Genuine Land Rover Parts

Fuel Filter - diesel fuel filter for the 2.2L Td4 engine, fitted in the low-pressure fuel supply circuit. The filter sits between the fuel tank an...

Thermostat Housing - coolant outlet housing in the engine cooling circuit of the 2.2L Td4 diesel engine. The housing mounts to the engine and carr...

Oil Filter - engine oil filter element for the 2.2L Td4 diesel engine, supplied with its sealing ring. The element fits inside the filter housing ...

Exhaust Gasket for the flanged joint between the exhaust front pipe and the catalyst section. It seals the bolted flange where the front pipe meet...

Coolant Hose from the EGR cooler to the heater inlet, part of the engine cooling and exhaust gas recirculation circuit. The EGR cooler is coolant-...

Coolant Hose Assembly - heater outlet to thermostat housing hose in the engine cooling circuit. Returns coolant from the heater matrix outlet to t...

Air Cleaner Housing Insulator locates and cushions the air cleaner (air box) assembly on its mounting. The rubber insulator secures the air cleane...

Indicator Bulb - PY21W amber signal bulb, 12V 21W, fitted to the direction indicator lamp units. The amber envelope provides the signal colour req...

Anti-Roll Bar Bush for the suspension stabiliser system. This rubber insulator clamps the anti-roll bar to its mounting, locating the bar while all...

Hex-Head Bolt and Washer - bolt and washer assembly used in the front suspension and subframe area. The fastener secures front cross member, stabi...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Hex Nut - M12 - a standard M12 hexagonal nut used as a general-purpose fastener across the vehicle. The six-sided form is tightened with a standar...

Flanged Nyloc Nut, M10, a multi-purpose locking fastener used across the chassis and suspension. The nylon insert resists loosening under vibratio...

Rear Brake Pipe Clip retains and locates the rigid brake pipes along the rear of the chassis. It holds the brake lines securely against the chassi...

Plastic Drive Rivet - Wheel Arch Trim secures exterior trim panels to the body as part of the wheel arch trim fixing set. This one-piece expanding...

Electronic Exhaust Valve Actuator for the sports exhaust system, fitted to 2.0L AJ200 and AJ20P4 petrol engines. The actuator drives the exhaust b...

NOx Trap Temperature Sensor is an exhaust gas temperature sensor within the diesel exhaust aftertreatment system, mounted in the exhaust stream at ...

Hub Nut - M24 x 2.0 for wheel hub and bearing retention. This M24 x 2.0 metric hub nut secures the wheel hub or halfshaft flange onto the stub axl...

Transfer Case Support bracket that carries the intermediate bearing of the front axle drive shaft where the shaft runs from the transfer case. It ...

Bearing Holder - front bearing housing within the Front Axle Drive Shaft assembly. The holder carries and retains the front support bearing of the...

Front Axle Drive Shaft transmits torque from the front differential output to the front wheel hub, forming part of the front driveline assembly. T...

Fuel Filter for the 2.0L Ingenium diesel engine (AJ200D / AJ20D4 / AJ21D4). The filter removes contaminants and water from the diesel fuel supply ...

Relay Black 2A 4 Pin

Glow Plug is a heating element threaded into the cylinder head of the 2.2L CR DI diesel engine, forming part of the pre-heating system. One plug s...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Halogen Headlamp Bulb of the H11 type, used in the dipped (low) beam of the front headlamp assembly. The H11 is a single-filament halogen bulb tha...

O-Ring and Grease Kit for servicing the transfer box input shaft. Contains the input shaft O-ring and the anti-seize grease used when resealing th...