Products

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

Transfer Case Support bracket that carries the intermediate bearing of the front axle drive shaft where the shaft runs from the transfer case. It ...

Front Axle Drive Shaft Bracket that carries the intermediate bearing of the front axle drive shaft where the shaft runs from the transfer case. It...

Injector Refit Kit supplying the seals needed to refit a fuel injector on petrol engines. It restores the sealing interface between the injector an...

Thermostat Seal for the thermostat housing on AJ200/AJ20 series petrol and diesel engines. It seals the thermostat housing joint within the cooling...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Front Cylinder Cover - a cover that closes off the front face of the cylinder block, sealing the opening and enclosing the components behind it. F...

DEF (AdBlue) Filler Hose for the diesel exhaust fluid system on the 2.0L Ingenium AJ200 diesel engine. The hose connects the DEF filler neck to th...

Brake Hose for the right-hand rear brake hydraulic circuit. This flexible hose delivers hydraulic pressure from the rigid brake line to the right-...

Brake Hose for the left-hand rear brake hydraulic circuit. This flexible hose delivers hydraulic pressure from the rigid brake line to the left-ha...

Combined Oil and Vacuum Pump for the 2.0L Ingenium (AJ200) diesel engine. This tandem unit houses the engine oil pump and the vacuum pump in a sing...

Timing Chain Tensioner Guide for the 2.0L 16V TIVCT petrol engine (Si4). The tensioner guide is the pivoting guide arm that the timing chain tensi...

Exhaust Clamp for the 2.0L Ingenium diesel exhaust system (AJ200D / AJ20D4). The clamp secures the front section joint of the exhaust, holding the...

Fuel Filter for the 2.0L Ingenium diesel engine (AJ200D / AJ20D4 / AJ21D4). The filter removes contaminants and water from the diesel fuel supply ...

Clip for exterior body trim and accessory fittings. The clip retains body mouldings, side steps, mudflaps and related exterior trim to the body, p...

Crankshaft Pulley with integral torsional vibration damper, mounted on the crankshaft nose of the 2.0L Ingenium AJ200 four-cylinder petrol and dies...

Tensioner Pulley for the auxiliary (accessory) belt drive on 2.0L AJ200 / AJ20 Ingenium petrol and diesel applications. The spring-loaded tensione...

Coolant Expansion Tank - the header and overflow reservoir of the engine cooling circuit, mounted alongside the radiator. The tank absorbs the vol...

Coolant Bypass Tube - a rigid coolant transfer pipe in the cooling circuit of the 2.0L AJ20P4 four-cylinder petrol engine. The tube carries coolan...

Glow Plug - cold-start pre-heating system of the 2.0L Ingenium AJ200 four-cylinder turbo diesel engine. Threads into the cylinder head, one per cy...

Valve stem seal for the cylinder head valve train. The seal locates on the valve guide and wipes the valve stem as it reciprocates, metering the s...

Exhaust Gas Pressure Sensor for the diesel exhaust aftertreatment system. The sensor is connected by take-off pipes to the exhaust upstream and do...

Module - Transfer Shift Control

Kit - Gear Shift Trigger

Door Handle Gasket - sealing gasket for the exterior door handle and lock assembly, part of the door closures group. It sits between the handle es...

Front Brake Sensor Wiring Bracket - mounting bracket for the brake pad wear sensor lead at the front disc brake and caliper assembly. The bracket ...

NOx Trap Temperature Sensor for the exhaust aftertreatment system, mounted in the exhaust stream at the NOx trap. The sensor measures exhaust gas ...

Timing Chain Guide, Lower Primary from the front timing gear assembly. It bears against the primary drive chain on the run between the crankshaft ...

Timing Gear Special Nut from the front timing gear assembly, securing the lower primary timing chain guide. The nut locates and clamps the guide a...

Front Shock Absorber Insulator from the front suspension strut assembly. It sits at the spring seat between the coil spring and the strut, isolati...

Front Crankshaft Oil Seal - radial lip seal in the cylinder block and front cover assembly, sealing the crankshaft nose where it passes through the...

Rear Crankshaft Oil Seal - the main oil seal at the flywheel end of the crankshaft, part of the crankshaft sealing arrangement on the Ingenium engi...

Front Wheel Arch Moulding for the right-hand side, part of the exterior body cladding assembly. The moulding follows the flange of the front wing ...

Front Wheel Arch Moulding for the left-hand side, part of the exterior body cladding assembly. The moulding follows the flange of the front wing w...

Tensioner - Timing Belt

Output Shaft Oil Seal for the ZF 9HP 9-speed automatic transmission (9HP48 / 9HP50). The seal is fitted in the transmission housing around the out...

Transmission Sleeve Kit

Iridium Spark Plug for the 2.0L 16V TIVCT turbocharged petrol engine (Si4, 240PS). The plug threads into the cylinder head and fires beneath its c...

Drive Chain Idler - timing gear idler sprocket for the 2.0L four-cylinder Ingenium engine family (AJ200 / AJ20 series, petrol and diesel). The idl...

Arm - Timing Chain Tensioner