Genuine Land Rover Parts

Drive Belt - ISG - V-belt in the front-end accessory drive of the 3.0L Ingenium six-cylinder petrol engine, driving the belt-integrated starter gen...

Camshaft Cover Gasket - moulded gasket sealing the camshaft cover to the cylinder head. It seals the valve train and cam carrier area against oil ...

Front Crankshaft Oil Seal - radial lip seal in the cylinder block and front cover assembly, sealing the crankshaft nose where it passes through the...

Coolant Bypass Tube - rigid coolant transfer tube in the engine cooling system, connecting the thermostat housing to the heater water circuit. It ...

Coolant Bleed Hose - small-bore hose in the engine cooling system, running from the cylinder head bleed point to the coolant expansion tank. It ve...

Transmission Oil Cooler - heat exchanger in the automatic transmission cooling circuit, mounted in the front cooling pack alongside the radiator an...

Cylinder Head Gasket sealing the cylinder head to the cylinder block. It contains combustion pressure at each bore and seals the coolant and oil g...

Timing Belt Pulley, Upper from the upper timing gear, right-hand side. It guides the timing belt around the upper drive components and maintains c...

Water Outlet Connection - coolant outlet component in the engine cooling circuit of the 3.0L DOHC GDI supercharged V6 petrol engine. It forms the ...

Compressed Air Hose - charge air duct in the intercooler circuit of the 3.0L V6 Gen2 turbo diesel engine. It carries cooled, pressurised charge ai...

Module - Transfer Shift Control

Front bumper mounting bracket, left-hand side, in the front bumper cover mounting assembly. The bracket carries the upper outer corner of the fron...

Front bumper mounting bracket, right-hand side, in the front bumper cover mounting assembly. The bracket carries the upper outer corner of the fro...

Stop light switch for the brake pedal box assembly. The switch mounts in the pedal box behind the brake pedal and is operated by the pedal arm as ...

Valve stem seal for the cylinder head valve train. The seal locates on the valve guide and wipes the valve stem as it reciprocates, metering the s...

Fender Mounting Bracket, Upper Right-Hand - front body structure, at the joint between the dash panel and the front fender (wing). The bracket for...

Coolant Hose for the engine cooling circuit on supercharged petrol engines. A moulded coolant line with pre-formed bends, so it seats along its in...

Stud for the exhaust manifold and turbocharger mounting joints. Locates and retains the manifold-to-cylinder-head and turbocharger-to-manifold joi...

Front Suspension Arm - upper front control arm for the left-hand side of the front suspension. It links the chassis to the top of the front wheel ...

Front Suspension Arm - upper front control arm for the right-hand side of the front suspension. It links the chassis to the top of the front wheel...

Cylinder Head Cover (Camshaft Cover) for the 5.0L V8 AJ133 petrol engine, naturally aspirated and supercharged applications. The cover bolts to th...

Camshaft Cover for the 5.0L V8 AJ133 supercharged petrol engine. It closes the top of the cylinder head, enclosing the overhead camshafts and valve...

Oil Cooler Gasket for the engine oil cooler and filter housing assembly on the 4.4L DOHC DITC V8 diesel. Seals the joint face between the oil filt...

Oil Filter Gasket from the oil cooler and filter housing assembly of the 4.4L DOHC DITC V8 diesel. The gasket seals the oil filter housing against...

Cooling Fan Motor in the engine cooling system, driving the radiator cooling fan. The motor spins the fan to draw air through the radiator, dissip...

Front Stabilizer Bar Insulator for the front anti-roll bar mounting. This bush locates the front anti-roll (stabilizer) bar to the vehicle structu...

Door Trim Panel for the front door. The trim panel finishes the inner face of the front door, covering the door structure and mechanisms and carry...

Camshaft Cover - cam cover sealing the top of the cylinder head over the camshafts and valvetrain, for the 3.0L DOHC supercharged GDI V6 petrol eng...

Dual-Tone Electric Horn producing a combined high and low note, part of the vehicle's audible warning system. Supplied with its mounting bracket.

Air Suspension Compressor The pump that generates and supplies compressed air to the four-corner electronic air suspension system. Driven by an el...

Door Latch Actuator for a rear door, part of the central locking system. The unit combines the door latch with the electric actuator that locks an...

Door Latch Actuator for a front door, part of the central locking system. The unit combines the door latch with the electric actuator that locks a...

Towing Hook Cover is the blanking cover that closes the towing eye aperture in the rear bumper fascia. When the screw-in recovery hook is not fitt...

Front Cylinder Cover - a cover that closes off the front face of the cylinder block, sealing the opening and enclosing the components behind it. F...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Thermostat Housing for the engine cooling circuit. It houses the coolant thermostat and directs coolant flow, opening the path to the radiator once...

Idler Pulley for the front-end accessory belt drive, 90mm diameter. The idler routes and guides the auxiliary drive belt around the accessory pull...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Wiper Blade for the windscreen wiper assembly. The blade fits onto the wiper arm and sweeps the windscreen to clear rain and road spray, maintaini...

Hex Flange Nut, an M8 flanged nut used to secure the exhaust manifold and turbocharger fixings on V6 and V8 diesel engines. The integrated flange ...

Oil Pump Gasket that seals the oil pump to the cylinder block within the engine lubrication system, for the 3.0L V6 diesel engine. It maintains th...

Engine Mounting Bracket - a structural bracket within the engine mounting system. The bracket bolts to the engine and locates the engine mount, ca...

Thermostat Seal for the thermostat housing on AJ200/AJ20 series petrol and diesel engines. It seals the thermostat housing joint within the cooling...