Products

Door Latch Actuator for a rear door, part of the central locking system. The unit combines the door latch with the electric actuator that locks an...

Air Suspension Compressor The pump that generates and supplies compressed air to the four-corner electronic air suspension system. Driven by an el...

Dual-Tone Electric Horn producing a combined high and low note, part of the vehicle's audible warning system. Supplied with its mounting bracket.

Camshaft Cover - cam cover sealing the top of the cylinder head over the camshafts and valvetrain, for the 3.0L DOHC supercharged GDI V6 petrol eng...

Brake Hose for the right-hand rear brake hydraulic circuit. This flexible hose delivers hydraulic pressure from the rigid brake line to the right-...

Brake Hose for the left-hand rear brake hydraulic circuit. This flexible hose delivers hydraulic pressure from the rigid brake line to the left-ha...

Door Trim Panel for the front door. The trim panel finishes the inner face of the front door, covering the door structure and mechanisms and carry...

Combined Oil and Vacuum Pump for the 2.0L Ingenium (AJ200) diesel engine. This tandem unit houses the engine oil pump and the vacuum pump in a sing...

Front Stabilizer Bar Insulator for the front anti-roll bar mounting. This bush locates the front anti-roll (stabilizer) bar to the vehicle structu...

Dirty Air Duct Guide for the engine air intake system. The guide locates and supports the dirty air duct, the unfiltered-air inlet duct that carri...

Timing Chain Tensioner Guide for the 2.0L 16V TIVCT petrol engine (Si4). The tensioner guide is the pivoting guide arm that the timing chain tensi...

Exhaust Clamp for the 2.0L Ingenium diesel exhaust system (AJ200D / AJ20D4). The clamp secures the front section joint of the exhaust, holding the...

Fuel Filter for the 2.0L Ingenium diesel engine (AJ200D / AJ20D4 / AJ21D4). The filter removes contaminants and water from the diesel fuel supply ...

Clip for exterior body trim and accessory fittings. The clip retains body mouldings, side steps, mudflaps and related exterior trim to the body, p...

Exhaust Gas Pressure Sensor for the 2.0L AJ200D Ingenium four-cylinder diesel, working within the turbocharger and exhaust gas management circuit. ...

Cooling Fan Motor in the engine cooling system, driving the radiator cooling fan. The motor spins the fan to draw air through the radiator, dissip...

Cooling Fan Motor

Oil Filter Gasket from the oil cooler and filter housing assembly of the 4.4L DOHC DITC V8 diesel. The gasket seals the oil filter housing against...

Oil Cooler Gasket for the engine oil cooler and filter housing assembly on the 4.4L DOHC DITC V8 diesel. Seals the joint face between the oil filt...

Oil Cooler Assembly is the combined engine oil cooler and filter assembly within the engine lubrication and cooling circuit. It passes hot engine ...

Camshaft Cover for the 5.0L V8 AJ133 supercharged petrol engine. It closes the top of the cylinder head, enclosing the overhead camshafts and valve...

Cylinder Head Cover (Camshaft Cover) for the 5.0L V8 AJ133 petrol engine, naturally aspirated and supercharged applications. The cover bolts to th...

Front Suspension Arm - upper front control arm for the right-hand side of the front suspension. It links the chassis to the top of the front wheel...

Front Suspension Arm - upper front control arm for the left-hand side of the front suspension. It links the chassis to the top of the front wheel ...

Grille - Dirty Air Duct for the engine air intake and filtration assembly. Fits over the mouth of the dirty air duct on the front fender support, ...

Stud for the exhaust manifold and turbocharger mounting joints. Locates and retains the manifold-to-cylinder-head and turbocharger-to-manifold joi...

Crankshaft Pulley with integral torsional vibration damper, mounted on the crankshaft nose of the 2.0L Ingenium AJ200 four-cylinder petrol and dies...

Tensioner Pulley for the auxiliary (accessory) belt drive on 2.0L AJ200 / AJ20 Ingenium petrol and diesel applications. The spring-loaded tensione...

Front Wiper Blade - Driver's Side is the driver's side blade of the front windscreen wiper system in left-hand drive configuration. It is the long...

Front Wiper Blade for the windscreen wiper system, mounting to the wiper arm on the passenger side of left-hand drive vehicles. The blade carries ...

Coolant Hose for the engine cooling circuit on supercharged petrol engines. A moulded coolant line with pre-formed bends, so it seats along its in...

Coolant Expansion Tank - the header and overflow reservoir of the engine cooling circuit, mounted alongside the radiator. The tank absorbs the vol...

Coolant Bypass Tube - a rigid coolant transfer pipe in the cooling circuit of the 2.0L AJ20P4 four-cylinder petrol engine. The tube carries coolan...

Glow Plug - cold-start pre-heating system of the 2.0L Ingenium AJ200 four-cylinder turbo diesel engine. Threads into the cylinder head, one per cy...

Rear Lamp, Stop and Flasher - rear lighting cluster section carrying the brake (stop) lamp and rear direction indicator functions. Mounts to the r...

Fender Mounting Bracket, Upper Right-Hand - front body structure, at the joint between the dash panel and the front fender (wing). The bracket for...

Primary Fuel Filter - diesel fuel supply circuit, mounted in-line in the fuel lines between the tank and the engine. As the first filtration stage...

Valve stem seal for the cylinder head valve train. The seal locates on the valve guide and wipes the valve stem as it reciprocates, metering the s...

Stop light switch for the brake pedal box assembly. The switch mounts in the pedal box behind the brake pedal and is operated by the pedal arm as ...