases the gloveb...
View full detailsTransmission oil cooler for the automatic gearbox cooling circuit. Automatic transmission fluid is routed out of the gearbox, through the cooler co...
View full detailsRadiator Hose - Top for the 5.0L AJ133 V8 petrol engine, part of the cooling system pipes and hoses. The top hose carries hot coolant from the eng...
View full detailsAir Suspension Control Module is the electronic control unit of the air suspension system. It interprets the ride height sensor signals and the dr...
View full detailsSpark Plug Aperture Gasket seals the spark plug aperture in the cylinder head cover on the left hand cylinder bank. It closes the joint between th...
View full detailsInlet Manifold Air Duct is the moulded elbow that routes charge air into the inlet manifold on the 3.6 litre V8 32V DOHC Td8 diesel engine. It joi...
View full detailsExterior mirror motor - left-hand side glass adjustment motor within the door mirror head. The motor sits behind the mirror glass and drives the g...
View full detailsFuel Pump and Sender - in-tank fuel pump and level sender unit, mounted in the fuel tank as part of the fuel delivery assembly. The pump lifts fue...
View full detailsWiper Arm - front windscreen wiper arm for the passenger side on left-hand drive vehicles, part of the front wash/wipe system. The arm locates on ...
View full detailsFuel Injector Pressure Sensor - high-pressure fuel rail sensor in the direct-injection fuel supply circuit. It measures the fuel pressure in the i...
View full detailsFront Brake Caliper Attachment Kit supplying the pad-retaining and caliper attachment hardware that secures the brake pads in the front caliper bod...
View full detailsCoolant Hose forms part of the charge air cooler coolant circuit on the 5.0L supercharged V8 petrol engine (AJ133). This engine uses a water-coole...
View full detailsCoolant Hose - Engine to Radiator, Upper is part of the engine cooling system pipes and hoses. It forms the upper leg of the main coolant circuit,...
View full detailsBrake Tube for the rear hydraulic brake circuit. This rigid pipe forms the right-hand rear section of the circuit, routing hydraulic pressure to t...
View full detailsClip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.
Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...
View full detailsSupercharger Actuator Repair Kit for the 5.0L AJ133 supercharged V8 petrol engine. The actuator is mounted on the supercharger and controls the by...
View full detailsWater Outlet Tube for the engine cooling circuit of the naturally aspirated 5.0L AJ133 V8 petrol engine. The tube carries coolant between the wate...
View full detailsSuspension Arm Bush for the front upper suspension arm, part of the front suspension arm and anti-roll bar assembly. The shouldered bush is presse...
View full detailsVacuum Tube for the brake booster (servo) vacuum supply circuit, running between the engine vacuum source and the booster inlet port. The brake bo...
View full detailsBrake Disc Retaining Screw that locates the brake disc against the wheel hub flange, holding the disc square and in position while the caliper and ...
View full detailsO-Ring for the diesel fuel injection system. It forms a fuel-tight seal at the injector, within the fuel injectors and pipes assembly. Supplied as...
View full detailsOil Filter Housing Cover is the cover for the cartridge-type oil filter assembly on 3.0 GDI petrol and 5.0 AJ-V8 engines. This cover retains the r...
View full detailsBrake Pad Fitting Kit
Front Brake Caliper Spring - the anti-rattle retaining spring for the front brake caliper. The spring holds the brake pads located in the caliper,...
View full detailsBrake Pad Fitting Kit
Rear Brake Pad Fitting Kit - the retaining clip set for the rear brake pads. The kit supplies the clips that locate and retain the pads within the...
View full detailsAxle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...
View full detailsFitment: L322 RH LHD
Power Steering Hose Sealing Washer - seals the union between a power steering supply or return hose and its mating port in the steering hydraulic c...
View full detailsAir Suspension Compressor Delivery Valve Kit
Compressor Overhaul Kit - Hitachi
Air Suspension Ride Height Sensor - left-hand front height sensor within the electronic air suspension system. The sensor measures ride height at ...
View full detailsSensor - Air Suspension
Throttle Body for the air intake system of the 4.4L V8 diesel engine. The electronically actuated throttle valve regulates intake airflow into the...
View full detailsWheel Centre Cap for the road wheel, fitting into the centre bore of the rim to cover the hub. Finished in silver with a black logo. The cap conce...
View full detailsEngine Mount Bracket for the 5.0L V8 petrol engine (AJ133, naturally aspirated and supercharged), part of the engine mounting system. Bolts betwee...
View full detailsWater Pump for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. It circulates coolant through the engine block, cylinder heads and radiator to maintain...
View full detailsWater Outlet Connection (Upper) for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. Part of the thermostat and coolant housing assembly, it carries co...
View full detailsEGR Cooler Inlet Hose for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. It routes engine coolant to the exhaust gas recirculation (EGR) cooler, whic...
View full detailsEGR Cooler Outlet Hose for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. It returns engine coolant from the exhaust gas recirculation (EGR) cooler t...
View full detailsExhaust Manifold Gasket for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. It seals the joint between the exhaust crossover pipe and the exhaust mani...
View full detailsCoolant Hose forms part of the heater line within the engine cooling system, routing coolant between the engine and the heater matrix. Supplied co...
View full detailsTurbocharger Oil Return Tube Gasket seals the oil return (drain) tube where it meets the turbocharger, within the turbocharger lubrication circuit....
View full detailsOil Separator Reservoir forms part of the crankcase emission control (crankcase ventilation) system. It separates entrained engine oil from crankc...
View full detailsEGR Outlet Gasket for the exhaust gas recirculation (EGR) system on the 4.4L DOHC DITC V8 diesel engine. Seals the joint between the EGR valve out...
View full detailsEGR Inlet Gasket for the 4.4L DOHC V8 turbo-diesel engine, part of the exhaust gas recirculation (EGR) system. It forms the gas-tight joint where ...
View full details