Products

Rear Wheel Cylinder for the rear drum brake assembly, left-hand side. Mounted to the brake backplate, the wheel cylinder converts hydraulic pressu...

Wheel Cylinder Repair Kit - Rear - a seal kit for reconditioning the rear wheel brake cylinder, part of the rear drum brake hydraulic circuit. The ...

See fitting instructions: https://www.scribd.com/doc/208898844/Fitting-Instructions-for-RTC3176-Adjuster-Shoes-Drum-brake-LAnd-Rover-Series

Oil Filter for the engine lubrication system, suited to the 2.0L and 2.6L IOE (inlet-over-exhaust) petrol engines. The filter traps metallic parti...

Oil Filter for the engine lubrication system of the 2.25L four-cylinder petrol and diesel engine. The filter traps combustion by-products, metal p...

Oil Filter (Large) for the engine lubrication system, the large-canister filter fitted to the 4-cylinder petrol and diesel engines. The filter rem...

Oil Filter for the engine lubrication system of the early V8 petrol engine. The filter removes metallic particles, carbon and other contaminants f...

Distributor Base Plate - the base plate assembly inside the V8 distributor, carrying the magnetic pick-up for the electronic ignition. The pick-up ...

Vacuum unit V-8

Upper Ball Bearing for the steering column assembly. The bearing locates the upper end of the steering shaft within the column, allowing the shaft...

Hazard Flasher Relay - the switching relay in the hazard warning circuit. When the hazard switch is operated, the flasher relay pulses all four di...

Dynamo Brush Set for the Lucas C40 dynamo. The carbon brushes bear against the commutator to conduct current through the rotating armature windings...

Contact Set for the Lucas 25D distributor in the ignition system of the 2.25L and 2.6L petrol engines. The contact set (breaker points) opens and ...

Distributor Cap for the Lucas distributor fitted to the four-cylinder petrol engine, part of the ignition system. The cap seats over the distribut...

Alternator Brush Set replaces the carbon brushes in an ACR-type alternator, within the charging system. The brushes bear on the rotor slip rings a...

Universal Joint is a cross-type (spider) joint fitted within the propshaft assembly, transmitting rotational drive between opposing yokes while acc...

Bottom Overhaul Gasket Set - 3.5L V8

Exhaust manifold gasket set 2.6

Decoke Gasket Set - the set of gaskets used when decarbonising (decoking) the cylinder head on the 2.6L 6-cylinder IOE engine. A decoke involves re...

Gasket Set - Cylinder Block - V8

Universal Joint for the propeller shaft, of the 82mm cap-to-cap type. The universal (cardan) joint connects two sections of the propshaft, transmi...

Brake Hose - the flexible hydraulic line in the braking system. It carries pressurised brake fluid from the rigid chassis-mounted brake pipe to the...

caliper front RH early Defender 90 upto ca. 1986. - Upto axle number 22L09654 (RHS) - and upto 23L05987 (LHS). - Also from axle number 22L10192 ...

caliper front LH early Defender 90 upto ca. 1986. - Upto axle number 22L09654 (RHS) - and upto 23L05987 (LHS). - Also from axle number 22L10192 ...

Brake Hose - the flexible hydraulic line in the braking system. It carries pressurised brake fluid from the rigid chassis- or axle-mounted brake pi...

Brake Master Cylinder Repair Kit - Non-ABS

Hub Bearing – inner taper roller bearing for the front and rear wheel hubs. The bearing sits inside the hub and runs on the stub axle, carrying th...

Hub Bearing - the outer taper roller bearing that supports the wheel hub on the stub axle. Each wheel hub runs on a pair of opposed taper roller b...

Universal Joint for the propeller shaft assembly, transmitting rotational torque between adjoining shaft sections while permitting the angular move...

Ignition Condenser for the distributor in the ignition primary circuit. The condenser is a capacitor connected across the contact breaker points i...

Condenser for the distributor ignition system. The condenser (capacitor) is wired across the contact breaker points inside the distributor. As the...

Air Filter Element for the engine air intake system, housed within the air cleaner assembly. It traps airborne dust and abrasive debris from the in...

Speedo cable assy SII

Speedometer Cable for Land Rover models fitted with the 2.6-litre 6-cylinder petrol engine. Transmits rotational drive from the gearbox output shaf...

Hub Oil Seal for the front axle, sealing the front hub and drive shaft assembly to retain hub lubricant and exclude water, dirt and grit from the w...

Oil Seal installed within the wheel hub assembly to retain lubricant and prevent contamination ingress at the hub-to-stub-axle interface. The seal...

Oil Seal - a radial oil seal fitted between the wheel hub and stub axle within the wheel hub and drive shaft assembly. The seal retains lubricant ...

Oil Seal - a felt seal for the outer end of the drive shaft hub. It sits at the outer hub-to-drive-shaft interface, wiping the shaft and excluding ...

Oil Seal for the swivel pin housing on the front axle, sealing against the polished surface of the swivel ball. The seal seats in the rear face of...

KIT - WHEEL BEARING

Wheel Bearing Kit - Metric - Per Wheel

Spark Plug - ignites the air/fuel mixture in the combustion chamber of the petrol engine. It threads into the cylinder head with its electrode gap ...

Radiator Cap seals the radiator filler neck and maintains the engine cooling circuit at its rated pressure. Rated at 9 lb (0.62 bar), the spring-l...

Rotor Arm for the Lucas distributor in the ignition system of the 2.0L and 2.25L 4-cylinder petrol engines (up to engine suffix C). Driven by the ...

Rotor Arm for the Lucas distributor in the ignition system. Mounted on the distributor shaft beneath the cap, it routes the high-tension spark fro...

Rear Wheel Cylinder (Right-Hand) is the hydraulic actuator within the rear drum brake assembly, mounted to the brake backplate. Under pedal pressu...

Rear Wheel Cylinder (Left-Hand) is the hydraulic actuator within the rear drum brake assembly, mounted to the brake backplate. Under pedal pressur...

Capless Wedge Bulb, 12V 1.2W, for instrument, facia, clock and cigar-lighter illumination. The glass wedge base pushes directly into the panel hol...