Products

Cooling Fan for the front-end cooling pack on vehicles built with factory air conditioning. The fan draws air through the condenser and radiator a...

O-Ring for the air conditioning refrigerant circuit, used at the pipe and hose unions through the system including the condenser and evaporator con...

Rear Screen Wiper Motor drives the tailgate wiper of the rear wash-wipe system. The motor and its integral gearbox convert electrical drive into t...

Oil Filter Housing Gasket seals the oil filter housing cover within the engine oil filtration assembly. It forms the joint between the filter hous...

Pedestal Rocker

Adjuster

Sealing Washer fitted at the engine front cover. Provides a leak-tight seal at a fastener or fitting on the front cover assembly.

Drive Belt for the accessory belt drive, a poly-V (multi-ribbed) belt that transmits drive from the crankshaft pulley to the air conditioning compr...

Locking Wheel Nut for replacing one standard wheel nut per wheel as a theft deterrent. The locking wheel nut features a unique external drive prof...

Locking Wheel Nut Key – Code A. Removal key for code-A locking wheel nuts. The key code is stamped on the original key and cannot be derived from t...

Key Wheel Nut

Locking Wheel Nut Key - Code F for removing locking wheel nuts with the Code F drive profile, fitted to alloy wheels across the Defender, Discovery...

Swivel Housing Grease for the front axle swivel assembly, supplied as a single pre-measured one-shot sachet. The sachet delivers the correct charg...

Rear Left Air Suspension Height Sensor for the Electronic Air Suspension (EAS) system. The EAS control unit uses signals from the four ride height...

Sprocket Timing

Exhaust Manifold Gasket sealing the exhaust manifold flange to the cylinder head exhaust ports. It forms the gas-tight joint between the manifold ...

Electric Door Mirror Assembly for the right-hand front door, part of the exterior mirror and door trim assembly. The mirror head is adjusted elect...

Rear View Mirror

Sunroof Seal

Heater Pipe Kit - Air Con

Air Conditioning Condenser - heat exchanger in the air conditioning refrigerant circuit, mounted ahead of the engine cooling radiator in the front ...

Inlet Manifold O-Ring for the 2.5L 6-cylinder BMW diesel engine (M51). This O-ring seals the joint at the inlet manifold, preventing air ingress t...

Engine Mounting Bracket - 3.5L V8

Tow Loop Cover for the front bumper, a trim cover plate that closes off the towing eye aperture. It fits into the opening in the front bumper that...

Hub Bearing - Taper Roller - Front & Rear is a taper roller wheel bearing for the front or rear hub assembly. Each bearing is made up of a tap...

Fastening Clip for the front towing eye cover. This plastic screw clip retains the blanking cover that conceals the front towing eye (recovery poi...

Coolant Pipe O-Ring for the Td4 2.0L M47 four-cylinder diesel engine cooling circuit. This O-ring seals the coolant pipe connection at the coolant...

Loadspace Mat is a fitted rubber mat for the rear loadspace floor. It protects the loadspace floor surface from wear, dirt and moisture and provid...

Cooling Fan Nut for the V8 petrol engine. The nut secures the viscous fan coupling to the water pump drive spindle, retaining the engine cooling f...

Window Clip is a glass retaining clip for the door drop glass. It locates at the base of the sliding window glass in the front and middle doors, s...

Master Cylinder

Tow Ball Adaptor for the vehicle's towing equipment. Provides the ball-towing attachment interface, adapting the towbar mounting to accept a tow b...

Spare Wheel Cover for Discovery 1 and Discovery 2, sized to fit a 255mm-wide tyre on a 16- or 18-inch wheel. The cover has a rigid backing panel a...

Protector Lamp

Fitment: Freelander 1