Products

Cup Washer for securing the instrument panel to the engine cowl on the Defender 90 and 110. This pressed steel cup-type washer fits beneath the in...

Water-in-Fuel Sensor for the Td5 2.5L 5-cylinder turbo diesel fuel filter / sedimentor assembly. It threads into the base of the fuel filter housi...

Fuel Filter Water Sensor for the TD5 fuel filter assembly, fitted to the Discovery 2 TD5. This sensor is installed in the base of the fuel filter ...

Spring Washer for use as a locking fastener component across Land Rover assemblies. A helical split spring washer providing resistance against fas...

Spring Washer fitted under a nut or bolt head to resist loosening from vibration. An M8 split-ring (single-coil) spring washer. The sprung opening...

Spring Washer - M10 single-coil spring lock washer. Fitted beneath a nut or bolt head, the split single-coil section bears against the fastener to...

Spring Washer - single-coil spring lock washer, 12 mm. Fitted between the nut or bolt head and the mating face on M12 fastenings, including engine...

Spring Washer, 1/4" nominal size. A split helical washer fitted under a nut or bolt head as a fastening hardware component. The sprung split appli...

Spring Washer for use across a wide range of fixings and assembly applications on Land Rover vehicles. This split-ring spring washer is placed ben...

Spring Washer is a split spring lock washer fitted under a nut or bolt head to maintain clamping tension and resist loosening caused by vibration. ...

Plain Washer - flat steel washer from the hardware and fixings group. It is fitted under a bolt head or nut to spread the clamp load over the join...

Sender Tank Fuel 110/130

Inertia Switch in the fuel supply and engine electrical circuit. It cuts electrical power to the fuel pump on a sudden impact or severe deceleratio...

Wing Gasket Foam sealing gasket fitted along the top edge of the front wing. Seals the joint between the wing and the adjoining bodywork to keep o...

TF Wing Top Foam Gaskets - 07 On

Wing Top Protector Kit - chamfered protector panels for the front wing tops. The panels cover the wing top, the area most exposed to scuffing from...

Leak Detection Pump - DMTL (Diagnostic Module Tank Leakage) unit for the fuel tank evaporative emission (EVAP) system. The module sits between the...

Fuel Vapour Valve for the evaporative emission control (EVAP) system. The valve governs the flow of fuel vapour between the fuel tank and the char...

Fuel Burning Heater Pump Metering fuel pump for the auxiliary Fuel Burning Heater (FBH). The FBH is a supplementary diesel-fired heater that warms...

Exhaust Stud Nut for front exhaust system connections. This nut secures exhaust pipe sections to the manifold or downpipe studs, maintaining a gas...

Exhaust System Screw, M8 x 20 mm. Used on exhaust and turbocharger joints - securing the catalytic converter to its mating pipe section, and at tu...

Kit gasket carb for Rover V8 engines fitted with SU carburetors

Crankshaft Oil Pump Seal Front crankshaft oil seal located in the oil pump housing. Seals around the crankshaft snout where it passes through the ...

Crankshaft Oil Pump Seal Front crankshaft oil seal located in the oil pump housing. Seals around the crankshaft snout where it passes through the ...

Headlamp for the front exterior lighting assembly, supplied as a complete halogen unit. The headlamp provides manual beam levelling, allowing the ...

Headlamp LHD (NLA Wanneer Op) - Discovery 2 - RH

Headlamp assy LH

H1 Halogen Bulb - 55 W single-filament halogen capsule on the standard P14.5s base, used in the front fog lamp and in headlamp reflectors built aro...

Handbrake Disc - transmission-mounted brake disc, the rotating element of the disc-type transmission handbrake conversion. Mounts on the transfer ...

Lamp assy RH OEM

Rear Lamp for the rear exterior lighting assembly, mounted on the left-hand side of the vehicle. The unit combines the rear lighting functions in ...

Rear Lamp Assembly, right-hand side - part of the rear lighting cluster mounted to the rear body. This is the facelift-specification unit, fitted ...

Rear Valeo Lamp Assembly

Rear Lamp Assembly - Stop & Flasher - rear lamp cluster within the rear exterior lighting assembly group, combining the stop lamp and direction...

Rear Lamp Assembly - Right Hand - rear lamp cluster within the rear exterior lighting assembly group. The cluster mounts to the rear quarter panel...

Rear Lamp Assembly, left-hand side - the rear body-mounted light cluster. This is the non-NAS specification with the red lower lens. It carries th...

Number Plate Lamp - LED for the rear number plate lighting circuit. This LED lamp assembly is a direct replacement for the standard incandescent n...