Products

Front ABS wheel speed sensor, part of the four-wheel anti-lock braking system's sensing circuit. Catalogued under a sensor kit part number; the ass...

Intake Air Valve Assembly is the rubber dust valve fitted to the base of the air cleaner housing in the engine air intake system. This one-way fla...

Starter Motor Drive Assembly is the pinion drive of the starter motor, used on V8 petrol engines fitted with the Bosch starter. When the starter i...

Camshaft Bearing Set for the Rover V8 petrol engine. This set provides the bearing surfaces on which the camshaft journals run within the cylinder...

Anti-Burst Lock - right-hand tailgate latch assembly. The anti-burst design captures the striker pin within a rotating claw, holding the door close...

Headlamp Bezel Clamp from the front headlamp mounting assembly. The clamp secures the headlamp bezel to the lamp mounting panel, retaining the lig...

O-Ring for the air conditioning refrigerant circuit, used at the pipe and hose unions through the system including the condenser and evaporator con...

Sealing Washer fitted at the engine front cover. Provides a leak-tight seal at a fastener or fitting on the front cover assembly.

Locking Wheel Nut for replacing one standard wheel nut per wheel as a theft deterrent. The locking wheel nut features a unique external drive prof...

Locking Wheel Nut Key – Code A. Removal key for code-A locking wheel nuts. The key code is stamped on the original key and cannot be derived from t...

Key Wheel Nut

Locking Wheel Nut Key - Code F for removing locking wheel nuts with the Code F drive profile, fitted to alloy wheels across the Defender, Discovery...

Swivel Housing Grease for the front axle swivel assembly, supplied as a single pre-measured one-shot sachet. The sachet delivers the correct charg...

Sunroof Seal

Air Conditioning Condenser - heat exchanger in the air conditioning refrigerant circuit, mounted ahead of the engine cooling radiator in the front ...

Engine Mounting Bracket - 3.5L V8

Hub Bearing - Taper Roller - Front & Rear is a taper roller wheel bearing for the front or rear hub assembly. Each bearing is made up of a tap...

Loadspace Mat is a fitted rubber mat for the rear loadspace floor. It protects the loadspace floor surface from wear, dirt and moisture and provid...

Window Clip is a glass retaining clip for the door drop glass. It locates at the base of the sliding window glass in the front and middle doors, s...

Master Cylinder

Protector Lamp

Cylinder Head Kit

Radius Arm Bush is the compliant mounting bush at the radius arm pivot in the front suspension. The radius arm locates the front axle fore-and-aft...

Folding Side Step mounts beneath the side door sill to provide a sprung step that aids entry and exit, folding up against the body when not in use ...

Cover - Spare Wheel

Waterproof seat cover for a single outer front seat, finished in grey. The cover is shaped to the standard seat frame and fits over the existing u...

Lamp

Spare Wheel Cover - a padded vinyl cover that fits over an externally mounted spare wheel to protect the wheel and tyre from weather and dirt. Size...

Hazard Switch Bulb Illumination bulb for the hazard warning switch within the facia switch assembly. It provides the internal lighting that illumi...

These locking wheel nuts are suitable for all alloy wheels that use original Land Rover alloy wheel nuts. Set of 5 locking wheel nuts and 1 key.

Locking Wheel Nut Kit for alloy road wheels, part of the road wheel and fixings assembly. Each locking nut replaces a standard wheel nut at one pos...

Heater To Bulkhead Seal seals the joint between the heater and blower duct and the bulkhead aperture, within the heating and ventilation assembly. ...

Wastegate Actuator Pneumatic actuator that regulates turbocharger boost pressure on the 2.5L 200TDi turbo diesel engine. Mounted on the turbocharg...

Sunroof Handle Assembly operates the manually-operated glass sunroof, forming the interface between the occupant and the roof panel's opening mecha...

Wiper Drum Adaptor - splined adaptor used in the windscreen wiper system to connect the wiper arm to the splined wiper spindle. The adaptor seats ...

Clutch Damper for the Defender Puma hydraulic clutch circuit. This in-line hydraulic damper installs within the clutch hydraulic hose run between ...

upper Tube clutch pipe GENUINE LR - LHD Defender TD5/PUMA