Price <10

Washer for the bonnet insulation pad. This washer retains the sound- and heat-insulation pad against the underside of the bonnet, holding the pad ...

Wiring Clip for securing and routing electrical harnesses in Land Rover vehicles.

Thrust Washer for the reverse idler gear in the LT95 four-speed gearbox. It bears against the reverse idler gear on its shaft, setting the gear's ...

Blanking Plug for sealing an unused panel aperture. This 20.5mm plastic plug closes off an open hole in the body or chassis panelwork, keeping out...

Blanking Plug used to close an unused aperture in body and trim panels. Seals openings such as seat base fitting holes and redundant grommet posit...

Dynamo Bush for the Lucas C39 and C40 dynamos as fitted to pre-alternator Land Rover variants. This bush supports the armature shaft at the commuta...

Copper Washer for use in the cooling system water pump assembly. This sealing washer provides a coolant-tight seal at water pump connections and b...

Spring lock

Screw - M4 x 16mm metric machine screw used as a general fixing. A multi-application fastener rather than a component-specific part; the same scre...

Spring Washer - Side Repeater Lamp A spring washer used at the side repeater lamp mounting. Fitted beneath the securing nut or screw, it maintains...

Plain Washer, an M6 flat washer. It fits under the head of an M6 bolt or nut to spread the clamping load over a wider bearing area and protect the...

Blanking Plug used to close off an unused aperture in the body or panel work, part of the grommets and blanking group. It seals a redundant or opt...

Snap Ring - a retaining ring for the rear suspension top link ball joint. The snap ring seats in a groove to secure the ball joint within the top ...