Products

Turbocharger for the 2.0L AJ200 / AJ20D4 four-cylinder diesel engine. It sits in the forced-induction circuit between the exhaust manifold and the...

Coolant Temperature Sensor in the engine cooling circuit. This sensor monitors coolant temperature and transmits a signal to the engine management...

Rear Brake Pipe Clip retains and locates the rigid brake pipes along the rear of the chassis. It holds the brake lines securely against the chassi...

Bracket - Fender Mounting

Bolt - M8 x 50 - Torx is an M8 threaded fastener, 50 mm long, with a Torx drive head. It is used as a general-purpose fixing across a range of bod...

"Land Rover" Rear Decal Badge A self-adhesive lettered name plate forming part of the exterior rear badging, applied to the rear bodywork. The let...

Flanged Nyloc Nut, M10, a multi-purpose locking fastener used across the chassis and suspension. The nylon insert resists loosening under vibratio...

Hex Nut - M12 - a standard M12 hexagonal nut used as a general-purpose fastener across the vehicle. The six-sided form is tightened with a standar...

O-Ring and Grease Kit for servicing the transfer box input shaft. Contains the input shaft O-ring and the anti-seize grease used when resealing th...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Hex-Head Bolt and Washer - bolt and washer assembly used in the front suspension and subframe area. The fastener secures front cross member, stabi...

Anti-Roll Bar Bush for the suspension stabiliser system. This rubber insulator clamps the anti-roll bar to its mounting, locating the bar while all...

Sealing Ring - oil seal at the input of the AWF21 six-speed automatic transmission, sealing around the torque converter hub where it enters the tra...

Coolant Hose Assembly - heater outlet to thermostat housing hose in the engine cooling circuit. Returns coolant from the heater matrix outlet to t...

Coolant Hose from the EGR cooler to the heater inlet, part of the engine cooling and exhaust gas recirculation circuit. The EGR cooler is coolant-...

Exhaust Gasket for the flanged joint between the exhaust front pipe and the catalyst section. It seals the bolted flange where the front pipe meet...

Bolt for the adjustable rear suspension arm on the Freelander 2 and Range Rover Evoque. This M14 × 85mm special bolt secures the adjustable rear a...

Oil Filter - engine oil filter element for the 2.2L Td4 diesel engine, supplied with its sealing ring. The element fits inside the filter housing ...

Thermostat Housing - coolant outlet housing in the engine cooling circuit of the 2.2L Td4 diesel engine. The housing mounts to the engine and carr...

Fuel Filter for the diesel fuel supply system of the 2.2L DW12 common-rail direct-injection turbo diesel engine. It is fitted in the fuel line betw...

Fuel Filter - diesel fuel filter for the 2.2L Td4 engine, fitted in the low-pressure fuel supply circuit. The filter sits between the fuel tank an...

Air Conditioning O-Ring - a sealing ring for the air conditioning refrigerant circuit. It seals the joints between refrigerant lines and component...

Sealing Ring - the right-hand outer seal for the front axle case, part of the front driveline. It seals the point where the front driveshaft passe...

Brake Disc & Caliper Bolt - a fixing bolt for the brake disc and caliper assembly. It is used at both the front and rear brake disc and calipe...

Grommet - a moulded rubber grommet fitted into an aperture in the body. It lines and seals the opening, providing a finished edge and helping to k...

Washer Bottle Filler Cap - the filler cap for the windscreen washer fluid reservoir. It closes the reservoir filler neck, sealing the washer fluid...

Bolt and Washer is a hex-head bolt with washer for the cylinder block. Used at the cylinder block and its plugs on the 2.2L diesel engine.

Oil Level Plug is the threaded oil level indicator plug for the 6-speed AWF21 automatic gearbox. Removed to check and set the transmission fluid l...

Transmission Oil - Hypoid is a hypoid gear oil for the Power Transfer Unit (PTU) / transfer box. It lubricates the hypoid gearset that sends drive...

Oil Seal - Differential Flange - Front seals the front differential where the drive flange exits the axle case. It runs against the differential o...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Driveshaft Oil Seal - Inner - Front LH is fitted to the front axle case (final drive housing) and seals around the inner end of the left-hand front...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Fuel Tank Vent Reservoir for the evaporative emission control (EVAP) system on petrol models. It collects and stores fuel vapour drawn from the fue...

Cigar Lighter Base - the socket housing for the cigar lighter and 12V auxiliary power point. It mounts in the instrument panel or floor console and...

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...